Under dc conditions, find the energy stored in the inductor in Joules. Give only the numeric value. 9V + 10 www www. 60 392 2 H m ell
Q: Find the equivalent capacitance between points A and B of the given circuit 3.5 uF 5.0 μΕ 8.0 µF 1.5…
A: The equivalent capacitance can be calculated by reducing the parallel and series connected capacitor…
Q: In case of a 4-pole machine, 1 mechanical degree corresponds to (i) 2 (ii) 4 (iii) 8 electrical…
A: Given a machine having, Total number of pole, P = 4 Mechanical degree, θm=1° Electrical degrees,…
Q: For a 10 MVA, 132 kV/6.6 kV power transformer with delta-star connections, obtain the number of…
A: We have an power transformer with, MVA = 10 MVA HV Side Voltage = 132 KV LV Side Voltage = 6.6 KV…
Q: Frequency modulated signal with single-tone modulation has a frequency deviation of 15 kHz and…
A:
Q: The voltage applied to a circuit is v=230 sin (ωt +30°) and the current through the circuit is i =…
A: We have been asked to find, Parameters of given circuit (Z, R, X) Power Consumed by Circuit The…
Q: A current of 5 A in primary coil of a circuit is reduced to zero at a uniform rate in 10 seconds. If…
A:
Q: Q\ What is the VSB modulation? and why it used? and how it can be generated?
A:
Q: Find the line current, shaft speed, load torque, induced torque, and rotor frequency of an induction…
A:
Q: Assume a Y-Y connected balanced 3-phase system in positive obc sequence with phase voltage of…
A: Given data, A Y-Y balanced 3-phase system in positive sequence. Phase voltage of magnitude Vp=170 V…
Q: 19. A factory draws an apparent power of 300 kVA at a lagging power factor of 0.65. The active power…
A: Given: A factory draws an apparent power, S=300 kVA Lagging power factor, cosϕ=0.65
Q: of electrons from the plate is caused by the acceleration of electrons by the screen grid. This…
A: Answer: Secondary Emission
Q: Problem: A 25 Q resistor is connected in parallel with an inductance of 2.5 mH across a Vrms = 75<0°…
A: Given:
Q: Eq5. A 4-pole, 3-phase induction motor operates from a supply whose frequency is 50 Hz. Calculate:…
A: Given: A 3-phase induction motor with P=4f=50 Hz
Q: Activity no. 2. Kirchhoff's Voltage and Current Law 1. Calculate the current I using KVL. 20 V 10 V…
A:
Q: A three-phase induction motor is taking 40 kW, the slip being 4%, stator losses amount to 800 watts,…
A:
Q: while using a synchronous Buck Converter. How can we keep the output constant with a vairying…
A:
Q: 8. a). What are the values of the inductor voltage and current and the capacitor voltage and current…
A: Given data, Circuit diagram is given as,
Q: Fig. shows the single line diagram of a 3-phase system. The percentage reactance of each alternator…
A:
Q: A system shown in Figure Q3 a) has a damping ratio of 1 and a natural frequency of 10 rad/s.…
A:
Q: Find trigonometric Fourier series expansion of the following plotted signals.
A:
Q: Using Ampère's law (OB•dl = H,I ene + HoEo VE ) to show that the magnetic field a distance r dt %3D…
A: Given- Magnetic field lines at distance= r Constant current = I
Q: An industrial plant draws 500 kW at 0.6 pf lagging from a 3-phase system. In order to raise the…
A:
Q: 3. x(t) = e-³tu(t) + e¯¹u(-t) h(t) = 8(t)e-2|t| Find y(t) = x(t)*h(t)
A: Given data, xt=e-3tut+e-tu-tht=δt-e-2t
Q: Que 4.20. Find the Y-parameter model. A the Y-parameter I 13 YA of the following -circuit and draw…
A:
Q: Que 4.20. Find the Y-parameter model. A the Y-parameter I 13 YA of the following -circuit and draw…
A:
Q: Find the value of R to show that circuit is critically-damped Uz +1 R W ΙΚΩ ww 1 μF 00 ΤΗ
A:
Q: 4. If the pressure in a tank is 345 kPa, Required: find the equivalent pressure head a) Mercury…
A: Given: Pressure in a tank is 345 kPa, we have to determine the equivalent pressure head for mercury…
Q: 25 Given the closed-loop transfer function T(s) = s2+3s+25 Find wn, Natural Frequency wn = Damping…
A: Given: The closed loop transfer function, Ts=25s2+3s+25
Q: Compute the power absorbed or supplied by each component of the circuit. Prove your answer using the…
A:
Q: Advantage of using a high frequency carrier wave is a. Signal can be transmitted over very long…
A: Given Advantage of using a high frequency carrier wave is..
Q: Compressible is a classification of ma where its molecu are existing separately om each other, which…
A: First answer : C (gas) solids and liquids can not be compressed even though there is inter molecular…
Q: Find the value of R to show that circuit is critically-damped 1 k$2 WW Uμ R W 1 μF 00 ΤΗ
A:
Q: Analog signal may be converted into digital signal by
A: The correct option along with the explanation is provided in the following section.
Q: An RLC circuit is connected across a variable frequency, 110V source. When the frequency is varied,…
A:
Q: What is the maximum transmission efficiency of an AM signal? a. 64.44% b. 33.33% c. 56.66% d. 75.55%
A:
Q: The three vertices of a triangle are located at A(6,-1, 2), B(-2, 3,-4), and C(-3, 1, 5). Find: a.…
A:
Q: A capacitor C is connected in parallel with a resistor R across a 60 V, 400 Hz supply. The supply…
A:
Q: separately-excited generator, when running at 1000 rpm supplied 200 A at 125 V. Find the generated…
A:
Q: the average output voltage
A:
Q: 1. True or false: In direct current (DC), the electric charge (current) only flows in one direction.…
A:
Q: Consider the feedback control system Select one: R(s). a. , 3.26 rad/sec = 100 s(s+11.8) Y(x)
A: Given data, Open loop transfer function is given as, Gs=100ss+11.8
Q: (2) V2 sine 1 kHz BAT2 15 V R1 7 ΚΩ Q1 2N2222 BAT1 15 V ww R3 ww Q2 2N2222 3 ΚΩ R2 7 ΚΩ D V3 sine 1…
A: Given, R1=collector resistance of BJT1=short R2=collector resistance of BJT2=7kΩ V2=Input base…
Q: Frequency modulated signal with single-tone modulation has a frequency deviation of 15 kHz and…
A: To solve the given problem, we will use Carson's ruleAccording to the Carson's rule 98% of the…
Q: A single phase transmission line delivers 1500 kW at 33 kV at 0.8 p.f. lagging. The total resistance…
A: Given P = 1500kW V = 33kV Pf = 0.8 lagging ZL = (10+j15)Ω Sending end voltage(VS): ? Sending end…
Q: A transformer has a rated output of 200 kVA at a power factor of 0.8. Determine the rated power…
A:
Q: Consider a causal second-order system with the transfer function 1 G(s) = 1+2s+s² with a unit-step…
A: The given transfer function is G(s)=11+2s+s2Unit Step R(s)=1sWe have to find the time taken by the…
Q: Ariela finds this circuit on the web and challenges Sean to a circuit solving contest to see who can…
A:
Q: Analog signal may be converted into digital signal by a. Sampling b. Amplitude modulation c.…
A: The correct option along with the explanation has been provided in the following section.
Q: Find 12 in the circuit shown below. 13 3Q 50L0° 712 a) 8.72-1.37⁰ b) 32-48.7° 5+j6 30/90° 6-j5 c)…
A:
Q: This goes with a unit ampere. a. Voltage b. Power c. Current d. Resistance e. Capacitance Which of…
A:
Step by step
Solved in 3 steps
- You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
- An inductor has a current flow of 3 amperes when connected to a 240-volt, 60-Hz power line. The inductor has a wire resistance of 15 . What is the Q of the inductor?Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?For the circuit shown, find vL (1ms). (Inductor voltage in one millisecond)
- (1) Find equation of current if charge q(t) = 5t2+10t+10. Also find value of current at t = 1sec. (2) What is value of capacitance if charge on capacitor is 20(micro C) and voltage is 10(Volt).The unit of capacitance is in Farad (F). One farad is equal to one coulomb per volt. If the capacitor is rated 10pF and is connected to an 8V dc battery, how much energy can it store? Enter in your answer in two decimal places and in pJ.The given circuit has Vth=30V and Rth=30K Ohms. If the inductor will be short circuit and the switch will be closed, what will be the current i (in mA)?
- Given:Vb = 100 voltsR = 10000 ohmsC = 200 μFAssuming that after a long period of time, the switch is flipped from position "A" to position "B" at t=0. How much is the energy stored in the capacitor after t=∞?P:16) Given the current across the inductor @ t= 3s is 0.875 A. What is the voltage across the 3 ohm resistor? Assume that the switch is open.a) Find the mathematical expression for the voltage VR (t).b) Calculate the reactive power on the capacitor.