Volumetric analysis of the products of combustion of an unknown hydrocarbon, measured on a dry basis, gives 10.4% CO2 1.2% CO 2.8% O2, and 85.6% N, Determine: (a) the complete actual combustion equation, with coefficients of O2 and N2 separately in the reactants, (b) the composition of the hydrocarbon and tell that whether such

Q: Show solution

A: The aqueous ionic solutions are prepared by dissolving the given compound in water. In water, the co...

Q: Aluminum has a specific heat of 0.897 J/g °C. How much heat is needed to raise the temperature of a ...

A: Given: Specific heat = 0.897 J/g. C   Mass (m) = 79 gm Temperature: T1 = 25 C (ambient assumed), T2 ...

Q: Chemical Engineering Question

A: In thermodynamics, the melting point of a substance is the temperature at which it changes state fro...

Q: A raw sample of NaCl weighing 5.45 g was treated with excess of AgNO3   6.92 g AgCl is obtained. Det...

A: Weight of NaCl = 5.45 g  Weight of AgCl obtained = 6.92 g  Molar mass of AgCl = 143.32 g/mol Molar m...

Q: Experiment is about preparation of isopentyl acetate

A: GC instrument Gas Chromatography Instrument

Q: Balance each of the following examples of heterogeneous equilibria and write each reaction quotient,...

A: A heterogeneous equilibrium is a system in which reactants and products are found in two or more pha...

Q: B/ A 0.9257gm sample of impure magnesite, MgC03, was decomposed with HCI. The liberated CO2 was coll...

A:

Q: Nitrogen monoxide reacts with oxygen to give nitrogen dioxide. 2 NO(g) + O2(g) → 2 NO2(g) (a) You wi...

A: Volume of NO=150mL To Calculate the volume of O2 is required (at the same pressure and temperature)....

Q: A reaction has an activation energy of 195 kJ/mol. When tge temperature is increased from 200°C to 2...

A: The increase in the rate constant for an increase in the temperature is to be determined.

Q: Answer with 4 decimal places.

A: A continuous process is taking place where water is removed from the paper continuously by the help ...

Q: Q19) (a) Write the oxidation and reduction half cell reactions and arrive at the balanced net redox ...

A: Given the equation is, F=96500 Coulombs The atomic mass of Cr=52 g/mol Cr deposit gram A is 40 gram

Q: 1) NaBr_______kJ/mol 2) Nal________kJ/mol

A: In thermodynamics, at equilibrium and at a constant temperature and pressure, the Gibbs free energy ...

Q: The reaction of 1 mol of solid phosphorus with chlorine gas to form PCl3(g) releases 287 KJ of heat ...

A: This law is dependent on Hess's law. Data given : Reaction of 1 mol of solid phosphorus with chlorin...

Q: 1. Select from the following pairs of work, w and heat, q for the following conditid of a system: • ...

A: This question is based on the sign of work and heat.  

Q: Find the difference between the pressure ? PA- Pa = ? TAKE // h = 2 m, h2 = 4 m, h 3 m ( Pwater = 10...

A: H1 = 2 m H2 = 4 m  H3 = 3 m  ρwater = 1000 kg/m³ ρmurcury = 13600 kg/m³  ρoil = 850 kg/m³   

Q: What happens if the discharge electrode is negative in electrostatistic precipitation?

A: Electrostatic precipitator is a filtering device  that removes dust, smoke and ash using the princip...

Q: In an engine test the dry volumetric analysis of the products was CO2 0.0527, O2 0.1338 and N2 0.813...

A: Volumetric Analysis of the products: CO2 = 0.0527 O2 = 0.1338 N2 = 0.8135 Completely Burnt Assumptio...

Q: Also,which of the 3 given equations is most likely to be correct?

A: Thermal decomposition of AgNO3. The possible decomposition equations are : 1) 2 AgNO3 ---> 2AgNO2...

Q: Which of the following is a specific conductivity reagent? HCI .a O KCI .b O MgCl2 .c O NaCI .d O Al...

A: The specific conductivity reagent is to be chosen.

Q: Q 6) A mixture of methane and nitrogen is burned in the presence of air and the effluent gas composi...

A:

Q: Calculate the Ecell between two Cu2+/Cu half-cells, one of which contains 0.001 M Cu2+ and the other...

A: Given, Cu2+ =0.001 M  Cu2+=1 M    

Q: 3. A counter current heat exchanger is to be used for heating 0.1 lb/s water from 50 to 180 °F by ho...

A: A co-current heat exchanger is that type of heat exchanger in which both the hot and cold streams en...

Q: 2. Calculate (NPSH)A according to the figure given below. (density of the fluid=1514 kg/m³) P1=775mm...

A: NPSH (NET POSITIVE SUCTION HEAD) is defined as the total head of fluid at the impeller center line m...

Q: What is the optimum slurry droplet size in spray dryer absorber systems?

A: Spray Dryer Absorbers facilitate the removal of acidic pollutants, heavy metals, and dust from flue-...

Q: Calculate the IV flow rate in ml/her for Dopamine 1,600 mcg in 500ml of D5W running at 4 mcg/min

A: In chemical analysis, the concentration of a solution is defined as a measure of the amount of solut...

Q: A petroleum product of viscosity 0.5 m Ns/m² and density 700 kg/m³ is pumped froma tank through a pi...

A: Viscosity (u)= 0.5 m Ns/m^2 Density (p)= 700 kg/m^3 Diameter (d)= 0.15 m  100m away Pressure drop al...

Q: Question 10 please

A: 10. Given, Initial temperature, T1=47.9°C Final temperature, T2=12.3°C Heat, Q=3.12 kJ=3120 J Specif...

Q: 1 mole of nitrogen tetraoxide was placed in a container and allowed to dissociate according to the n...

A: Write the reaction as follows: N2O4g  → 2NO2g   The volume of the mixture, V = 36 L The pressure of ...

Q: In a decomposition reaction of Mercury (II) Oxide, a 25.7 g sample of the compound is heated and all...

A: Mass of HgO = 25.7 g 2HgO  -----------> 2Hg +O2 assuming normal temperature = 25oC = 298 K MM of ...

Q: Question 8 please

A: 8. Given, Heat, Q=98.3 J Mass of substance, m=12.28 g Temperature rise,

Q: Q4. In underground coal combustion in the gas phase several reactions take place including: CO +02 C...

A: Reactions:  CO + 12O2→CO2 H2+ 12O2→H2O CH4 + 2O2→CO2 + 2H2O Molar Compositions: CO2=15.22% CO=13.54%...

Q: In SPME for HPLC, analytes are desorbed from thefiber into solvent that is injected into the HPLC co...

A: SPME also known as Solid Phase Micro Extraction is an equilibrium sampling method and can be used fo...

Q: Please use Book: Introduction to Chemical Engineering Thermodynamics 8 edition, 2018 (Smith, J.M., V...

A:

Q: Sul

A: The mass of CaSO4 and H2O in the sample is to be calculated.

Q: what is hte pH for the complte titration of 34.5 mL of 0.192 M benzoic acid, HC6H5CO2, with 0.150 M ...

A: Given that: Volume of weak acid, benzoic acid (HC6H5CO2)= 34.5 mL Concentration of (HC6H5CO2)= 0.192...

Q: ............pressures al gases approaches ideal gas behavior A)gases with 0 MPa B)gases below 10 M...

A: Answer: option B) gases below 10 MPa

Q: Calculate AH for the following: rxn SiO2(s) + 4 HF(g) → SİF4(g) + 2 H,O(!) :) +

A:   Given To calculate   

Q: The reaction of liquid hydrogen peroxide, H2O2, with liquid hydrazine has also been suggested as a s...

A: 2 H2O2 (l) + N2H4 (l) → N2 (g) + 4 H2O (g)  ΔHf values: H2O2 (l) = –187.8 kJ/mol N2H4 (l) = 50.6 KJ/...

Q: i need the answer quickly

A: Given: diameter of tube d = 25 mm = 0.025 m mass flow rate of water m = 1.5 kg/s Mean bulk temperatu...

Q: Need brief explanation If its correct, I will upvote.

A: Volume of sample (V) = 4 L  Sample contain 2 Hg2+ ions  Molar mass of Hg2+  = 201 g/mol  Molar mass ...

Q: A completely sealed container, in the shape of a cube with side panels of length = 0.64 m, is full o...

A: Side of cube L = 0.64 m  Inner temperature = - 85.8°c = 187.2 K  Outer temperature = 31.6°c = 304.6 ...

Q: 2Fe2O3 + 3C → 3CO2 + 4Fe D. How many grams of CO2 are produced from 11.42g Fe2O3?

A:

Q: Actual = number on product side of balanced equation ** Theoretical = answer to your stoichiometry p...

A:

Q: Complete solution please, thank you!

A: a) aTiO2(s) +bC(s) + cCl2(g) →dTiCl4(g)+ eCO2(g) + fCO(g) TiO2 = 35g Cl2=45g C=11g  

Q: Does Q for the formation of 1 mol of NH3 from H2 and N2differ from Q for the formation of NH3 from H...

A: The expression for the reaction quotient is ratio of concentrations of products to concentrations of...

Q: The CaCO3 slurry is to be filtered in a filter press having 0.05 m2 area at a constant pressure of 4...

A: Given data: The properties of CaCO3 slurry at initial conditions are, Area of filter press = 0.05 m2...

Q: If we begin with 8 mL of a glucose solution with a concentration of 0.25 M and dilute it to a volume...

A: Given that, Initial Volume V1 = 8 mL = 0.008 L Initial concentration M1 = 0.25 M Final volume V2 = 0...

Q: Determine the characteristic gas constant for the following gases. ...

A: Oxygen Molecular Weight = 32 Nitrogen Molecular Weight = 28 The characteristic gas constant or the s...

Q: The following pneumatic conveyor system can be used preferably to handle materials at high temperatu...

A: A conveyor is nothing but it is a process that which is used to move or transport materials over a f...

Q: 4. For the reaction H2O(g) + C20(g) → 2HCIO(g), you know S'an and Says and S of HCIO(g) and of H2O(g...

A: H2O (g) + Cl2O (g) ----> 2 HClO (g)  We know S°rxn , S°HClO and S°H2O 

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.