VLAN A Prefix Size: 19 VLAN B Network Mask 255.0.0.0

Q: In Packet Tracer, name the type of connection cable found in the connections group that can be used…

A: Answer- b. Coaxial Cable. This kind of cable is mainly adopted in feedlines connecting radio…

Q: Virtual circuit network is combination of Packet-switched network & physical link Two…

A: Answering first question as per the guidelines. The problem is based on the basics of networking.

Q: ________ multiple access technique is used by IEEE 802.11 standard for wireless LAN.

A: While doing programming in any programming language, you need to use various variables to store…

Q: Describe the problems found in wireless networking with regards to a station that is hidden and the…

A: The hidden station problem happens when multiple or more channels that are out of range of each…

Q: Convert IP Address to Binary   12.101.9.16

A: 12.101.9.16 IP Address to Binary

Q: A cable connector characteristics are defined on the O a transport layer O b. data link layer O c.…

A: Cable Connector : A cable connector is a metallic conductor that is used to connect the mainline of…

Q: What are Label Switching Routers?

A: Label Switching Routers, are basically routers that support the MPLS i.e. (Multiprotocol Label…

Q: a networking device that regenerate analog or digital signals distorted by transmission * .loss due…

A: Here in this question we have asked that a networking device that regenerate the analog signal…

Q: e subnet mask is used e -------or on a -- me default subnet mask for network 192.168. 1.0 is WXZ

A: Given :

Q: A network has a data transmission bandwidth of 20 × 106 bits per second. It uses CSMA/CD in the MAC…

A: Introduction :Given ,CSMA/CDnetwork bandwidth =  20 × 106 bits per secondPropagation time = 40…

Q: Packet switching is more appropriate for mobile networks than circuit switching.

A: Inauguration: Appropriate for mobile networks rather than circuit switchingTraditional telephone…

Q: What is the range of IP address and directed broadcast address for the subnet 219.7.9.72

A: The Answer is in Below Steps

Q: Give description of network layer packet.

A: Given:   Give description of network layer packet.

Q: Determine the communication method used in a wireless local area network.

A: communication method used in a wireless local area network are given below :

Q: A call is placed from an IP Phone and routed over a T1 circuit to the PSTN. A valid port identifier…

A: Lets see the solution.

Q: A thin UTP cable has higher attenuation than a thicker UTP cable. Select one: O True O False

A: In step 2, you will get the answer

Q: Describe packet loss at input ports and how it might be eliminated.

A: To be determine: Brief about Packet loss at input ports and how it might be eliminated

Q: List six access technologies. Classify each one as home access, enterprise access or wide-area…

A: The six access technologies are as follows: Digital Subscriber Line (DSL) instead of a traditional…

Q: is a protocol that is used in communication networks to boost the line's

A: Please find the answer below :

Q: Virtual circuit network is combination of None Circuit switched network & datagram network Two…

A: Step 1  The answer is given in the below step

Q: ARP is used by: Select one: O a. network layer O b. application layer O c. data link layer O d. none…

A: GIVEN:

Q: odem; IEEE 802.llx/Wifi wireless networks; mobile 3G/LTE Internet access technologies; DOCSIS…

A: network access protocol and physical medium (e.g. 10BaseT or 100BaseTx Twisted pair, 100BaseFx…

Q: collision transmits generation LAN are C respectiv the first s five static

A:

Q: What is the smallest acceptable ethernet frame size?

A: Ethernet is the popular technology which are used for connecting device using wire in a local area…

Q: . A certain data packet contains a total of 20 bits of which 16 are data bits. Determine the…

A: To calculate the efficiency : Efficiency = ((Total transmitted - retransmitted)/Total transmitted) *…

Q: Distinguish between wireless local area networks (WLANs) and their wired counterparts (WMANs).

A: Wireless metropolitan: Area networks have been used to construct wireless connectivity between…

Q: As frequency increases in data transmission on physical layer, the period ________. a. decreases b.…

A: This question comes from data transmission on physical layer.

Q: Layer 1 of the OSI model. This layer is concerned with the transmission of bits on a network.…

A: Note:There are multiple questions are given in one question. According to the rule, you will get the…

Q: Explain the architecture of IEEE 802.11 Wireless LAN. Briefly explain the various variants and…

A: IEEE 802.11 WLAN : used for computer communication in the 900 MHz with maximum of 60 GHz frequency…

Q: Since all 802.11 wireless technologies have distance limitations, a _____ can amplify the signal and…

A: The IEEE designation for wireless networking is 802.11. The 802.11 standard encompasses a number of…

Q: No. Protocol Layer The process to process delivery of the entire message is the responsibility of…

A: Question given:  Some OSI layer's protocols or works are given. Assign the appropriate OSI layer for…

Q: Calculate the physicals address if CS = 1405h and IP = 1204h * %3D %3D

A: Answer: Physical Address of CS = Seg add of CS * 10h + offset add = 1405h * 10h + 1204h =15254h

Q: "Data Plane" of a Router - what is it? What may it be used for?

A: Given: "Data Plane" of a Router - what is it? What may it be used for?

Q: A protocol called RTP (Real-time Transport Protocol) enables real-time data transmission and…

A:

Q: Please select the protocol which can work in data link layer. RTP UDP O ICMP DSL

A: RTP: The Real-time Transport Protocol is a network protocol for delivering audio and video over IP…

Q: It is a 6.312-Mbps service, where it can be used as a single service for 6.312-Mbps transmissions or…

A: In Telecommunications, We have M12 Multiplexing in that we take low level digital signal built it up…

Q: packet switching is implemented on the O a physical layer O b. data link or network layers c. data…

A: 1) packet switching is implemented in network layer

Q: TDM and FDM are used in packet switching in order to allocate the users different frequencies and…

A: TDM and FDM are used in packet switching in order to allocate the users different frequencies and…

Q: Transmissions can be secured by expanding the bandwidth of a channel and adding redundancy, this…

A: The Forward Error Correction is a method of adding redundant data to a signal to make it secure and…

Q: Packet switching networks: a) Are very slow, often taking up to 24 hours to send a message  b) Use…

A: Packet switching network: Packet switching is a process by which information is first divided into…

Q: 802.11's frequency hopping spread spectrum variation includes a dwell period in the beacon frames.…

A: your question is about Is the dwell time included in Bluetooth's comparable beacon frames? let's see…

Q: half the data (50MB each). What IPC mechanism will you use and why?

A: In this approach, shared memory is best to use because in other IPC's we have restriction/limits on…

Q: VolP (Voice over Internet Protocol) is a technology that uses the Internet to communicate.

A: Introduction: VoIP, often known as IP telephony, is a technique and collection of technologies for…

Q: MC2: Please select the protocol which can work in data link layer. DSL UDP RTP ICMP

A: UDP operates at Layer 4 - Transport layer RTP - Transport layer ICMP - Network layer protocol DSL -…

Q: The coaxial cable has a bandwidth that ranges from a. 5- 750MHz b. 10-300 MHz c. 5-550 MHz d.…

A: The coaxial cable has a bandwidth that ranges from a. 5- 750MHz b. 10-300 MHz c. 5-550 MHz d.…

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.