(USCS units) A sine bar is used to determine the angle of a part feature. The length of the sine bar = 8.000 in. The rolls have a diameter of 1.000 in. All inspection is performed on a surface plate. In order for the sine bar to match the angle of the part, the following gage blocks must be stacked: 2.0000, 0.5000, 0.2500, and 0.0050. Determine the angle of the part feature.

(USCS units) A sine bar is used to determine the angle of a part feature. The length of the sine bar = 8.000 in. The rolls have a diameter of 1.000 in. All inspection is performed on a surface plate. In order for the sine bar to match the angle of the part, the following gage blocks must be stacked: 2.0000, 0.5000, 0.2500, and 0.0050. Determine the angle of the part feature.

Precision Machining Technology (MindTap Course List)

2nd Edition

ISBN:9781285444543

Author:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Publisher:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Chapter2: Measurement, Materials, And Safety

Section2.5: Quality Assurance, Process Planning, And Quality Control

Problem 5RQ: What is the important factor to consider when choosing the proper measuring tool to inspect a...

See similar textbooks

Similar questions

23) In wire drawing process, the cross sectional area of wire is reduced. Select one: True False
Research and identify one type of geometric tolerances (besides obvious specs like length, distance, diameter, etc.) that can be called out on a technical drawing. Discuss a specific feature in a specific product/design case where calling out this geometric tolerance would be relevant for performance, assembly, or general operation.
A siilicon boule has been processed through grinding to provide a cylinder whose diameter = 281 mm and whose length = 899 mm. Next, it will be sliced into wafers 0.8 mm thick using a cut-off saw with a kerf = 0.5 mm. The wafer thus produced will be used to fabricate as many IC chips as possible for the personal computer market. Each IC has a market value to the company of $108. Each chip is square with 17 mm on a side. The processable area of each wafer is defined by a diameter = 265 mm. Estimate the value of all of the IC chips that could be produced (in $), asssuming an overall yield of 84% good product.
104) Which is not one of the methods used to specify geometric features in technical drawing?A) circularityB) fluidityC) sizeD) smoothnessE) tolerance 105) How does aluminum yield strength change as a result of annealing?A) first decreases and then decreasesB) first increases and then decreasesC) increasesD) decreasesE) does not change 106) which gives the stainless steel property?A) chromeB) vanadiumC) molybdenumD) manganeseE) sulfur
On what produced part below, show a simple sketch on how the flatness on the part may be verified and how the resultant flatness tolerance zone is defined. Please refer to attached image.
Numerical analysis
How to get the answer 371lbs. I need the correct explanation within 30-45 Minutes.
What is meant by the idea of testing individual units?
What is a transfer-type measuring tool?
You have the following information: (IMAGE) Taking into account the above, answer the following questions: 1) Calculate the safety stock that allows for 5 stockouts in a year. 2) Calculate the reorder point that will allow for these 5 stockouts in a year. 3) Calculate the number of stockouts in a year, corresponding to a safety factor of 0.84. 4) Calculate the reorder point that allows the number of stockouts corresponding to a safety factor of 0.84.
-write legibly and show complete solution-write the answers on 5 significant digits in mm^4
Which is a more precise (or exact) measuring tool, the top-loading balance or the graduated cylinder?