Answered: Use the results of Problem 5 to find…

Use the results of Problem 5 to find the value of phase o that minimizes the (peak value of) current Io in the circuit shown. 6Z0 V j4 Q 30 j3 2 t 4290° A

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.13P

See similar textbooks

Related questions

Q: 1. The current in an AC circuit at any time 't' seconds is given by : i=120sin(100r1 + 0.36)…

A: Sinusoidal alternating currents are commonly used in electrical and electronic systems. The general…

Q: ind the sum of the voltages and its phase angle and the angle difference. 1. ez = 12 sin 10t + 60°V…

Q: Q-2 The voltage across a 40 2 inductive reactance is given. What is the sinusoidal expression for…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: A coil of inductance 0.1 H and negligible resistance is connected in series with a 25 2 resistor.…

A: The values given by them is wrong you can simply check that the phasor sum of voltages VL and VR is…

Q: H.W : Find the phasor of the following signals: a. v(t) = 8 cos(2000t+40°) volt b. v(t) = 5 sin(200t…

A: The phasor format has RMS value as magnitude and angle as phase angle. Thus we will convert each…

Q: Question 1 The maximum value of a sinusoidal voltage is 220 V. it's rms value is 140.02 V 311.17 V…

A: In the above given question they have mentioned maximum voltage of the sinusoidal signal that's 220…

Q: If the frequency were doubled, what would be the new impedance? R E sine R = 123 ohms XL = 16 ohms…

Q: 6. A series RLC circuit with L=160mH, C=100µF and R=40.00 is connected to a sinusoidal voltage…

A: Given series RLC circuit with source e=40 sinωt ,ω=200 rad/secL=160 mHC=100 μFR=40 Ω

Q: Determine the instantaneous equation of the given waveform. 40cos(wt + 80 degrees) V 40sin(wt + 80…

Q: 4. What is the value of Phasor shift if R=300N L=400 mH with f = 50 Hz. Discuss the increase or…

A: In R-L circuit phase angle, ϕ=tan-1wLRwhereϕ=phase-shiftL=inductanceR=resistancew=angular frequency…

Q: Q3/What is the phase relationship between the sinusoidal waveforms of ?each of the following sets a.…

A: We need to tell phase relationship for given .we will find out phase angle for given set then decide…

Q: theo Ch2: Sinusoidal Steady-State Analysis Sinusoids OExample: Calculate the phase angle between vi…

Q: vab=12V Ra=24kohms Rb=30kohms Rc=32kohms determine the current passing on the 2nd resistor (Rb)

A: This question belongs to circuit theory . It is based on the concept of current division rule in…

Q: Given v = 170 sin (120at + /2), what is the period? %3D Given v = 170 sin (120at + T/2), what is the…

Q: 23. If the impedance of the circuit is 50ohm and the resistance is 8ohm. Find the power factor A.…

A: 24. Given: Impdedance,Z=50ΩResistance,R=8Ω

Q: 4 0 -is n 6 0 -j8 N js n 220/-30° V Figure 3. Referring to figure 3, determine the rms current at…

Q: The equation for an altemating current is given by i = 75 sin 314.16t. Find the peak value,…

Q: 1.18 In the circuit shown in the figure below, for what value of C will the current-I be in phase…

A: we need to find out value of capacitor C.

Q: Average power is the power converted from electric to nonelectric form and vice versa Select one: O…

A: In this question we will write about average power...

Q: electromagnetics-milford A. In the circuit of the below figure, obtain the impedence. B- obtain the…

Q: A Series RLC circuit with L=160mH , C= 100mF and R= 40.0ohms is connected to a sinusoidal voltage…

Q: Get the phase difference of the two signals. Only the absolute value of the angle is needed. a(t) =…

Q: Problem 5: The current through a 6.8 kN resistor is as indicated. Find the sinusoidal expression for…

Q: Given A = 10 cos (5t+60). Find i)the peak value of A ii) the A frequency in Hz iii) the A in sin…

Q: 12. If an AC voltage has a peak value of 160.5 V, wat is the phase angle at which the instantaneous…

A: 12. It is given that: Peak Voltage=Vm=160.5 VInstantaneous voltage=v(t)=110 V

Q: State which one is leading by determining the phase angle between the two sinusoids below. V1 = -10…

Q: a) Draw a graph that depict single-phase waveforms for a purely sinusoidal 50 Hz voltage with…

A: a) Draw a graph that depict single-phase waveforms for a purely sinusoidal 50 Hz voltage with…

Q: What is the capacitance to be connected in parallel with the load to increase the power factor to…

Q: Given : VT - Vm sin wt f = 60HZ Vm = 310V (2) R4 = 28 2 L, e 0.06 H Find : (a) RMS calculated vo…

Q: 5. Determine the rms values of the following instantaneous equations -- (answers must be in 4…

A: Find the RMS values for the given sinusoidal waveforms.

Q: Compute the complex power S (in polar form) drawn by a certain load if it is known that (a) it draws…

Q: Q6. Find the average power and the reactive power (both the magnitude and the sign) for each element…

A: In this question , we will find average power and reactive power for each element...

Q: Consider the sinusoidal voltage v = 48 cos(32t + 10°) V. NOTE: This is a multi-part question. Once…

A: Given: Vt=48 cos 32t+10°V

Q: a. v(t) = 10cos(26t + 340°) V i(t) = 4sin(26t - 200°) A b. v(t) = 8sin(45°) V i(t) = 3cos(-45°) A c.…

Q: Find the phase relationship between the following pair of waveforms: a) v = 25 V cos(@t + 77°) i = 4…

A: The phase relationship between v & i is given

Q: Consider the following circuit, supplied by a 10VRMS current source with a 0° phase shift (i.e.…

A: Circuit diagram is given as,

Q: In the circuit shown below, C= 0.40 µF and R = 500 N. The phase difference between the source…

Q: 100 µF 6 mH 14 Q 30 Ω +)12 cos 377t (V) 10 mH 30 mH RLS 10 Q

A: When two coils are placed close to each other, a change in current in the first coil produces a…

Q: A certain element has a phasor voltage of V = 200/30 V and current of I = 6/120 A. The angular…

A: Given: An element with phasor voltage, V=200∠30° V Current, I=6∠120° A Angular frequency, ω=500…

Q: 4 0 -js N -j8 N 6 0 js n | 220/– 30° V Figure 3. Referring to figure 3, determine the rms current at…

A: To find 1. rms current through j5ohm=I 2. rms voltage across j5ohm=V

Q: 52 -jss2 RL |ooLo° V rms +

Q: Q.1 An alternating current is given by i,(t) = 50 sin (50za – 100°)A. (i) Determine the period,…

Q: Find the RMS value of Vit)-100 sin(377t+76) V 141,421 V 55,10 V 100 V 70.71 V

A: Given data: The Rms value is, Vt=100SIn377t+76 V

Q: Determine: (i) Average Value, (ii) RMS value, (iii) Form factor, and, (iv) Peak factor for the…

A: In this question, Current waveform is shown in the figure. Find the average current, rms current,…

Q: ww v(t)=28.284 cos(ot + 55°) + S' I

Q: In the circuit shown below, the angular frequency w at which the current is in phase with the…

A: Given circuit is - Given that current is in phase with voltage.

Q: VR in-phase with I V, lead I Ve lags I M w MA C R L 0.l MF 5V $= 500 Hz

Q: In a given circuit the applied voltage and resulting current are given as follows: v= - 200 cos…

A: In a given circuit the applied voltage and resulting current are given as follows: v= - 200 cos…

Q: Get the phase difference of the two signals. Only the absolute value of the angle is needed. a(t) =…

Question

Use the results of Problem 5 to find the value of phase o that minimizes the (peak value of) current Io
in the circuit shown.
-j4 Q 3Q
3j3 2 1) 4290° A
6Z0 V
lo

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
The power factor for a capacitive circuit (R-C load), in which the current leads the voltage, is said to be (a) Lagging (b) Leading (c) One
The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero
find the following : a) the peak voltage Vp b) the Peak to bottom Vpp c) the Time period d) The frequency e) the phase differnece
What is the peak factor of 169sin 377t? Answer: 2.02
When you are converting an instantaneous current to a phasor, how does the phase angle being positive or negative affect solving the problem i.e. the representation being (wt - the phase angle in degrees) or (wt + the phase angle in degrees)?
A resistance of 20 Ω, an inductance of 0.2H and a capacitance of 100μF are connected in series across 220-V 50 Hz mains. Determine the following: a) impedance b) current c) voltage across R, L, and C d) power in watts and VA e) power factor and angle of lag.
A. Find the total impedence Zt in polar form. B. Draw the impedence diagram. C. Find the current and voltages Vr,VL and VC in phasor form. D. Draw the phasor diagram of voltage E,VR,VL and VC and the current I. E. Verify kirchoff's voltage law arround the closed loop. F. Find the average power delivered to the circuit. G. Find the power factor of the circuit, and indicate whether it is leading or lagging. H. What happened if Xc=2ohm? Please explain.
Find a value of inductance less than 100 Henries, which ensures that the current, IS(t), is in phase with the source voltage, VS(t) = 12 cos (2000t-45°).
Polyphase is defined by the presence of two or more sinusoidal voltages, each with a distinct phase angle. True False