Use mesh analysis to find the power dissipated through the 6kohms resistor and use kirchooffs law on the same question to verify the answer

Q: Problem #1) Given the following circuit: 2 KR 240V IDC 10kΩ 15ΚΩ VRX - Rx=33kΩ 2ΚΩ Determine: a) the…

A:

Q: 1- Calculate RF such that V0=-9 V

A: For the given summing amplifier the value of the feedback resistance needs to be calculated for the…

Q: Explain the concept of microcontrollers and how they differ from other types of integrated circuits

A:

Q: 22. Find the current through each resistor in Figure 9-33 Figure 9-33 1.5 V 14 R₁ 47 02 www IA www…

A:

Q: Q1:A: Draw the signal flow graph and find the transfer function C/R for the system shown in Fig.1. R…

A: In this question, we need to determine the transfer function and also draw the signal flow graph.

Q: 2.25 Find the gain as well as the output impedance of the current amplifier of Fig. P2.25 is |11 =…

A: GivenThe circuit diagram of the current amplifier is,To find outGain of the current amplifier…

Q: Question 3: By using the KVL and the Ohm's laws, calculate I₁, I2, IL and VÂG with: The switch S1…

A: In this question, we need to determine the currents I1 , I2  and IL  and voltage VBG  as shown the…

Q: 1. Determine Zi, Zo, and Av for the network of Fig. 1 if Ipss = 6 mA, Vp = -6 V, and gos = 40 μS, H…

A:

Q: (a) What are the limitations of a basic difference amplifier? How an Instrumentation amplifier…

A: It is asked to show that the application of negative feedback reduces the fluctuation of the gain…

Q: Question 1 The terminal voltage and terminal current were measured (b) on the device (a) shown.…

A:

Q: 3. If you are preparing to design a low pass filter using an RC circuit with a resistor (R) of 10…

A: In this question, we need to determine the transfer function of the LPF. We know capacitive…

Q: a) Determine (derive) the gain for the variable gain difference

A:

Q: Use the Fermi-Dirac equation to determine the probability that an allowed energy state is occupied…

A:

Q: B: Sketch the complete root locus plot of the system having G(s)H(s) K/(S(S+1)(S+2)(S+3)), Find the…

A: In this question, we need to draw the root locus and range of k over which system is stable.

Q: ₂) Find transfer Function b₂ Xx₂ m2 X₁ (s) F(S) f(t) k and Jx₁ X2 (5) F(S)

A: In this question, we need to determine the transfer function.. .We solve this problem using the…

Q: For the balanced positive-sequence three-phase circuit shown below, fill the given below tables…

A:

Q: 9V R1 50 Ω 12V R2 200 Ω. R3 100 Ω R4 1 ΚΩ a) Calculate and measure the current across resistor R1,…

A:

Q: Vin 500 £2 www 500 2 200μF Yout Ω Determine the frequency response Vout(W)/Vin(jw) for the circuit.

A:

Q: DETERMINE BY MEASUREMENT NORTON EQUIVALENT FOR THE CIRCUIT BETWEEN NODE A AND GROUND. VS 18V R1 39kQ…

A:

Q: Describe the principles and advantages of microchip fabrication using CMOS technology. How does it…

A: We need to describe the principles and advantages of microchip fabrication using CMOS technology.…

Q: How do thermal printers work, and what are their common applications in various industries?

A: Thermal printers operate on the principle of heat-sensitive technology. They consist of a thermal…

Q: 6. For the following circuit, find the powers associated with each circuit element. 120 V 30Ω ww +…

A:

Q: 9. In a series RLC circuit, L is varied to produce resonance keeping the supply frequency and 200 Ω,…

A:

Q: 2. calculate current in 5 Q resistor in the below figure given * 20 V 10- Fig 2

A:

Q: 2.2 If the interconnection in Fig. P2.2 is valid, find the total power developed in the circuit. If…

A: Basically Two rules are there in ideal sources interconnection.1) Two or more different ideal…

Q: + 30 to 3Ω t = 0 - Vs 2 mH fit fic -0.5 mF R₂ Is The switch is closed at t=0. Write the numerical…

A:

Q: Q4: A: For the unity feedback closed loop system, having forword transfer function G(s)= k/(…

A:

Q: Calculation discrepancy with Smith chart: I am trying to find the input impedance for a load that is…

A: According to the question,Load impedance Characteristic impedance We need to calculate the input…

Q: What is the percentage accuracy at Vout?

A: For the given potential divider circuit the percentage of accuracy for the output voltage needs to…

Q: Using mesh analysis find Io. (Concept : Mesh Analysis) 5Ω 10Ω www 1. 12V (+ 20 Ω Μ 15Ω (1)2 A (3v 3…

A:

Q: 5V 3000 1000 FKH 2m(1) Si 4000 500 12V The circuit shown in Figure 1 contains a Si diode with a…

A: The given circuit is shown below.The diode is a Silicon diode with on state resistance of . We need…

Q: ound in (a)?  Part (C) At what instant of time is the power being extracted from the circuit…

A:

Q: Question 4 The variable resistor R is adjusted until io = 10 mA. Find the value of R

A: The circuit diagram,

Q: Given that the power supply is set to 9.OV, current is limited to 0.10A and VR is 7.10V, calculate…

A: The circuit isWe need to calculate the voltage drop across LED.

Q: A signal x(1), whose Fourier transform X(t) is shown in the figure below, is normalized so that…

A: Signal X(t)  = 60 kHz per voltWe need to find the bandwidth required for transmission.

Q: P1: A 7. SV zener diode has it nominal Voltage when I = 5mA. The incremental resistance at the…

A: In this question, we need to determine the zener voltage if current flow in the circuit I= 15 mA.

Q: Consider the circuit as shown below. R₁=192 V₁=8 V V2-4 V H R₂=292 R₁-2 22 V3-4 V R₁-6 Q Use…

A:

Q: USING [Parallel Analogy] X2(s)/F(s)

A:

Q: - ENCUENTRE LA TRANSFORMADA DE FOURIER PARA LAS siguientes funciones: A Cs(wt); 1.. 2: 3: pulso…

A:

Q: 18.10 Find the a parameters for the circuit in Fig. P18.10. Figure P18.10 1 + 1 kn V₁ 10-4 V₂ 1₂ +…

A:

Q: Part (A) At what instant of time is the power being delivered to the circuit element maximum? Part…

A:

Q: Covert this to signal flow graph then solve for the transfer function V_o(s)/ V_i(s). R₁ ww Ls elle…

A:

Q: 58 CIRCUIT ANALYSIS TECHNIQUES DRILL EXERCISE 2.2 Use nodal analysis to find the node voltages v₁,…

A:

Q: A 5 km long 3-phase line has a horizontal configuration of 4 ft. spacing. The conductor is 336.4 MCM…

A:

Q: A diode at room temperature (VT=25mV) conducts 1.2 mA when its forward voltage is 0.7 volts. What…

A:

Q: Find the SAE's for the assigned nodal voltages. Solve for the nodal voltage v3 (in volts).

A: For the given circuit the simultaneous algebraic equations and noda voltage needs to be obtained.

Q: b. A system is represented by the black box as shown in figure 4. If the input value of the box is 1…

A: In this question, we need to determine the transfer function of the system. We know, transfer…

Q: 5 mW signal is supplied to an amplifier with a gain of 16dB. What is the output power of the signal?

A: In this question, we need to determine the output power in Watt and decimal. If gain is 16 dB and…

Q: B: Sketch the complete root locus plot of the system having G(s)H(s) K/(S(S+1)(S+2)(S+3)), Find the…

A: In this question, we need to draw the root locus and range of k for given system is stable. We solve…

Q: 50Ω W b 3.0 d 25.02 3.02 402 W M 60 W 5.02 5.0 C 202 e 75.0 100Ω W

A:

Star Delta Conversion

Find the input resistance between points A and B of the following resistive network: