Two pure elements, ? = 10 ohms  ? =100micro F , in a parallel connection have an applied voltage ? =150cos (5000t-30°). Find the total current.

Q: 2. A full wave rectifier is using a center tapped step down transformer. The input to the primary of...

A:

Q: EX :(9):- Consider a noiseless channel with a bandwidth of 3000 Hz transmitting a signal with two si...

A: a. The  maximum bit rate is the Nyquist bit rate and is given by the expression as shown below:  Bit...

Q: Problem 2: Y-A three-phase and Z= 4/245º N. Given the line impedances Zi = 3 + j4 N, A balanced acb ...

A: In this question,  We need to determine the line current and total power absorb by the load.  We kno...

Q: Determine the voltages at the nodes iz 2 1 3 3 A 2ix ww

A:

Q: Questions:- 1. How voltage is built up in D.C. shunt generator?

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please su...

Q: R4 3 22k2 2 R1 R2 4.7k2 6.8k2 R3 R5 1 4 10k2 33k2 V1 V2 10V 15V

A: The solution is given below

Q: DETERMINE THE VALUE OF V AND THE POWER DENT S OURCE SUPPLIED. BY THE INDEPEN- しy V. 24 mA

A:

Q: What type of voltage is generally used to control an analog switch?

A: The analog switch is the relay that are used to isolate the devices by on or off operations.

Q: f(1) A 10 2 4 6 t A. Express f(t) in terms of the step function. Simplify your expression. B. Solve ...

A: In this question,  We need to expression of the given signal in the form of unity step.  And also fi...

Q: PIProf 2 TT 2. 30 Pdp dø 49.7V %3D

A: Types of coordinated system to analyze the electrical and magnetic field  Rectangular coordinate Cy...

Q: A certain battery with potential difference of 2 Volts can deliver 10 Joules of energy, determine th...

A: Voltage is defined as  The work done per unit charge So use the definition V = W/q volts Units of wo...

Q: 1. Determine the output voltage for the circuit for each input voltage in (b). (c), and (d). The cir...

A:

Q: * In causal systems: O a. There is no input till the output is applied to the system. b. Non of the ...

A:

Q: At a location in Europe, it is necessary to supply 300 kW of 60-Hz power. The only power sources ava...

A:

Q: Question 1: 9A HAla Given a system with an input-output relation y(n) = cos2(n + 1)+x(n- 1). Answer ...

A:

Q: State the conclusion based on the series circuit experiment (lab report about ELECTRIC POWER IN PARA...

A: Series and parallel circuits are very important to analyze the large and complex electrical circuits...

Q: For a 3-phase induction motor, what fraction/multiple of supply voltage is required for a direct-on-...

A: Given, A three phase induction motor with, Starting current is limited to 4 times the full load curr...

Q: Consider the following short circuit transformer as shown in figure below which operate at: the shor...

A: The solution is given below 

Q: Find Xc Z, I, VR.Vc and don't forget to put their units. Source voltage 250z50° 12.5 kQ 3.5 kQ 140 µ...

A: The solution is given below. 

Q: 1. Determine the current passing through each diode, current passing through R, voltage across the d...

A:

Q: EX :(10):- A complex low-pass signal has a bandwidth of 1200 kHz. What is the minimum sampling rate ...

A:

Q: Question: An LTI system has an impulse response h(t) shown in Fig.(a) below. Use convolution to find...

A:

Q: 3. The fuel-cost functions in S/h for two 800 MW thermal plants are given by F = 400 + 6.0P, + 0.004...

A: Generator- A generator is a machine that generates electricity by converting mechanical energy into ...

Q: 40 k2, 8 kΩ 10 k2 20 kN +Vcc + 5 V -Vcc RL= 20 kQ +

A: We need to find out voltage at node 1 .  

Q: 5. A CT signal x(t) is given below. Sketch and label the following signal: (1) x(t)[8(t + 1.5) – 8(t...

A:

Q: Q4) The resistance of two wire is 25 2 when connected in series and 62 when connected in parallel, f...

A:

Q: A resistor and an inductor are connected in parallel to a 120 volt, 60 cps source. a) If the total ...

A:

Q: jan

A: The given circuit is shown below:  In the ac circuit, the condition for the maximum power transfer ...

Q: A 5-hp 120-V 41-A 1800 r/min shunt de motor is operating at full load. Its armature resistance is 0....

A: The solution is given below 

Q: * The given circuit Step!: lurrent loops 7n 三3H Ve = Ri = L di dt Vとことidt iz cdvc dt

A: The given circuit represent a circuit which has unknown voltage and current for them, the 3 steps ar...

Q: 9) Determine the maximum power transfer for the following circuit: 100 2 240 Ω 50 Ω 200 2 100 Ω RL 1...

A: Given circuit,

Q: Determine vo and i in the circuit ww- 12 V 4 V I+ (+ 1)

A: In this question , we will find unknown voltage Vo and current i in this circuit using KVL..

Q: IĘ = (ß + 1) I, H.W. Prove this equation %3D

A: Given equation, IE=β+1IB Here, IE is emitter current IB is base current β is current amplification f...

Q: express f(t) in terms of step function.

A: In this question, express f(t) in terms of step function. We know ramp signal r(t) = tu(t)   

Q: The below signal is: 2.5 0.5 -0.5 -1 5 4 -3 -2 -1 0 1 2 3 45 6 78 9 10 11 12 13 14 15 16 17 18 19 20...

A: Option C  Is correct  Since the signal has amplitude of 2 at n=6 So n delayed by 6 units  So (n-6) A...

Q: Find I, in the network in the figure. 7 mA 2 mA +1

A: Given circuit:  

Q: Define the Signum function.

A:

Q: EX :(9):- Consider a noiseless channel with a bandwidth of 3000 Hz transmitting a signal with two si...

A: Given, Bandwidth of transmitting signal is  BW = 3000 Hz Number of signal levels (L) = 2  

Q: Consider a 3-bit ADC and full scale voltage measurement range of (0-56) The Resolution will be O 7.0...

A:

Q: Three capacitors of capacitances =10F, =20F, The same three capacitors, , and were connected and =30...

A:

Q: -즐 <x<플 そくメ< Find the Fourier Series od (x)= x %3D ミT-つ 2.

A:

Q: R, - 15 kN V, R3 20 kn Vs1 R2 10 V 12 V 30 kN 1 mA Answer: V = 15.1111 V. 4.4444 V from V, 4 V from ...

A: The solution is given below

Q: From the circuit diagram provided. Use mesh analyisis to determine the currents of Ir1 & IL1 & IC1. ...

A:

Q: A full-wave rectifier uses two diodes. The transformer r.m.s. secondary voltage from the center tap ...

A: The solution is given below 

Q: Find the autocorrelation function of signal f(t)=e-|t|.

A:

Q: Determine the meter readings in Figure Vcc +8 V R 33 kN Rc 2.2 kN BDC 200 R2 10 kN RE 1.0 kN Section...

A:

Q: Consider a standard size 6-input NOR gate connected to a 20C load. Determine the following: 1 Best c...

A: The NOR gate is also called as a universal gate. So, by that we can also form all the basic gates us...

Q: 2, Find Inverse Laplace transform for the following functions: s+7 4 a) F(s) = %3D s2 - 6s + 8 s2 + ...

A: The solution is given below 

Q: Find the fourier Series of { 6) =20 Henee, dedute Shd -+능+능

A:

Q: Electrical Engineering From the following circuit, analyze the power consumption of the loads and in...

A:

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.