Using Ohm's Law, determine the amount of current the ammeter in the circuit of Figure 1 below will measure: 220 0 12 V 4.7 kO Figure 1 00244 amps .0244 amps 244 amps 000244 amps

Q: Report : 1- Calculate IN., RN. And IL theoretical? 1k Ohm 330 Ohm 6 V/1 kHz RL 220 Ohm 330 Ohm

A:

Q: Determine the cutoff frequency of an op-amp having specified values B1=4 MHz and AVD= 171 V/mV.

A: Given  Bandwidth and voltage gain of an op amp.we need to determine the cutoff frequency. Please…

Q: Determine the field intensity at point P using Biot-savart law for a line current along the z-axis…

A: Given    Point P(4,0,0) Line current and length of 9m We needbto determine the field intensity at…

Q: Q.1. The gain margin (in dB) of a system having the loop transfer function G(s)H(s)-(2)"/(s(s+1) is…

A:

Q: IS 15. The electrolysis of water produces A. gaseous water B. H2 and O2 gases C. electrically…

A: Electricity is used for electrolysis Electricity is passed through the water Then water is…

Q: d q2 = -2q q3 = -3q Find the direction and magnitude of net electrostatic d. d force excert on the…

A: We need to find out force on charge particle

Q: Calculate the total offset voltage for the circuit shown below for op-amp specification values of…

A:

Q: Q2): A 1500-V, 50-Hz delta-connected induction motor has a star-connected slip-ring rotor with a…

A: Phase voltage and line voltage in delta connected system remain same Phase current and line currents…

Q: An A.C. supply voltage source v(t)=12 sin (377t) volt is connected in series with 50 N resistor. The…

A: Given, An A.C. supply voltage, vt=12 sin 377t volt                            where Vm=12 V Series…

Q: resistor for each network in Fig. 8.121. Then determine the voltage Using mesh analysis, determine…

A:

Q: Three identical coils are connected as delta load to a three phase supply. The line current drawn…

A: Here given in the question that active power is P = 75 kw which is greater than apparent power S =…

Q: A delta connected balanced load is connected to a 3 – phase, 400 V supply.  The line current is 35…

A: The solution is given below  The phasor analysis of delta connected load can be done

Q: Q2/Complete the following sentences: 1) If an A.C position is chosen of Input Coupling Selector in…

A: The oscilloscope is a instrument which can be used to monitor the electrical signals in a wire by…

Q: Given in Figure la is an operational amplifier used as a summing amplifier that accepts three…

A: Summing amplifier is used to process analog signal.summing amplifier is used in a audio amplifier.…

Q: Given the circuit shown below, use nodal analysis to get the voltages across all resistors. R4 40 0…

A: The basic kcl solution is shown below .

Q: Question Implement the Function 'Y = ACB + BC + E' using a 4-Input, 2-Address Bit Multiplexer. What…

A:

Q: H.W: for the circuit shown in figure find: (a) the charge in each capacitor. (b) The total charge.…

A: In this question,  We need to determine the charge in each capacitor, total charge, equivalent…

Q: A 300kw , 250v, 8pole , generator has a simplex lap winding. Determine the voltage generated per…

A:

Q: Determine the reading on the meter when VCC = 10 V, RC = 5 k2, and IC = 1mA. Re E O a. -5V O b. 0.7V…

A:

Q: .The value of E at the conductor's surface is always parallel to the surface True False O

A: Answer:False

Q: Q1- As we know, each a transmission line can have an equivalent circuit consisting of four elements…

A: Option-4 :CORRECT ANSWER The electric field confined between the two wires of the transmission line.…

Q: To test a diode using analog multi-meter, you should use what function? a. ohmmeter O b. ammeter c.…

A: Measuring resistance value using an analog multimeter you should select a range then ground be test…

Q: For the circuit shown in the Figure, if R1=8 , R2=6 Q, and C=0.2 F, and if i = A + Bet, answer the…

A: Fig: Given circuit  Although , It is given that voltage source is…

Q: 3) A 120-V, 50-Hz single phase induction motor (split -phase) has the following constants for the…

A: Single phase induction motor is not self starting motor The Resultant starting torque is zero To…

Q: The figure below shows a logic circuit and its incomplete truth table. Complete the below truth…

A:

Q: 12V 子 什トA 28 K2 14MA J=1A J=1 A 上4Ka 23 KL V= ?

A:

Q: A delta connected balanced load is connected to a 3 – phase, 400 V supply.  The line current is 35…

A:

Q: Q2/ Complete the following sentences: 1) If an A.C position is chosen of Input Coupling Selector in…

A: The oscilloscope is an instrument which can be used to monitor the electrical signals in a wire by…

Q: Q1) Prove the following relationship:

A: Here, we have to prove the relationship between magnetic susceptibility and magnetic permeability .

Q: 1: What are the main characteristics that a communication device can exhibit? Explain in a brief…

A: Communication devices are the part of communication system as the system includes all the hardware…

Q: Please solve it step by step:

A:

Q: Find, and I2 if the transmission parameters for the two-port in Figure below are 22 14/0° V [7] 10 2

A:

Q: 3. Two batteries, E1 = 6 V, 0.25 N, and ɛ, = 12 V, 0.5 N are connected series-opposing. An external…

A: a. Since the batteries are corrected in a series of opposing, the total voltage is,  ε1=6 Vr1=0.25…

Q: 9. Find V, for the circuit given below. 40 ka y ww 20 kQ v, = 6 V, v, =?

A:

Q: e condition for positive feedback is that the phase shift around the feedback loop must be D a. 90 O…

A: These are the few questions related to the understanding of significance of negative sign in the…

Q: Q1: which of these statements are True and which one is False? 3. The phase margin is the change in…

A: The open loop and closed loop system have a little difference i.e., closed loop system has and…

Q: Calculate the capacitance between surfaces r= 4 and r= 10 with dielectric of er=3 ? between these…

A: Given, Outer radius=rb=10Inner radius=ra=4εr=3Charge=Q=50Potential between two…

Q: H.W1// Determine and sketch: 1) x(t) * h(t) 2) x(t) * m(t) & 3) h(t) * m(t) x(t) h(t) 2 1 2 1 1 -1…

A: In this question,   We need to determine the output y(t) and sketch the output y(t).  We are solving…

Q: QI: Check the following statements and see which one is true and which one is false III. Time…

A: In time response system output of system is input vary with respect to a time this phenomena is…

Q: Q5: Consider the plant S - 2 | G(s) = %3D (s +3)(s2 + 2s + 17) 1. Sketch the approximate Bode plot…

A:

Q: The winding of a 3-phase, 6 pole, 60 cycle alternator has 2/3 pitch. What is the chording angle

A: Chording angle is defined as the angle by which pitch are shorted. A full pitch coil having zero…

Q: Determine the PF associated with a load: (a) consisting of a 6.25-µF capacitor in parallel with the…

A: In this question we need to find a power factor.

Q: Problem 4 Let XIf) be the input, and hlt) the impulse resPonse of an LTI system, where x(4)= 3 COs…

A:

Q: An op-amp has an open-loop gain of 80,000. Vsat = ±14 V. A differential voltage of 0.5 V p-p is…

A: 46 Given: The open loop gain is 80,000 Saturation voltage is 14 V The differential voltage is 0.5…

Q: Problem 4 Let X(f) be the input, and hit) the impulse response of an LTI system, where x(4)= 3 COS (…

A:

Q: 1. Solve a. RT total resistance b. IT total current c. PT total power d. Current in each resistor e.…

A: In this question we need to find a current and power in each resistor.

Q: the Finite State Machine (FSM) shown below, the value of D is 00000011 and the present state is W.…

A:

Q: _10. Determine the magnitude of the electric field intensity of an infinitely long, straight line…

A:

Q: R(s) E(s) C(s) G(s) H(s) Consider G(s) = K 4s-1 H(s) = %3D s2+2s+1 Find the Range of K for Stability…

A: The transfer function can be analysized by using RH criterion.

Q: R= 3302 R= 470 2 R, = 820 2 R = 680 2 R= 560 2 R = 1202 E;= 48 V R1 R2 R3 R4 R5 R6 TOTAL VOLTAGE…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.