VCE B=80 16 V 3.9 kN Ice 62 kn oVC +. B = 80

Q: Q2) A lossless transmission line is terminated with a 752 load. If SWR on the line is 1.5, fined the...

A: We need to find out load resistance for given standing wave ratio .

Q: H.W1 Prove that: D, 12 t1 €2

A:

Q: armature winding of a 200-V, 4-pole, series motor is lap-connected. There are 280 slots and each slo...

A: We need to find out speed for given motor   

Q: A 3-phase transmission line having a capacity of 10,000KVA serves as a balanced load that draws 5,00...

A:

Q: G6 GA C(s) G3 G2 6 G1 R(s) 1 G7 G8 G9

A:

Q: Given the Boolean expression: AB'C + A'B'C' + ABC + A'BC' = X, identify the incorrect part of the ci...

A: Given Boolean Expression X = AB'C + A'B'C' + ABC + A'BC' 

Q: A certain current lags the voltage by 36 electrical degrees. The voltage waveform is increasing posi...

A:

Q: i. For the circuit shown in Figure B5i, calculate the output voltage Vout- current I, flowing throug...

A:

Q: 1. For the diode circuit shown in Figure C1, assume the Turn-On voltage of LED1 is 2.0V and LED2 is ...

A:

Q: diode structure shown below. The diode has the following properties. P doping =1x1018cm•³ N doping =...

A:

Q: 18.) Determine the effective resistance between points A and B in the given network below. Express i...

A:

Q: Design a 3 bit Binary Adder Subtractor and explain it with the help of an example.

A: Binary Adder and subtractor-  It is a combination of 4 full adder. It is available for the both oper...

Q: [5] The conductor becomes incandescent due to * the thermal effect of the current. the chemical effe...

A: Option A  Thermal effect of electric current The meaning of incandescent is to give out light becaus...

Q: Q2) Design a quarter-wave transformer to match a 100 load with a transmission line with a characteri...

A: We need to design quarter wavelength transformer to match given line .

Q: Derive the truth table for a majority function which is generated in a combinational circuit when th...

A: The answer for the following questions are

Q: Find Norton equivalent circuit: 20 300 2 4 2 42 6 V 40 2V

A:

Q: Calculate the: (a)fLs, fLG, and fLc

A:

Q: A signal, x(t) is described by : X(t) = rect(1000t)*S0.002(t) X(t) is the input of an ideal lowpass ...

A:

Q: the following Boolean expression F (A, B, C D) = B' +C'D + A'BD' using NAND gates ONLY. Note that co...

A:

Q: [21] To reduce the resistance of a conductor, its temperature should be * increased decreased not en...

A:

Q: [11] Insulators have valence electrons. two three O four O None of the above

A: Insulator are those who has no free electrons to roam or share with neighbouring atoms electrons

Q: The primary winding of a transformer has 2000 turns. If this transformer is to be used for changing ...

A:

Q: 9. What would be the complement of the following : (a) A (BC + BC) (b) xy + yz + z ? 10. Find the co...

A: Boolean expression-A Boolean expression is the expression that evaluates to either TRUE or FALSE i.e...

Q: In Figure Ro represents the resistance of the door knob on each of the 4 doors in the room. R, = 500...

A: Wheat stone bridge is an arrangement of 4 resistor in a balanced condition. This arrangement helps i...

Q: The message signal m(t) = a cos(2rf t)is used to either FM or PM for the carrier A cos(27f t). Find ...

A:

Q: A power transformer rated 8MVA, 34.5 kV/230 V is connected delta-delta.What is the phase current of ...

A: The solution is given below 

Q: Use k-map method to derive the simplified SOP expression for the function L(V,W,X,Y,Z)=summation of ...

A: Kamp-Kamp / Karnaugh maps are Boolean algebra simplification techniques. Using maps expressions can ...

Q: When a dielectric plate is inserted into a uniform electric field, the electric field in the dielect...

A: When a dielectric plate is inserted into a uniform electric field the dielectric plates polarized an...

Q: Solve the following system by any method 211 - 2 + 313 + 514 = 21 h - 213 + I4 = -1 5/ - 512 + 13 + ...

A: This question belongs to basic electrical . It is about solving equations and calculate unknown vari...

Q: 7/ A delayed half-wave rectified sine wave has an average value of 0.25 of the maximum value as show...

A: From given waveform write the expression for y(t). Now using average value integral calculate angle ...

Q: resistance R to maintain a voltage of 7.2 V across the voltage is constant at 12V and the minimum ze...

A:

Q: Example Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine a...

A: I am answering three subparts of this question as per guidelines.

Q: y(t) = 50sin(200t + q) ? (w = 2TTF ) 1. How many frequencies make up the signal 2. What is the frequ...

A:

Q: Please show the neat solution. Thank you. Draw a sinusoidal voltage waveform with peak value of 200...

A: In this question.  We know Peak value of 200 volts An instantaneous value of 100 volts at t= 1 milli...

Q: a) Using the nodal analysis, determine the current across each element b) Using the mesh analysis, d...

A: We need to find out the current through resistor.

Q: A CT of nominal ratio 1000/5 A is operating with total secondary impedance 0.4+j0.3 N. (1 At rated c...

A:

Q: Determine Vo for the configuration of Fig. 167.

A: Voltage across the germanium diode when it is on is 0.2 volts  And voltage across the silicon diode ...

Q: (2) A certain alternating voltage is described by the equation : v = 170 sin 628 t volts = Vp sin w ...

A: This question belongs to circuit theory . It is based on the analysis of sinusoidal a.c. voltage . I...

Q: 24.) Using Thevenin's Theorem, determine the equivalent resistance as viewed through the terminals B...

A:

Q: Design an op-amp circuit to yield the relationship shown in each equation. Vo = 8A + 8B – 3C – 12D ...

A: Op-Amp is a device or integrated circuit which is used to amplify the two input voltage difference.

Q: p 12 V 3 k2 470 k2 10 μ 20 µF B = 100 R, + 0.3 kΩ + Z, RL 4.7 k2

A: We need to find voltage gain and current gain for given circuit

Q: Vhat is the CMRR of the circuit? 50v 50v 1 1500v 2000v 30v

A:

Q: R(1) K( + 3) (s+ 4) (++ 1) (s + 2)

A: The given block-diagram is shown below:

Q: Use superposition to obtain v, in the circuit of Fig. 4.85. Check your result using PSpice or IL Mul...

A:

Q: Given three impedance Z1=10 +j0 Z2 =3+j4 and z3=8-j6. Impedance z2 and Z3 are connected in parallel ...

A: If two impedances Z1,Z2 are connected in series than equivalent impedance is Z1 +Z2.  If two impedan...

Q: Solve the following system by any method 211 - 12 + 313 + 514 = 21 1 - 213 + I4 = -1 51 - 512 + 13 +...

A: This problem comes under basic electrical. It is about calculation of unknown variable by using give...

Q: Problem 2 (Problem 2.12-1 from the textbook) 0 1 x(k +1) =0 3 >(4) = | -2 1 |=(*) (a)Find the transf...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 3. In the circuit shown in figure below, the resistance R is random and uniformly distributed betwee...

A: The circuit shows a voltage source which provide supply to the constant resistance and R in form of ...

Q: Rg = 330 kn Rc = 1.5 k2 Cin Bdc = 150 Cout R = 1.5 kN Vin = 50 mVeP

A:

Q: series circuit composed of a 0.20 henry inductor and a 74microFarad Capacitor is connected to a 60 V...

A: For the given circuit we have to find the value of frequency 

Thermocouple

A thermocouple is a temperature measurement device. It includes diverse metal wires which are joined collectively to form a joint. At the same time as the junction is hot or cold, a small voltage is generated inside the measuring thermocouple electrical circuit, which corresponds to the temperature.