V1 12 Vs SINE (1 0.05 5000k 0) Vin Cbp HH 0.1µ U1 LM358 -Vo

Q: A star connected alternator supplies a delta connected load. The impedance of the load branch is (8…

A: Given data:Required information:

Q: 3.2 Given vectors A = x2 - ŷ3 + 2, B = x2 − ŷ + 23, and C = x4 +ŷ2-22, show that C is perpendicular…

A: The vectors,

Q: Q13) Plot the amplitude spectrum of the sampled signal X, (f) in the previous question with sampling…

A:

Q: Draw the structure of ionosphere and explain the mechanism of ionosphere propagation.

A: The ionosphere is a region of Earth's upper atmosphere, extending from about 30 miles (48…

Q: For the input voltage vi(t) = 10sin(3000t), calculate vo(t) via Laplace transform.

A: Given:A circuit, with . we need to find:Output  using Laplace transform.

Q: A microwave oven cooks food by irradiating the food with microwave power generated by a magnetron.…

A: tan δc=0.35Operating frequency = 2.45∗109 HzFind: -The average power per cubic meter.

Q: A hot plate is fitted with low, medium, and high settings. The element consists of; two sections…

A: The supply voltage, The power output at high setting,

Q: 1. What is the value of the duty cycle in A? 2.What is the quantization noise in a modulator that…

A: Given:Multiple pulse modulated signals for the signal that is given by the dashed line sinusoidal…

Q: With neat diagram design the 5 element Yagi-Uda antenna for the receiving 100MHz radio signal…

A: According to the question, we need to design 5 elements Yagi-Uda antenna.

Q: A solid non-magnetic conductor of circular cross section has its axis on z-axis and carries a…

A: Given data:Required information:The magnetic flux density at

Q: A single phase inductive load draws 10 MW at 0.6 power factor lagging. What is the value of the…

A: Given data:Required information:

Q: h[n] =(1/4)^n u[n]     For a system given as x[n] = 3 cos((π/2)n)u[n] input sign Find the output…

A: Given:Impulse response of the system, h[n] =(1/4)^n u[n], Input signal x[n] = 3 cos((π/2)n)u[n]To…

Q: What is the unit of real power? a.V-ohmb.VAc. V/ohmd. none of these

A: The objective of the question is to identify the correct unit of real power in electrical…

Q: ble √752 + (172.79 127.32)² = 87.700 230 87.70372107 Ai) z = Aii) = == Av) f = = Aiii) P = 2.62x230…

A: This question is Ac analysis

Q: A three-phase balanced star-connected

A:

Q: Question 2: Do as required: A) (100110)2 = (?)10 B) (38)10 (?)16 C) (26)16 (?)10 = = (11000)2 = (?)…

A: In the given questions we need to solve the following number system problem.

Q: Q4: Answer the following questions: 1-A single-phase 100 kVA, 600V, 50 Hz alternator has effective…

A: Note: “Since you have posted multiple questions, we will provide the solution only to the first…

Q: Using Mesh analysis, the mesh equation for the supermesh (1-2) in the circuit shown below. Given…

A:

Q: If a 3-phase, 2-pole, 11 kV, 10 MVA synchronous generator has current balance protection which…

A: Rating of synchronous generatorwe have to find% of the winding protected protected from earth fault…

Q: 0 0 O 0 0.2 0.2 0.2 0.4 0.4 0.4 Q16) What is the sampling frequency? 0.6 0.6 Q15) What is the…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: NMOS Inverter Circuit Analysis 5V svg 2.2k Calculate the values of vo for v=0, 2.5, and 5 V. Use…

A: A MOSFET, or Metal-Oxide-Semiconductor Field-Effect Transistor, is a type of transistor used for…

Q: For the following design, write Verilog code to describe it. Write testbench program to test the…

A:

Q: isnt Transformer ration V1 / V2 i see the opposite is here V2 / V1

A: Asked to explain the previously solved answer the transformer ratio.

Q: a. Explain with the aid of diagrams, the operation of the circuit with the switch first in position…

A: In the given questions we need to calculate the time required to current drop to its 20 % of initial…

Q: 3. A source of information produces equaiprobable blocks of 4-bits. The encoder circuit adds an even…

A: The input-output relationship of an encoder circuit is represented by an encoder table. This makes…

Q: The OLTF of a system is 30,000 G(s) = s¹+67s³+1017s² +8637s+13725* What is the phase crossover…

A: The OLTF of a system is shown below..

Q: A pulse width modulation (PWM) system uses a carrier frequency of 1 kHz and encodes 1s and 0s by…

A: A pulse width modulation (PWM) system uses a carrier frequency of fc=1 kHz and encodes 1s and 0s by…

Q: connected three-phase generator connected through a three phase transmission line to a Y-connected…

A: Supply voltage Vs = 415 V (line)We have to find active power supplied by generatorpower factor of…

Q: An 60 Hz, three-phase induction motor has 2 poles and a rotor resistance of 0.19 per phase and runs…

A: Given diagram,No of poles P = 2Frequency f = 60 HzRotor resistance R = 0.19 ohm,Full load speed =…

Q: Q1\ convert the following numbers to indicated system:- 1- (122.24) 10 > (?)8 2- (E2.81AC) 16- > (?)…

A: In the given questions we need to calculate the octal and decimal equivalent.

Q: 1.) Aşağıdaki devrede eşdeğer endtiktans değerini inductance value (LT) in the circuit below)

A:

Q: simplify the following equation using Boolean algebra. 1) X = A.B.C. Ó + A.B.C.D + A.B.C.D+A.B.C.D +…

A:

Q: In a system, there are two generators operating in parallel. One generator, of rating 250 MVA, has…

A: Given data:Required information:

Q: Q.2) A) For the sinusoidal signal m(t) 2 sin(2000xt+ 0.055x), shown down, is sampled, quantized and…

A: "Since you have posted multiple questions with multiple sub parts, we will provide the solution only…

Q: Consider the circuit in figure 1. a: Find Thevenin equivalent circuit with the respect to terminals…

A: Given:A circuit, we need to find:a) Thevenin equivalent circuit with respect to terminals a-b. b)…

Q: A loaded Zener regulator shown in figure has: Vzv 6.3 + IZTMA IZK MA IZMmA Zz, 40 3 65 8 (a)…

A: Given data :Given circuit,Asked to determine,The minimum permissible load resistanceThe maximum…

Q: 1B. A 4 kVA, 200/400 V, 50 Hz, single-phase transformer gave the following test figures: No load…

A: open circuit test (LV side)200V0.7 A70 Wopen circuit test (LV side)15 V10 A80 WAsked to find the…

Q: 2. In the circuit, the resistor is adjusted for critical damping. The initial capacitor voltage is…

A: A capacitor is an electronic component that stores electrical energy in an electric field. It…

Q: 1. Verify (KCL and (KVL). 2. Comment on results. 3. Find I1, I2, I3. 3 V 10ar b -20 V g h 2202 4V…

A: The circuit diagram,

Q: Tow resistors (R₁, R2) are connect in parallel, prove that R₁ R2 R₁ = R₁ + R₂

A: In the given questions we need to calculate the equivalent resistance.

Q: Design a CMOS transistor network that implement the functionality of the following logic function: F…

A: CMOS stands for complementary metal oxide semiconductor devices. CMOS transistor uses both NMOS and…

Q: Write a Scilab/Matlab function called dBm. The argument should be a power level in watts, an the…

A: It is asked to a MATLAB function called dBm. The argument should be a power level in watts, and the…

Q: *(e) A (B x C) * (f) Ax (B x C) (g) x x B (h) (A x ŷ) 2

A: The vectors,

Q: 6-2. A 480-V, 60 Hz 400-hp, 0.8-PF-leading, six-pole, A-connected synchronous motor has a…

A: A 480-V, 60 Hz 400-hp, 0.8-PF-leading, six-pole, A-connected synchronous motor has a synchronous…

Q: 2) LOMA 1.6 H m tro disw > 20kn SAF After being open for a long time, the switch in the circuit is…

A: The given circuit isThe switch is open for a long time before it has been closed at t = 0.We need to…

Q: 4. Find the branch current analy R₁ loon E," IS V E R₁220 E₁20V 41. R: 580 -25

A: we have to findcurrent I1 and I2

Q: 8) Draw the circuit diagram of logic function Y=(AB+CD) using both combinational Gates and…

A:

Q: Q20) Give a plot that represents an ASK modulation of the sequence of bits (101010000111) using…

A:

Q: The diagram below shows an inductive circuit. OF V1 12V R2 500 R1 100 Inductor 470mH a. Explain with…

A: In the given questions we need to solve the part a, b and c.

Q: (3-31) Let the signal y(t) = 5[1 + 0.8 cos(272500t)] cos (2104t) be applied as an input to the…

A: Given:A system, with, we need to determine: the system output Z.

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.