Water A H1 cm H2 cm Mercury

Q: A container is filled with different layers of various liquids, as shown in the figure, Determine:…

A: Given data in question Different Layers depths. Specific gravity  Atmospheric pressure  To find…

Q: figure 5 shows a manometer being used to indicate the difference in pressure between points A and B…

A: Question is based on the concept of manometer. A manometer is given in the questioncontains water…

Q: A pressure gauge fitted on the side of a tank filled with liquid reads 50 kPa and 100 kPa at heights…

A:

Q: PROBLEM I - The pressure difference between an oil pipe and water pipe is measured by a double-fluid…

A:

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: Determine the magnitude and point of application of the horizontal and vertical compenents of the…

A: Compressive stress is the force that deforms the material in a way that reduces the volume of the…

Q: Question(5): (A) (Practical Question) In Figure (4), water flows through the pipe at A with a…

A:

Q: 1. A large tank contains a layer of oil floating on water as shown in the figure below. The flow is…

A: Given data  Specific gravity of oil = 0.8  Density of water = 1000 Pa  Acceleration due to gravity =…

Q: To measure the pressure inside a pipe, a manometer is connected to it as shown in the figure below.…

A:

Q: The system shown in the figure is used to accurately measure the pressure changes when the pressure…

A: Given S=1.26pgpw=1.26⇒ρglycerine=1260 kgm3

Q: 4. 1.7. Surface Tension H.W. 1: Derive an equation to estimate the internal pressure that is due to…

A: in case of liquid drop forces act on drop is like, gauge pressure exerted on area of droplet and…

Q: PROBLEM 1: Both a gage and a manometer are attached to a tank to measure pressure. Given the reading…

A:

Q: For the figure below, the atmospheric pressure equal to 101.3 kPa and the bottom pressure is 240…

A:

Q: In the set up shown in the figure, assuming the specific weight of water as 10000N/m³, the pressure…

A:

Q: Calculate the pressure at a point 420 mm below the surface of the mercury in a vessel. Express the…

A:

Q: Question 3 a) Consider the water container with a conical plug at the bottom, as shown. Determine…

A:

Q: For the figure below, the atmospheric pressure equal to 101.3 kPa and the bottom pressure is 240…

A: Given-Specific gravity of oil=0.89Specific gravity of water=1.0Specific gravity of X=?Specific…

Q: In the figure, liquid A weighs 58.5 lb/ft and liquid B weighs 73.3 lb/ft. Manometer liquid M is…

A:

Q: In the figure shown, what is the static pressure in kPa in the air chamber? AIR 2.0 m OIL S=0.80 4.0…

A:

Q: Air flows through a pipe at a rate of 200 L/s. The pipe consists of two sections of diameters 20 cm…

A:

Q: Calculate the pressure at a point 337 mm below the surface of the mercury in a vessel. Express the…

A:

Q: A vertical conduit is carrying oil (S=0.95) as shown in figure 2. A differential mercury manometer…

A: Given data, the specific gravity of the oil is 0.95. we have to  Determine the difference in…

Q: Pitot tube is an instrument that is used to measure flowrate in a pipe. Figure 3 shows water flowing…

A:

Q: (a) Consider a 1 m wide inclined gate of negligible weight that separates water from another fluid…

A:

Q: In figure 6, compute the pressure difference between m and n, in pounds per square inch, when: (a)…

A: Writing pressure equation PM+γAz-γGz+γA4.6=PN

Q: 3. A student wants to find the absolute pressure of water at a point below the surface of water. He…

A:

Q: 21. For the figure below, the specific gravity of unknown fluid is equal to a. 1.271 b. 1.35 C. 2.25…

A:

Q: Oil 65 kPa SG = 0.72 75 cm Air Water 30 cm Mercury SG = 13.6 h

A:

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: The figure below shows a closed tank that contains gasoline floating on water. Calculate the air…

A: Solution: Given Data S.G for mercury=13.54  Pressure is given byP=ρghρ=density of…

Q: ) For the manometer shown in figure, compute the pressure at point A, in kN/m². Specific gravities…

A: Given data : Specific garvity of oil (SOil )=0.8Specific gravity of mercury (SHg)=13.6Density of…

Q: Pitot tube is an instrument that is used to measure flowrate in a pipe. Figure 3 shows water flowing…

A:

Q: THIS IS NOT GRADED.  This is a 2020 Past Paper that I am working through. However I only have the…

A:

Q: In the figure below, a fluid with a specific gravity of 0.77 is flowing. The mass flow rate is…

A:

Q: In figure 6, compute the pressure difference between m and n, in pounds per square inch, when: A.…

A:

Q: AIR; PRESSURE=1.0 PSI OIL SG=0.82 MERCURY- LIQUID X SG=4.0

A: Given  Deflection from the gauge liquids= 800 mm  Height of mercury= 450 mm  Oil specific gravity =…

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: 3. An open manometer, shown in figure, is installed to measure the pressure in a pipe carrying an…

A:

Q: What is the absolute pressure inside the tank after it was submerged in a liquid if the volume of…

A: Given data  Percentage volume change Atmospheric pressure  To find Absolute pressure

Q: If the pressure in a tank of oil (sp.gr.=0.80) is 400 kPa, what is the equivalent head in meters of…

A: Given data  Specific gravity of oil ( Goil) = 0.80  Pressure in tank = 400 KPa  Now  We have to find…

Q: h₁ 3 Water process fluid h₂

A:

Q: In figure 6, compute the pressure difference between m and n, in pounds per square inch, when: (a)…

A:

Q: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as…

A:

Q: 2. What is the relationship between volume and pressure? 3. Calculate the volume if it is v1=1.5 L,…

A:

Q: a) As shown in Figure 1, what is the pressure of the air in the tank if = 40 cm, 62 = 100 cm, lz =…

A: Taking pressure equation:P1+l3γhg-γairl2+Sγwl2-Sγwl2-l1=P2

Q: A cylindrical tank is filled with fluid. A pressure gauge 7 meters above the bottom reads 140 kpa.…

A:

Q: A barometer reads 760 mm Hg and a pressure gage attached to a tank of oil (s = 0.8) reads 850 cm.…

A: Barometric pressure =760mm mercury  Gauge head = 850cm of oil  Gauge pressure= specific weight of…

Q: Question 2 Refer to the given figure below. Given: a = 1.55 m b=1.11 m c=0.73 m Carbon…

A:

Q: In the figure, fluid 2 is carbon tetrachloride(1.589) and fluid 1 is benzene (SG = 0.877). If the…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.