Using the equation below, calculate the molar volume and compressibility factor for methanol vapor at 500K and 10 bar pressure. As a result of experimental studies, the virial coefficients are as followshas been found. B = -2.19 x 10-4 m3 / mol, C = -1.73 x 10-8 m6 / mol2 Answer the following questions at the critical temperature of methanol at 512.6 K, critical pressure 81 bar. a) Using virial equation, b) Using the Redlich-Kwong equation.

Q: A rectangular parallelepiped with a square base  d = 0.260 m  on a side and a height  h = 0.120 m  h...

A: Given, Length of the square base, d = 0.260 m Height, h = 0.120 m mass of the object, m =6.60 kg mas...

Q: Chemical Engineering Question

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want rem...

Q: II II Time, Time, Time, [A], M [A], M [A], M 1.00 1.00 1.00 0.75 0.50 0.80 0.67 25 0.78 25 25 50 0.6...

A: In chemical reaction engineering, the rate of reaction is defined as proportional to the increase in...

Q: A sample of 3 mol of Argon is put through the following cycle :        a. Express the kind of proces...

A:

Q: A waste contains 150 mg/L of copper at a steady state flow rate of 75 L/minute. Determine the amount...

A: Consider a waste stream flowing at steady state and containing copper in it. The copper in water is ...

Q: The glycerin at 25°C flows in a circular pipe with a 150 mm inside diameter. The average velocity of...

A: The flow pattern can be determined on the basis of Reynolds number.

Q: Chemical Engineering Question

A: 1) Given:Acetone from a waste gas is to be removed using an oil;Consider the below figure for the gi...

Q: CaCO3 precipitate is made by reacting CaO with an aqueous solution ofNa2CO3, the by-product being Na...

A: The given process can be shown as

Q: Q3) A filtration test was carried out on a sulfide concentration (s.g.=4) of 40% solid (w/w) using a...

A:

Q: Put the given

A: Molality of aqueous solution m = 0.575 M Boiling point elevation constant (Kb) = 0.512°c/m  

Q: The impact mill machine has been used for size reduction process. The crushed granites has been char...

A: Given: The cumulative mass distribution of the crushed granite particles at two different velocities...

Q: 9. For the reaction 2N2O5 → 4NO2 + O2, the rate is directly proportional to [N2O5]. At 45°C, 90% of ...

A: The value of the rate constant is to be determined.

Q: A pipeline carries petroleum at the rate of 795 m³/s from petroleum-well to the tank farther. The pr...

A: Given,  petroleum is goes well to tank at different pressure level.

Q: а. 1.00 L of 0.200 M NAOH from the concentrated commercial reagent [50% NaOH (w/w), sp gr 1.525]. b....

A: (a) Given, The volume of NaOH is 1.00 L Concentration of NaOH is 0.200 M   Calculate the moles of Na...

Q: Q// Upon completion of the Reynolds experiment, we had this information. The tube diameter was 0.03 ...

A: Given, Tube diameter,(d)=0.03 m Volumetric flow rate, V= 5×10-5 m3/s Temperature, T=26°C Density of ...

Q: 5- Liquid toluene is flowing through a pipe at a rate of 175 m3 /h. a. What is the mass flow rat...

A: The measurement of flow rates of the fluid can be done on the basis of either Mass, Volume, or Moles...

Q: Discuss the uses and economics and also manufacturing process of Acetylene

A: The uses, economics, and manufacturing process of acetylene is to be mentioned.

Q: Question 15 a Knet needs to be a number

A: Aluminum hydroxide is a base, so, it will dissolve in acidic medium.

Q: Compute the heat transfer through the air condition if the outside temperature is outside temperatur...

A: Given, The outside temperature, T0 = 5 °C The inside temperature, Ti = 20 °C length of the room, l =...

Q: What Risky-Safety Analysis is conducted during the siting of Filling/Gas Station

A: A filling station is a place where the petrol or the gas is stored, and fill the vehicles when neede...

Q: There is a drop in the bubble with the diameter of 10mm and pressure of 250 KN/m?. If the surface te...

A: In fluid mechanics, surface tension is defined as the property of the surface of a liquid allows it ...

Q: 5. A furnace is fired with fuel oil with a partial analysis of 7.6% S and 2.8% N. Orsat analysis of ...

A: Basis taken = 100 kgmol of stack gas (SG) Given that: Partial analysis: S= 7.6 % = 0.076 N= 2.8 % = ...

Q: 2. An aqueous solution has a specific gravity of 2.5 and contains 12mol% salt (MM=60) and 88mole %...

A: The molecular mass of the salt=60gram/mol The specific gravity of salt=2.5 or Density of salt ρs=2.5...

Q: production of paper from ground nutshell complete flow chart

A: In this question flow chart of production paper from ground nutshell is to be discussed.

Q: Q1) Water is pumped steadily from one large, open tank to another at the same elevation as shown in ...

A:

Q: Give at least 3 examples of under the Chemical Engineering Field that uses numerical analysis. Inclu...

A: To give 3 examples under the Chemical Engineering Field that uses numerical analysis which Includes ...

Q: Using the pressure steam table given

A: Given that saturated steam is used to heat Nitrogen from 0 to 100 C The process can be represented a...

Q: Compare the solubility of lead phosphate in each of the following aqueous solutions: Clear All 0.10 ...

A: Lead phosphate dissociates in water via the following reaction The common ion effect reduces the so...

Q: Q2) Consider the large tanks system shown in Figure Q2. Determine the level of water in tank 1, ha. ...

A: Diameter of pipe at the exit of tank A = 0.03 m Diameter of pipe at the exit of tank B = 0.05 m Leve...

Q: 1- In a steam boiler with a volume of 1.5 m³, has contains 750 kg of saturated water mixture at 1 MP...

A: The provided data of steam boiler is as follows: v=1.5 m3m=750 kgP=1 MPa

Q: 4) Synthesis of ammonia by the Haber process occurs by the reaction N2 + 3H2) 2NH3) Species AH (kJ m...

A:

Q: During a routine de-pressurisation of a gas storage system, 700 kg/hr of methane and 200 kg/hr of bu...

A:

Q: There is no table given X Your answer is incorrect. Water within a piston-cylinder assembly, Initial...

A: Given, State 1: Temperature, T1=750 °F Pressure, P1=10 lbf/in2 State 2: Temperature, T2=800°F Pressu...

Q: This is all part of the same question.

A: Note: Since we are entitled to answer only 3 subparts, we’ll answer the first three. Please resubmit...

Q: Chemical Data Submitted Corporation Cost of Chemical to Military 1.5 g of Y results in a 5°C rise in...

A: US military is going to hire that company which will provide them the chemicals at a price such that...

Q: 2) At 20 centigrade degree, half-life is 22.5 hour and in 40 centigrade degree, half-life is 1.5 hou...

A:

Q: Problem (Synthesis of Strawberry Jam) To make strawberry jam, strawberries containing 15 wt% solids ...

A: The answer is based on the material balance on the basis of given information.

Q: A 1.50 L reaction vessel contains a gaseous mixture of 2.1 mol NOCI, 0.52 mol NO, and 0.21 mol Cl2. ...

A: The direction of the reaction is to be determined for the equilibrium attainment.

Q: 8. Coal fired in a furnace analyzes 57.1%C, 8% ash, 1.4% N and 0.77% S. The Residue contains 24.5% C...

A:

Q: 5. Raw Sulfur containing 83% pure S is burned together with 80% excess air (Š to So, ), An analysis ...

A: Hi and thanks for the question. Since you have posted a question with multiple sub-parts, we will an...

Q: Please solve this two question

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want rem...

Q: From the given, calculate: 1. Heat gained by melt water 2. ∆Hfus  (show all calculations)

A: Heat gained by the melt water and enthalpy of fusion is to be calculated.

Q: The vapor pressure of a substance is given by the following equation. Calculate the molar heat of va...

A:

Q: Indicate two important microstructural characteristics for polymers that are considered for fibre pr...

A: • Unlike the natural fibres, the polymeric fibers are derived from the polymers. • Some of the examp...

Q: 100 g of F gas is stored in a cylinder in equilibrium with an external pressure of 1 atm and tempera...

A: Given: Mass of the gas, m = 100 g Pressure, P = 1 atm = 101325 Pa Temperature, T = 305 K Exothermic ...

Q: A heater is used to heat 150 SCM (standard cubic meter) of oxygen in a rigid vessel from 25oC and 1 ...

A:

Q: A water jet leaves a nozzle at a speed of 60 m/s and a flow rate of 120 kg/s. It is used to generate...

A: Given speed of water jet from the nozzle=60 m/s flow rate of water jet=120 kg/s To find The work gen...

Q: 5. A plant is burning limestone which analyzes 52% CaO, 41% CO, and 7% inerts using coke that analyz...

A:

Q: 6) СхНу + а(air) - bC02 + d H20 + (0. 375n – 0. 125)02 + 3.76a N2 If -0.8, the form of family fuel i...

A: In combustion, The equivalence ratio is defined as the ratio of the actual fuel/air ratio to the sto...

Q: Calculate the degree of ionization of morphine, pKa 8.0, in a solution with a pH of 2.2. Predict how...

A: Write the ionization of morphine as follows: C17H19NO3 + H2O → C17H20NO3+ + OH-   Given, pKa = 8.0 p...