Water flows at a rate of 0.020 m 3/s from reservoir A to reservoir B through three concrete  pipes connected in series, as shown in figure below. Find the difference between water surface  elevations in the reservoirs. Neglect minor losses.

Q: well is sunk through an unconfined aquifer and is pumped at a constant rate. The draw-down in he…

A:

Q: Water at 20°C is siphoned from a reservoir as shown in following figure. For d = 8 cm and D = 16 cm,…

A: Given,d=8cmD=16cTemperature of water =20°C

Q: Water flows at a rate of 0.05 m³/s from reservoir A to reservoir B through three concrete pipes…

A:

Q: A pipe 800 m long connects two reservoirs whose level difference is 60 m. Find the discharge in pipe…

A:

Q: The monthly flows of a river during a critical period are tabulated below. Determine the active…

A: Solution Given Data Month  O N D J F M A M J J A S Q(m3/s) 10 3 10 6 14 15 6 6 10 9 4 9

Q: Two reservoirs are connected through a homogeneous and isotropic aquifer having hydraulic…

A: Given data  Length (L) = 2km = 2000 m  Porosity (n) = 0.3  Hydraulic conductivity (K) = 25 m/day

Q: Three reservoir A, B and C have elevations of 30 m., 24 m. and 15 m. respectively. Point D is the…

A:

Q: A confined aquifer underlies an unconfined aquifer as shown in the illustration below. Given the…

A:

Q: b. The reservoirs shown in Figure 5.1 contain water at 20°C. If the pipe is smooth with length, L,…

A:

Q: A cylindrical well is 2m in diameter and 12 m deep. If there is 3m of water in the bottom of the…

A: Given that,  the diameter of the cylindrical well, D=2m Depth of the cylindrical well, H=12 m water…

Q: Water flows at a rate of 0.025 cubic meter per second from reservoir A to reservoir B through three…

A:

Q: The following data represent the elevation-area relation for a reservoir, if the lowest outlet…

A:

Q: A reservoir with a surface area of 325 hectares had the following average values of parameters…

A: Avg. daily temp. by Meyer's formula:EL = Km ew - ea 1 + Ua16Where,Ua = monthly mean wind velocity in…

Q: PROBLEM 3 Water flows in a 4-cm-diameter pipe at 20 m/s. The pipe divides into two pipes, one 2 cm…

A:

Q: Two water reservoirs are connected by a siphon (running full) of total length 5000 m and diameter of…

A:

Q: B- Estimate the constant rate of withdrawal from a 1375 ha reservoir in a month of 30 days during…

A: Hi! Thank you for the question As per the honour code, We’ll answer the first question since the…

Q: What is the average daily -1 evaporation loss from reservoir with an average water spread area of 15…

A:

Q: The monthly flows of a river during a critical period are tabulated below. Determine the active…

A: Data Given: Month Discharge (m3/s) October 10 November 3 December 10 January 6 February…

Q: Hydrology problem. 6. Three pumping wells are located around an observation well as shown in the…

A: Given- Diameter of pumping wells-D=0.5 mTransmissivity-T=20 m2/dayRate of pumping-Q1=140…

Q: Two reservoirs are connected through a homogeneous and isotropic aquifer having hydraulic…

A: given          haduralic conductivity (k) = 25m/day         effective porosity (n) = 0.3…

Q: Calculate the volume of water in the dam at the end of the year assuming no outflows for downstream…

A:

Q: Two reservoirs are connected to each other with a pipe of length of 2 km and diameter 0.2 m.…

A: Given: Length, L = 2 km Diameter, d = 0.2 m Difference in water level, h = 8 m Friction factor, f =…

Q: Spillway 12.9 m. long releases flood run off from a reservoir 5 hectares in area. If the reservoir…

A:

Q: A lake has a surface area of 7.0 x 105 m² During a given month, the mean inflow to the lake was 2.5…

A: Given : Surface area of lake, SL = 7.0×105 m2Mean inflow, Im = 2.5 m3/secIncrease in stored volume…

Q: Design the pipe that will connect two reservoirs for a water distribution system of a certain sitio.…

A: Given = length of pipe = 2500 mtr Difference between elevation= 50 mtr

Q: The flow net for an earthen dam with 30 m water depth consists of 25 potential drops and 5 flow…

A:

Q: You are given the following information for the three reservoir system given below. All pipes are 28…

A: Flow rate is generally the volume of water that flows a point through the area per unit of time.…

Q: A reservoir with a surface area of 180 hectares had the following average values of parameters…

A: Given Values: Surface Area= 180 hectares Water Temperature=20.5oC Relative Humidity=75% Wind…

Q: m2 water has to be transported to compensate for natural evaporation. The total evaporation per year…

A: According to given data  For an irrigation project for an area of 10.000 km2 water has to be…

Q: Example 10: Water is released from a 3 m deep reservoir into a 6 m wide open channel through a…

A:

Q: Water flows at a rate of 0.0300m3 /? from reservoir 1 to reservoir 2 through three pipes connect in…

A: Given data Q = 0.03 m3/s  f= 0.025  We have to find Z1 - Z2 =Z  L1 = 1000m d1=0.2m L2 =1500m…

Q: Water at 20°C is siphoned from a reservoir as shown in Figure. For d= 5 cm and D= 15 cm, h = 5 m,…

A: To find out the:- (a) Minimum flow rate that can be achieved without cavitation occurring in the…

Q: Groundwater flows through an aquifer with a cross-sectional area of 1.0 x 104 m² and a length of…

A: Given data- Cross section Area A=104 m2Length of aquifer L=1500 mHead difference H=50 mDischarge…

Q: Find the required capacity of the reservoir using Mass Curve diaghram if the inflow of river shown…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In a given month, a lake of constant surface area 1,000,000 m2 has a mean inflow of 0.40 m3/s, an…

A: Given data:Inflow, I=0.40 m3/s or 1036800 m3 in the monthOutflow, O=0.34m3/s or 881280 m3 in the…

Q: The following figure illustrates the flow net for a proposed structure at the Alaska shore. From the…

A: Given data: H=10, K=6×10-5m/sec from figure, Nf=3, Nd=12 K=6×10-5K=6×10-5×60×60×24=5.18m/day For…

Q: SITUATION 11: A 300-mm diameter test well penetrates 27 m below the static water table. Water is…

A: Given a 300 mm diameter test well y = 27m; Water is pumped at a flow rate of 69 l/sec   The rate of…

Q: Q2. A flowrate of 1.2 m³/s is supplied from a drinking water dam lake (reservoir), which has been…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: b. The reservoirs shown in Figure 5.1 contain water at 20°C. If the pipe is smooth with length, L,…

A:

Q: The flow net constructed for a dam is shown in the figure below. Taking coefficient of permeability…

A:

Q: Q3: A concrete dam and the flow net are shown in the Figure below. The following parameter ar given…

A: Given Data:

Q: What is the head loss at the outlet of the pipe that discharges water into the reservoir at a rate…

A:

Q: The difference in levels between the catchment reservoir and the service reservoir of a town supply…

A:

Q: The water needs of a small farm are to be met by pumping water from a well that can supply water…

A: Given Flow rate of water, Q=5L/s  =5x10-3m/s  Diameter of the pipe, d=6cm=0.06m  Length of pipe,…

Q: The monthly flows of a river during a critical period are tabulated below. Determine the active…

A: Solution: Month Discharge (m3/s) Days Volume of water stored OCT 10 31 10*31*24*60*60=26.784…

Q: Water is flowing into a conical reservoir 20 ft. deep and 10 ft. diameter across the top at the rate…

A: Height of conical reservoir = 20 ft Diameter of reservoir = 10 ft Rate of water flowing is given as…

Q: Example 4.4 A fully penetrating artesian well is pumped at a rate Q = 1500 m³/day from an aquifer…

A:

Q: A well produces water from a confined aquifer at a rate of 550 m3/day for a period of 30 days, and…

A:

Q: Calculate the daily quantity of seepage into the drain of an area underlain by an unconfined…

A: Answer we are given hydraulic conductivity k =1 m/hr = 1*24 m/day distance between canal and drain =…

Time and time related variables in engineering

Time is the event progression starting from past to present and then, future statistically. The time-related variable is any particular value in relation to time to assess its changes on a specified (XY) plane.