Use the following values:r=160ZR= 4 OhmsWrite the final answer to at least 5 significant figures Questions 13Given: r, ZRj2 NI+V.ZR NFind the voltage V, in rectangular form.Find the current I in rectangular form.

Answered: Image /qna-images/answer/6bdf10ba-1301-40d1-b794-0dd90b6e36e8.jpg

Answered: Use the following values: r=160 ZR= 4…

Engineering

Electrical Engineering

Use the following values: r=160 ZR= 4 Ohms Write the final answer to at least 5 significant figures

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.3MCQ: If a phasor representation of a current is given by I=70.745A, it is equivalent to a. 100e/45 b....

See similar textbooks

Related questions

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

A: We need to find out voltage for given circuit

Q: SOLVE THE FOLLOWING. SHOW COMPLETE SOLUTION, CIRCUIT TRANSFORMATION, RESISTANCE COMBINATION.FIX…

Q: If an ohmmeter was used to measure a 20Q resistance and its readings where as follows: 19.50 20.5Q…

A: Exactness alludes to how close estimations are to the "valid" esteem, while accuracy alludes to how…

Q: What should be the value of the resistor R? 90 mA 60 mA R13 24 N 10 ohms 11 ohms 13 ohms 12 ohms

A: We need to find out value of resistance for given current .

Q: 1- Calculate the voltage across the dependent source. 20 2420° V VO 2v.

A: Circuit diagram is given as,

Q: The terminal voltage of a battery is 13.5 v when 5 A current enters its positive terminal, but when…

Q: Solve for Vo and ID +8 V 1.2 ka 4,7 k2 Id=Blank 1 mA at least 2 decimal place Vo=Blank 2 V at least…

Q: An electric geyser/electric storage tank water heater is used to raise the temperature of 150 litres…

A: According to the question we have to find the input energy required to heat the water.

Q: 4. How long can a 12 Volt car battery supply 250 Amps to a starter motor if the battery has 4 * 106…

A: Given: Voltage of car battery, V=12 V. Current, I=250 A. Chemical energy in battery, E=4×106 J.

Q: To measure the resistance of about 8 Q which instrument should be used? Kelvin's double bridge…

A: Given: To measure resistance value of 8 ohm

Q: zero O b. 202 Oc. 52 If a simple wire is connected across the two terminals of a resistance, the…

Q: Fill in the blanks / identification: 14 2 30 Ω 20 Ω a 27 N 50 Ωξ 24 2 30 Ω 12 0 FIND THE VALUE OF…

Q: Question: Calculate the voltage of your battery bank. Assume suitable values if needed.

A: Question: Calculate the voltage of your battery bank. Assume suitable values if needed.

Q: Q4. In the meters shown below, if you have to choose them based on their abilities which is…

A: Time-invariance: For the time-invariance system, the time delay provided in the input must be…

Q: Find the Thevenin Voltage at node A with respect to B. Round to the tenths place (1 decimal place).…

Q: 2 ま61 ま84 20 102 MA Find I

Q: 2. A platinum coil has a resistance of 3.146 ohms at 40 deg. C and 3.767 ohms at 100 deg. C. Find…

Q: Identify the given statement. Lead and mercury are examples of superconductors. Select your answer.…

A: Superconductors: A superconductor seems to be a substance that obtains superconductivity, a state in…

Q: The expected value of the voltage across a resistor is ‘A’V. However, measurement yields a value of…

A: Expected value = A Measured value = B

Q: A 15 meter wire with a resistance of 0.10 2/m is connected across a 9 V battery. How many amps of…

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

Q: In a Measurement ,the Expected value is 25 V and the measured value is 21 V. Find (i) absolute error…

A: The given data's are, Expected value is 25 V, Measured value is 21 V. Absolute error: It is the…

Q: Current 2.94 A Current 1.56 A 1.38 A

A: Given circuit shown with Resistance valueR1=20 ΩR2=19 ΩR3=11 ΩThe computed values of the current…

Q: Calculate the current and voltage. Then Obtain the Thévenin equivalent, calculate the current and…

Q: When connected to a 4-ohm resistor, a battery has a terminal voltage of 6.5V. If the open-circuit…

Q: a) If input voltage = 235Cose of the following figure.2, then draw the voltage curve across the Ri…

A: A Half-wave rectifier is an AC to DC converter. single-phase HWR converts AC voltage into pulsating…

Q: Use the following value: Vs=30V write the final answer to at least 5 significant figures.

Q: 9 uonsanD Which of the following achievements is NOT related to the Egyptians? The first recorded…

A: i) Bitumen has been identified for the first time in Egyptian occupied Nubia. ii) In Egypt, drip…

Q: A room 15 m x 15 m is lit by 20 lamps to a fairly uniform illumination of 100 lm/m2. Calculate the…

A: A room 15 m x 15 m is lit by 20 lamps to a fairly uniform illumination of 100 lm/m2.given that the…

Q: The current of an ammeter is 1 mA with coil resistance 100 Q used to measure 10 A. calculate the Rsh

A: Given: Ammeter current , Im=1mA Coil resistance ,Rm=100 ohm Current to be measured , I=10A Rsh=?

Q: 13.) Fill in the blank: The ammeters and voltmeters record the r.m.s. values of "and voltage…

A: We need to fill the blank space for given statement

Q: instrument can be used as O a. All the options are correct O b. Galvanometer O c. Voltmeter O d.…

A: In this question , we have to define PMMC instrument uses..

Q: Find the value of the unknown current ixfrom the given circuit.

A: According to Kirchhoff's current law, the total current entering node A will be equal to the total…

Q: Fill in the Blanks Type your answers in all of the blanks and submit A 2 HP motor has an efficiency…

A: In this question we need to find a input power and supply current

Q: A battery is supplying electrical power to a single resistor R. If the total current in the circuit…

A: The circuit will be as :- It is given that current flowing in the circuit is 0.75 A. And EMF of…

Q: Unlike the solar energy, the wind energy has the advantage of being available all the time.

Q: Consider the circuit given, where R= 3 Q. lic 48 Ω 10u(-t) mA 2 mF : 250 mH Determine id0"). (You…

A: Given switch is open for t<0 and assume circuit reaches steady state for t<0. At steady state…

Q: with battery. Assuming a half scale šēries Ohmmeter is desired at Rx=1k 2, then Rị is found to be…

Q: 4. Determine RTH of the given circuit in figure 1. 5. In Number 4 define VTH. 1. 22 요 A 44요 222 332…

A: Given : Brief description: In the above given question they have mentioned an electrical circuit…

Q: The initial cost of an energy saving plant is 4,75,000/- and its useful life is 12 years. The…

Q: Quéstion 6 If an ohmmeter was used to measure a 200 resistance and its readings where as follows:…

A: Check the ohmmeter is precision or accurate? Reading of the meter are showing.

Q: The resistance of a coil of copper wire is 3.35 2 at 0°C. What is its resistance at 50°C. For copper…

A: GivenTemperature T1=0°CResistance at 0°C=3.35ΩT2=50°CTemperature coefficent α=4.3×10-3C-1

Q: The expected value of the voltage across a resistor is 90 V. However, the measurement gives a value…

Q: STRENGTH OF M ATERIALS ABORAT ORY COMPRESSION TEST

A: COPRESSION TEST:- We have to use the universal testing machine for this experiment. APPARATUS : 1)…

Q: 6 kN R kN 6 kN Is mA )3 V Use either nodal or mesh analysis to determine i1. +

Q: 4. Determine the numerical value of the voltage V, . 40 k2 5 k2 5 k2 9 V ( * 5 V 20 k2

A: To find the value of VZ in the below circuit:

Q: Application of Memristor

A: In this question we will write Application of Memristor....

Q: Use the following values: Vs=14V R=8 Ohms Write the final answer to at least 5 significant…

A: Perform the following steps to solve the given example using nodal analysisIdentify the nodesLabel…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

Use the following values:

r=160

ZR= 4 Ohms

Write the final answer to at least 5 significant figures

Questions 13
Given: r, ZR
j2 N
I
+
V.
ZR N
Find the voltage V, in rectangular form.
Find the current I in rectangular form.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Convert into rectangular, polar and exponential form:Given: Z1= 2-j3 Z2=3-j51. (Z1)^−5
Given that Z1 = 10+j5 and Z2 = 20- reduce Z1+Z2, Z1-Z2,Z1Z2 and Z1/Z2 to rectangular form.
Solve the power triangle at Z3 using the following network law below. Thanks in advance!!!2.) Maxwell EquationGiven:V1, V2, and V3 = 200∠0° V, 60 HzZ1 = 3+j5 ohmsZ2 = 4+j7 ohmsZ3 = 8+j6 ohmsZ4 = 5+j10 ohmsZ5 = 7+j8 ohms
Given that n=5, find the phasor voltage and current V1, V2, I1, and I2.
Use source transformation to determine Vo as a result of the independent contribution from the voltage source Vs=18<90°. Give the answer in rectangular form
Solve the power triangle at Z6 using the following network laws below.1.) Kirchoff's Law2.) Maxwell Equation3.) Nodal Analysis Given:V1, V2, and V3 = 220∠0° V, 50 HzZ1 = 7+j8 ohmsZ2 = 6+j3 ohmsZ3 = 5+j5 ohmsZ4 = 2+j3 ohmsZ5 = 8+j4 ohmsZ6 = 1+j9 ohms
Find the total impedance, voltage drop on the 100-ohm resistor, draw the phasor diagram of the voltage and current at R1, total power (apparent) delivered by the current source, draw the phasor diagram of the voltage and current at the source. Also, is the circuit inductive, capacitive, or neither (resistive)? please give the step-by-step solution NOTE: Polar form for Voltage & Current. Rectangular form for Impedance
Determine the mesh currents I1 and I2 in phasor form
The circuit shown in the figure is in the frequency (phasor) plane.showing the environmental current equations in the simplestShow in the figure [Z] [I] = [V]?Here [Z] impedance matrix, [I], [V] respectivelyis the vector of current and voltage.
Given the phasor V2=5∠50o, the equivalent phasor voltage is given by the expression?
PLEASE SOLVE THIS SHOW the circuit in the figure in the frequency (phasor) plane.showing the mesh equations in the simplestShow in the figure [Z] [I] = [V]?Here [Z] is impedance matrix, [I], [V] respectivelyis the vector of current and voltage.
Suppose that v1(t)=100 cos(ωt+45°) and v2(t)=150 sin(ωt+60°). Use phasors to reduce the sum vs(t) = v1(t) +v2(t) to a single term of the form Vm cos(ωt+θ). Draw a phasor diagram showing V1, V2 and Vs. State the phase relationships between each pair of these phasors.