V + R2 R1 www R3 R23

Q: angular waveguide has a dimension of 3cm by 2 cm is used

A:

Q: Mr. Wahid needs to transmit a digital signal (data) to Mr. Alice through internet. Mr. Wahid has con...

A: Phase shift key: It is the digital modulating technique that carries the data by changing the phase.

Q: 3 Series Diode Configurations 5. Determine the current I for each of the configurations of Fig. 155 ...

A: Since you have posted the multiple questions so we are supposed to answer first one.

Q: Prove that the frequency of the rotor induced emf in an induction motor is slip times its stator sup...

A:

Q: Explain the basic principle of IP (induced polarization)! (b) the mechanism for the occurrence of th...

A: We have given the following problem a) Explain the basic principle of IP (induced polarization)! (b)...

Q: t + 3 -3くt<-1 f(t) = {t+1 - 1<t < 2 f(t + 5)

A:

Q: Why it should be used in both sides (transmitter and receiver) in the radar system.

A: Radars- Radars have very large wave length. Since radio waves can have very length and also the inte...

Q: Find the Transfer Function Y(s)/X(s) of the following network. H3 H2 L2 L1 G3 G4 Y(s) Gg. Y(S) R(s) ...

A:

Q: Find the impulse response corresponding to this transfer function. 2.0 1.5 1.0 h(t) 0.5 -0.5 1 2 3 4...

A:

Q: The maximum value of 50 Hz an AC voltage is 100 V. Its value after 1/300 second will be O a. 66.8 V ...

A: Given: The maximum value of ac voltage, Vm=100 V Frequency, f = 50 Hz Time, t = 1300 sec

Q: Find the transfer function x2/F and x1F. Where,  K= 2, K2=2 , K3= 1+c fv1=1/2, fv2= 2+b, fv3= 3 ...

A:

Q: A rectangular waveguide has a dimension of (3X2) cm is used to transmit a signal of 9 GHz. Determine...

A: Given: A rectangular wave-guide used in dominant mode. Dimensions, a=3 cm and b=2 cm Frequency, f=9 ...

Q: Determine the total resistance across ab. R a R R R R. R. R b. R.

A:

Q: IGI (dB) -20 dB/decade O dB - 20 dB/decade -40DB / decade 1 10 80 1000 w (rad/s)

A: This is problem of calculation of transfer function from bode plot. The solution is given below

Q: a power factor of 0.45 lagging?

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: A 1,000-kVA, 12.47-kV-480Y/277-V transformer with 4% impedance feeds a 480-V bus. The fault duty of ...

A:

Q: A 5 OH MS RESISTOR IN SERIES WITH AN INDUCTOR HAVING ANINDUCTANCE OF L= 15,92 MILLI HENRY IS CONNECT...

A:

Q: 10.31 a) Find the average power dissipated in the line in Fig. PI0.31. b) Find the capacitive reacta...

A:

Q: Discuss the advantages of parallel hybrid system with series hybrid system

A: Power-split hybrids, also known as series-parallel hybrids, are parallel hybrids with power-split de...

Q: 1. Calculate the voltage output by the secondary winding of a transformer if the primary voltage is ...

A:

Q: Specify the unit vector extending from the origin toward the point G(2, −2, −1). NOTE: Final Answer ...

A: We have given the following problem Specify the unit vector extending from the origin toward the poi...

Q: Reduce the block diagram shown in the Figure below, and find the transfer junction C(s)/R(s). G4 R(s...

A:

Q: 2 Load-Line Analysis 1. a. Using the characteristics of Fig. 152b, determine Ip, Vp, and Vg for the ...

A:

Q: 3-phase, 3km long line delivers 3000kW at a power factor of 0.8 lagging to a load. If the voltage at...

A: Short transmission line An effective length less than 80km is known as a short transmission line. It...

Q: A semiconductor is doped with ND >> ni and has a resistance of R1. The semiconductor is doped with a...

A: The resistance of the semiconductor doped with ND is R1. The resistance of the semiconductor doped w...

Q: Solve for current through r2 resistor using source transformation. Thank you in advance

A:

Q: Vab = 220 angle 20 deg. Z-delta = 20 + 10j ohms Assuming positive sequence Van A LAB Von B Isc CA Ve...

A: The solution is given below

Q: 0,(s) Find the transfer function G(s) fc T(s) %3D

A:

Q: 2. If Z,(s) is the impedance of 10 µF capacitor and Z,(S) is the impedance of 10ok2 resistor, find G...

A:

Q: Si Ge 2. VR and Ip + + E 5V 1.2K2 VR (a) +

A:

Q: 7-28 An FM detector is designed to operate at a center fre- quency of 90 MHz, and it has a detector ...

A:

Q: A given wire has a resistance of 20 ohms. If its length is 300m, how much length must cut-off from t...

A:

Q: Given A = 5ax + 10az and B = 3ay + 4az, find the projection of A on B? %3D %3D

A:

Q: X1(s) X2(s) Q2. Obtain the transfer functions F1 (s) and F2(S) for the system shown below. F2(1) X2 ...

A:

Q: Consider the Z-transform of the impulse response h(n) shown from the figure below. If we define y(n)...

A: SOLUTION:- 1)           Hz =0.2251-z-21+0.39z-2-0.16z-4              Hz =0.225z2-1z2z4+0.39z2-0.16  ...

Q: Find the unit vector directed from (3, -7, 6) toward (4, 6. -12).

A:

Q: Given: H (A,B,C,D) = B'D +A'D +BD. Write the simplified product of maxterm expression

A:

Q: An AC bridge circuit is in equilibrium at a frequency of 2000H2 with the following components: Find ...

A:

Q: 2,4 kfl 40 mAt)2.7k13 33 kng C0.5 uF The switch in the circuit of Fig. p7.22 has been in the positio...

A:

Q: For the OP-Amp circuit below: a) Derive the transfer function, T(s). b) Calculate the magnitude of t...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: 16. DETAILS PREVIOUS ANSWERS The magnetic field 43.0 cm away from a long, straight wire carrying cur...

A: The magnetic field is the zone in which the force of magnetism acts around a magnetic material or a ...

Q: Oatain the selution

A:

Q: +15V R4 560 Q R1 1ka R3 9100 VZR: 3V R2 3 2ka - 8V

A: The solution is given below. 

Q: Convert 100 Hp into its equivalent Watts.

A: In this case, 100 Hp of power is to be converted into its equivalent watts. 

Q: Derive the condition for maximum torque of an induction motor and hence obtain the expression of max...

A:

Q: 1. Consider the FIR filter with real coefficients given by N-1 H(2) = E h(n)z". n=0 (a) Under what c...

A: FIR filter- This type of filter which settles to zero in the finite time range whose impulse respons...

Q: 1. A wire used for wiring electric ranges, hot water heaters, stoves and hairdryers where both heat ...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: V3 + iz 50 Ω 30 N 202 + 45 N 100 V 0,2v3 5i2 0,02v1

A:

Q: 15. A solenoid coil with a resistance of 50 ohms and an inductance of 250mH is connected to a 220Vpk...

A:

Q: Find the output of h(t) = 8(t) + S. x(t) = e-ltl.

A: Laplace transform- It is an transform that which is integral transform and this represents a functio...

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.