Voltage = 120 resistance =30 and Cap reactance =40 what is the current at the power source

Q: Determine the total resistance of network in Figure 300 N 200 N

A: The solution can be achieved as follows.

Q: 6. The filament of a 240 V metal filament lamp is to be connected from a wire having a diameter of…

A:

Q: A point at which two or more elements have a common connection is called Select one: a. A contact…

A: Given :   In the question they have mentioned a statement and they want to know the the meaning of…

Q: Correct me if i am wrong I have studied different formula formula for saturation current.

A: Both are correct.

Q: In the circuit show in Figure 3, at the temperature of room increase what happen to the resistance…

A: Given: Circuit

Q: -Apotential difference of 2Vismaintained across a 80 resistor fora period of 22s. What total charge…

A:

Q: it is the ratio of measured voltage to the measured current of an electrical load circuit. A.…

A: ratio of measured voltage to the measured current of an electrical load circuit is called as a…

Q: Q1. A series voltage regulator with constant-current limiting is shown in Figure 1. a) Determine the…

A: Given:A series voltage regulator Circuit is:

Q: A. Using long coupon bond(s), make a written discussion of what you learned in this lesson. Your…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Short answer: Ohm’s law is not exclusively for electrical circuits. Explain what ohm’s law is in…

A: According to Ohm's law "The voltage across the given conductor is directly proportional to the…

Q: 3.12 A carbon brush used to conduct current from the commutator of a DC generator has a length of 4…

A: In the question,  Find the cross sectional area of carbon brush.  If current flow = 400A Voltage not…

Q: Collector current is 3.06 mA  Find Vz ?

A: The relation between the collector and base current is: IC=βIB3.06=200*IBIB=15.3μA And, the base to…

Q: What is the voltage at Vout (in V)? Answer tolerance is 5%.

A: Given: Diode voltage =1 V                    R1=6.3 kΩR2=7.2 kΩR3=6.5 kΩR4=4.2 kΩR5=2.1 kΩR6=2.4 kΩ…

Q: resistance R to maintain a voltage of 7.2 V across the voltage is constant at 12V and the minimum…

A:

Q: What is the voltage will produce 3A through a circuit that has 15ohms of resistance?

A: We need to tell about voltage .

Q: What is the thermal voltage equal to at T 400K? 25mV 25.9mV 34.5mV 40.2mV

A: We have to find the thermal voltage at 400K. as we know Thermal Voltage = k.Tqwherek =boltzmann…

Q: The lumen rating of a 60W Incandescent lamp is 4200,Its Efficacy will be O a. 30% O b. 70% O C. 60%…

A: The efficacy is the measurement  of how efficiently light source produce visible light. It is…

Q: DC CIRCUIT IN SERIES NUMBER 6 amps Current flow, direction Internal Resistance 36 V 15 ohms…

A:

Q: VI characteristics of solar PV

A:

Q: Find Vout 10 ohms SVMM 100 ohms + • Vout

A:

Q: voltmeter

A: 5.Given-For short shunt method-Voltmeter reading= 250 VVoltmeter resistance= 5 kohmResistance value=…

Q: Find the total resistance for the figure below: 20 40 30 20

A:

Q: A current 0.25 A exits in a 60-ohm lamp. The potential difference is

A: Given data, Current is given I = 0.25 A Resistance is given R = 60 ohm.

Q: direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating…

A:

Q: A 5.3 V zener is rated at 1.5 watt. The maximum zener current is equal to a. 2.83 mA. O b. 283 mA. O…

A: In this question we need to find a maximum zener current .

Q: Choose the value of the supply voltage for a 1000 W, 10 ohm load from the following option. a. 50 V…

A: Power consumed by resistor R with supply voltage V is P=V2R Given power consumed P =1000 watts And…

Q: How much work is done by a 12-V automobile battery in moving 5x102" electrons from the positive…

A: According to the question we have to find the value of work done.

Q: The value of resistance in insulators is O a. small O b. large O c. can not be determined O d. zero

A: The electrons in the insulator's atoms are strongly bonded and cannot travel easily. Other…

Q: Rp Ho Re Vps Vas Figure 7.52 Bi resistance, R

A: NMOS transistor. It is a semiconductor chip and is one type of MOSFET transistor. In this…

Q: Convert the current source to a voltage source

A: In this question we will convert current source into equivalent voltage source...

Q: 2. Repeat problem #1 for ß = 140 using the exact approach. What levels are affected the most and…

A:

Q: UNSEEN An e-beam welder uses a 20 kV potential to give an electron beam aimed at the metal to be…

A: Given values are - V=20kVI=50mA

Q: power output. Question 4: An ideal PV cell with reverse saturation current of 1.5nA is operating at…

A: Solar cell is a PN junction diode across which when light falls on depletion region electron-hole…

Q: Determine the resistance of a coil connected to a 150 V supply when a current of    (a) 75mA   (b)…

A: Here i have derived the answer using ohms law.

Q: A 5.6kohm B 5.6kohm 100V 1 kohm 1 kohm

A: Given circuit,

Q: A 3 V Duracell battery is connected across a lamp of 1 ohm resistance. How much power will be…

A: In a purely resistive circuit, if E represents the voltage applied across a resistor of resistance…

Q: Determine the voltage at resistor R1 if the Zener voltage is 5.1 V. * D1 KH R1 500

A:

Q: Sketch the output voltage (V,) for the circuit and the input voltage (V;) shown in figure (3

A: A diode is a two terminal PN junction device, the two terminals of a diode are anode and cathode.…

Q: A student wants to measure the electric potential difference across the battery for the circuit…

A:

Q: D1 好 R1 500

A:

Q: A device used to protect a circuit against over currents is a what? a. Polyswitch b. Capacitor c.…

A: A device used to protect a circuit against our current is called fuse.

Q: 20 k 30 kn 60 kn 20 kn 50 kn

A: According to the question we have to find the value of the equivalent Resistance.

Q: Q5. What is the Type of the circuit blow and Determine vo for the circuit below. 30 V

A: What is the type of circuit and determine Vo

Q: What changes would you apply to the circuit to saturate Vo? Propose at least 5 possibilities.

A: Using Virtual ground concept in the circuit, V+=V-=0 KCL at node (V-) I1+I2+I3=IfV11 k+V2100+V110…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.