Using the optional method for dwelling unit calculations, what\'s the dryer portion of a 60-unit multifamily building\'s demand load if there\'s a 4.50 kW dryer in each unit? a.25 kW b.55 kW c.65 kW d.75 kW

Q: vi+ 100 V 1 kQ 1.5 ΚΩ 2 H m 2 KQ For the initially uncharged circuit found in the right side, the…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: V1 R1 Assume the following: V1 = 58 V V2 = 94 V 11 = 24 A R1 93 Ohms R2 = 23 Ohms R3 = 41 Ohms V2 R2…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: With the load resistor R₁ removed, calculate the Thevenin equivalent voltage, VTHV, using the Node…

A: As per Bartleby guidelines, Only 1 question can be solved at a time, please send other questions…

Q: Electric field of the Earth is 100V/m is directed towards the center of the Earth. A charge of…

A: Given data, The electric field of earth is E = 100 V/m. Charge lifted is given q = 0.001 C. charge…

Q: Q3: A- A centrifugal fan has a circular inlet and outlet area of 0.15 m² respectively. the Static…

A:

Q: 9. The figure below shows a time-varying magnetic field that is perpendicular to the plane of a…

A:

Q: Use impedance matching to determine the gain transfer function of the input/output circuit shown…

A: Given that . Value of resistance is  R=100 Ω Value of capacitance is C=10 mF value of inductance is…

Q: for the given waveforms, the power factor is: V 0 O a. 0 Ob. unity langing 1-0 an p=VanR İs P

A: Given data:- Van : Voltage waveform iR : Current waveform

Q: The maximum overshoot for a unity feedback control system having its forward path transfer function…

A:

Q: n₁-2 ve n₂-20 2 ise transmission coefficient = ?

A: We need to find transmission coefficient for given impedance.

Q: Q2: Determine the maximum output voltage and 50% voltage and its time for 16-stage impulse generator…

A:

Q: 14 252 652 ΤΩ 4A

A:

Q: Determine the total rms current in the circuit below. What are the currents through L2 and L3? Vrms…

A:

Q: Find the state variable equations with output e exn W 10 {n} 41. 2F B 1₁ eee D {n}

A:

Q: A. A delta connected load is supplied from a 230V, 3 phase abc system. The load impedances are…

A: In this question We need to determine the current in the line of a .  Here assume abc phase…

Q: For the block diagram shown in Fig. 2, what is the bandwidth of the signal s(t), if a- ideal…

A:

Q: A conductor has an initial diameter of 0.175 inch and a resistance of 0.5 ohm. If the wire is drawn…

A:

Q: A point charge of +1 nC is placed in a space with a permitivity of 8.85 × 10-¹2 F/m as shown in Fig.…

A: Given- Point charge, q = 1 nC placed in a space. Permittivity, εo=8.85×10-12 Fm. Two points P and Q…

Q: QUESTION 1 In the circuit below, determine the currents /, and /2, respectively? 4A R₁ www 802 R₂.…

A: Given data, Total current, I=4 A.

Q: Problem 5 Find using the mutual inductance method and the T equivalent method. jΤΩ ΖΩ 8/30° V V. j4…

A: Problem 5: To find Vx (i)using mutual inductance method and (ii)T equivalent method:

Q: For the block diagram shown in Fig. 2, what is the bandwidth of the signal s(t), if a- ideal…

A: Given:  d=τT=0.333, T=1 ms, and A=2,Cn=Adsinnπdnπd,                n=0,±1,±2,.......

Q: Vs1 -12V R1 20 9 11 2A R2 40 Vs2 20V

A:

Q: In an over-current relay, if the current setting is set to 125%, connected to a current transformer…

A: Given data, In an overcurrent relay, Current setting is 125%. Transformer ratio is 400/5. And the…

Q: 3. A 5 kW, 120 volts compound generator has an armature resistance of 0.23 ohms, a series field…

A:

Q: 2. For a transistor of width 1μm, the la 20 μA and Cgs of 5 fF. Vth = 0.4V. Design the transistor…

A: Given- Transistor width  = 1 μm,Id=20 μA,Cgs=5 fF,Vth=0.4 V, Inductor = 200 pH, To Find- Design the…

Q: A 40-KVA, 3,300/240-V, 50 Hz, 1-phase transformer has 660 turns on the primary. Determine (a) the…

A: In this question We need to determine the unknown parameters.  We know V1 /V2 = N1 /N2   Apparent…

Q: 1 1. Let Ē=(x-2 jŷ)e¯¹²¸‚Ĥ = (2jx +ŷ)e¯¹² 377 (a) Find the time-averaged Poynting's vector . (b)…

A: It is Given that:  E→=x^-2jy^e-jz, H→=13772jx^+y^e-jz

Q: 110 1120 For the a 1. Find 2. Find VOL 3. Find IPL 3. Find Power System (P, Q, S). Ia A 60 146⁰ 110…

A:

Q: 8) Equiprobable binary symbols at a rate of 10 Mbits/sec are transmitted over AWGN with noise PSD N…

A:

Q: From t=0 tot = 3.46 min, a man stands still, and from t = 3.46 min to t = 6.92 min, he walks briskly…

A: It is given that:  Initial velocity u2 min=0 ms final velocity v5.46 min=2.09 mst2=5.46t1=2

Q: A pre-emphasis filter is a low-pass filter that is used to attenuate the amplitudes of the…

A: A pre-emphasis filter is a low-pass filter that is used to attenuate the amplitudes of the…

Q: Question 4 In an AC generator, the wire loops are called through magnetic and , they are connected…

A: Steam turbines, gas turbines, and combustion engines serve as the AC generator's input sources for…

Q: The inner and outer conductors of a coaxial cable have radii of 0.5 cm and 1 cm, respectively. The…

A: Given, coaxial cable have radii of 0.5 cm and 1 cmwith ϵr=1,μr=1 & σ=5.8×107S/m the outer…

Q: 6. 1- The below given circuit has Vs = 230V and R = 20 2. Find the value of the average output…

A: Given data, Vs= 230 v R = 20 Ω Firing angle of 45°    Explanation is given below in step 2

Q: In Fig., the potential difference between points P and Q is P 2A 252 m 10V 8Ω + 4Ω ww 692 Q

A: In this question We need to determine the potential difference between node P and Q.  We are solving…

Q: A discrete-time filter is designed with the following pole and zero locations: 2 Poles at Z=0,-0.4 3…

A: Recursive Causal Non-Linear Phase Stable Low-Pass Filter

Q: A load Z₁ = 54+j 59 [0] absorbs 82 [VA] of power. Hence, the absorbed average power P [W] equals:…

A: Given data, Apparent power S=82 VA. Impedance ZL=54+j59 Ω.

Q: Find the z transform and its ROC of the following n n x(n) = (-¹)″ u(n) + (¹²)” u(−n − 1) a.

A: In this question We need to determine the Z transform and ROC of the given signals  we know u(n) = 1…

Q: A 10-kVA, 1-phase transformer has a turn ratio of 300/23. The primary is connected to a 1500-V, 60…

A:

Q: If you were to ask me, what is a Voltage Event Recorder?

A: We need to tell about voltage event recorder .

Q: V1 M Ix 252 M For the circuit shown above, find the value of Vo given that V1 = 23 V. 4 Ix 5Ω M + I

A: Given the circuit. The value of the voltage source is 23 V

Q: Q4. The electric field intensity of a plane wave propagating in a medium is given by: E = 10e ax…

A:

Q: 3. Write an expression that is a 1 when one or more of its variables (A, B, and C) are Os.

A: Given data 3. Three input variables are A, B, and C.  We need to find out the expression such that…

Q: Find the current

A:

Q: R₁ 60 Iss D² 2A b Isz 3A R₂ 30 9 R₂ ww 602 C Vs -10V d

A: The given problem is from circuits.  The problem can be solved by using nodal analysis.  The…

Q: 2. The permittivity of the Earth's ionosphere can be described by an unmagnetized cold plasma model:…

A:

Q: V1 2 ΚΩ ΜΕ 6 ΚΩ 4 ΚΩ 2 ΚΩ www Μ 6 ΚΩ 4 ΚΩ For the circuit shown above, find the value of io using…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Determine the required peak reverse voltage rating in the following circuit. R₁ 1 ΚΩ www Vs 200 Vpk…

A:

Q: Find the Vth of the given circuit that is external to R2

A:

Q: Problem1. Find vo in the circuit below, using nodal analysis. 30 V + 10 Ω R₁ M Ix 2Ω 1Ω m 4 Ix 5Ω…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.