WD=51.1 kN/m W₁ = 14.6 kN/m B с 2.7 m2.7 m → 10.8 m 5.4 m
Q: A turbine is rated at 600 hp when the flow of water through it is 0.61 m^3/s. Assuming an efficiency…
A:
Q: 2. Determine the reaction at the supports using E = 70 GPa and I = 1,300,000,000 mm^4. Draw the FBD…
A:
Q: Calculate the TMU equivalent of 0.0075 h per piece, 0.248 min per piece, 0.0622 h per hundred…
A: Answer We know from Methods of time measurements that Time Measuring unit(TMU) is used to determine…
Q: what is the mass of an object that requires a force of 90 N to accelerate at a rate 2.6 m/sec^1/2 ?…
A: As per Newtons second law of motion, acceleration produced in a body is directly proportional to the…
Q: are involved in fini 1.
A: solution of above problem is below:
Q: The truss shown is composed of steel sections. If the 2L150 x 90 x 8 A36 steel section was used in…
A: Given
Q: Use cantilever method to estimate the forces in the laterally loaded frame shown. Loads: fifth…
A: Solution: Analyse the frame using cantilever Method: Point of contraflexure occurs at the middle…
Q: Following are the results of a shrinkage limit test: n 1: Determine the shrinkage ratio of the soil.…
A: Given data- Initial volume of saturated soil Vsat=24.6 cm3Final volume of dry soil Vdry=15.9…
Q: 5. Cables A, B and C support a 50 lb load as shown. Determine; a) The magnitude of the tensions in…
A: Determine; a) The magnitude of the tensions in each cable b) Express the tension in each cable in…
Q: Ablock weighing W= 20 KN is resting on an inclined plane which makes an angle of (30 degree) to the…
A:
Q: Find the maximum uniformly distributed load can be resisted by the slab show in the figure using…
A: given- Yield Line MethodMoment strength of the slab-M=25 kN.mSide lengths= 4 m, 2 m, and 4 m
Q: In the construction of a levee by compacting soil excavated from a borrow area to dry of 1.78…
A:
Q: A circular drainage pipe 0.80 m in diameter conveys a discharge at a depth of 0.30m. If the pipe is…
A:
Q: 2. The results of Marshall Test for five specimens are given below. Find the optimum bitumen content…
A: Given:- The result of the Marshall test for the five specimens is given Bitumen content Stability…
Q: Construct the frequency and percentage distribution table. Round off your answer in nearest…
A: Answer Frequency or absolute frequency is actual number counted for unique set of category or bins.…
Q: enters a tank of ss flow rate of r ith diameter Do rictional losses y at h 10 m e water will reac…
A:
Q: 3) Determine the maximum allowable value of P if the flexural tensile and compressive stresses are…
A:
Q: This assignment consists of determining the quantities for a cost estimate in different units.…
A: from the given data from the problem Type Length height Area After completion of deduction…
Q: In the construction of a levee by compacting soil excavated from a borrow area to dry of 1.78…
A: In the point 3 It must be Quantity of water as the quality of water has nothing to do with…
Q: 25 KN-m -im tim t R₁ 10 kN/m₂ -3m im R₂
A:
Q: A 400mm x 300mm short tied column is designed to carry an eccentric ultimate load of 1000 kN. If the…
A: Minimum eccentricity= 20 mm= 0.02 m Load carrying capacity of the column= 1000KN Moment carrying…
Q: Two unlike parallel force, each of the magnitude 50 KN are 200 mm apart from each other. what will…
A: It is measured by the moment of the force. The product of one of the two forces of a Couple and the…
Q: Compute for the (1) Hulling efficiency; (2) Milling recovery; and (3) Milling degree using the…
A: Given data • Total weight of sample = 320 grams• Weight of brown rice = 286.4grams• Weight of…
Q: The regression analysis of a 30 year flood data at a point on a river yielded sample mean = 1200…
A:
Q: Problem 5 From the figure shown, the void ratio of the sand is 0.55 with a specific gravity of 2.68.…
A:
Q: Consider the figure below where AX=1000 ft, AY=750 ft, AZ-50 ft, Kx-50, PHI-27%, μ-30 cp, Pi-4500…
A:
Q: A 6 Kg object is subject to three forces F1=20i+ 30 jN F2= 8i-50j N F3= 2i +2j N Find the…
A:
Q: 3 5-63. A 25-ft-long garden hose with ain. inside diameter, is used to drain a swimming pool, as…
A:
Q: A submerged sharp crested weir 0.75 m high extends across a rectangular channel 3 m wide. The depth…
A:
Q: The beam shown is laterally braced at A, B, C, and D. Determine the following: a. Check for…
A:
Q: Determine the ultimate axial load capacity of a rectangular tied column 350 mm x 450 mm having…
A: step 1-
Q: mm allows e negligible ermine the he tank and alculate the
A:
Q: Determine area the top and all side of a platform below. 6m 2.65m 115°
A:
Q: the modulus of elasticity.
A: Modulus of elasticity: - It is defined as the normal stress of a material divided by longitudinal…
Q: Velocities of bodies that undergone translation are relative. * TRUE FALSE Whenever the body has…
A:
Q: Design a round spiral column to support an axial dead load of 500 KN and an axial live load of 650…
A:
Q: 1. Calculate the support reactions at A and C if El is constant throughout the length. determine the…
A: Let using superposition method Taking vertical reaction at A (RA) as a redundant.
Q: Draw the FBD of the beam with the calculated values of the support reactions.
A: Here, we have a cantilever simply supported beam. And we have to calculate the support reaction at A…
Q: It is observed that 40 traffic crashes occurred on a 17.5 mile long section of highway in 6 months.…
A: Given :
Q: A cantilever beam with a length of 15 meters and a circular cross section with a diameter (d) of 250…
A: For equilibrium of the beams: ∑fy=0VA=25 KN∑fy=0HA=1500 KN∑MA=0-MA-25KNm=0MA=-25KNm Diameter of the…
Q: Calculate the support reactions at A and C if El is constant throughout the length. determine the…
A: Let RA be redundant reaction force. y1 (deflection at A due to udl) = wL4/(8EI) =…
Q: A plywood beam is built up of 1/4-in. strips separated by blocks as shown in Fig P-577. What…
A:
Q: Q1: A sag vertical curve connects a (-3.5%) grade and a (+0.5%) grade. The PVC is at station…
A:
Q: 7. The sketch shows a test of an electrostatic air filter. The pressure drop for the filter is 3…
A:
Q: Consider the figure below where AX=1000 ft, AY=750 ft, AZ-50 ft, Kx=50, PHI=27%, μ-30 cp, Pi-4500…
A:
Q: I. Write the shear and moment equations and draw the shear and moment diagram. 100 KN 50 kN/m 60…
A: As per Bartleby's guidelines we are supposed to answer only first question. Kindly repost other…
Q: Find the width (meter) of a suppressed weir using the following data: H = 25.8 cm; D = 2.485 m; Q =…
A: H=25.8cm Q=0.84m3/s
Q: A jet of water 25 mm in diameter and having a velocity of 7.62 m/s strikes against a vertical plate…
A:
Q: The population of a state is known to grow at a rate proportional to the number of people presently…
A:
Q: A soil meant for road construction is said to have a CBR of 5% explain the meaning behind this…
A: The California Bearing Ratio Test is indeed a penetrating method used to measure the stability of…
The beam shown is laterally braced at A, B, C, and D. Is a W14 × 99 adequate for Fy = 345
MPa?
Step by step
Solved in 2 steps with 2 images
- Water flows through an almost level channel 3 m wide at a rate of 12 m³/s. The depth gradually increases from 1 to 1.10 m over a length of flow of 5 m. Which of the following most nearly gives the roughness coefficient?A confined aquifer is 18.5 m thick. The hydraulic head drops 2.99 m between two wellsthat are 823 m apart. If the hydraulic conductivity of the aquifer is 4.35 m/d, how many cubicmeters of water are moving through the aquifer per unit width?This solution is incorrect because the computation for the Volume is wrong. Please give a more detailed solution and correct answer to this problem. An earth dam shown is required to have an effective unit weight of 12.079 kN/m3. The suitable material for the dam was identified available from the two borrow sites in the vicinity of the proposed dam. Borrow site A has dry unit weight of 17.875 kN/m3 and was observed to have free swell of 18.975%. Borrow site B has bulk unit weight of 19.245 kN/m3 at moisture content of 8.544% and was observed to have free swell of 28.785%. Assume Gs to be 2.841. Determine the following: a. Volume of the soil solids per meter length of the dam, m3. b. Cost per meter length of the dam if borrow site A was chosen at cost of P264.855 per cubic meter. c. Cost per meter length of the dam if borrow site B was chosen at cost of P238.012 per cubic meter.
- Aquifer area extent 100 km/sq is overlain by 4 strata as given below: Strata 1 (top): Thickness = 1, Kx (m/day) = 1, Ky (m/day) = 0.25 Strata 2: Thickness = 3, Kx (m/day) = 2, Ky (m/day) = 0.3 Strata 3: Thickness = 2, Kx (m/day) = 1.5, Ky (m/day) = 0.2 Strata 4: Thickness = 4, Kx (m/day) = 0.025, Ky (m/day) = 0.005 (1) If a 4 hour storm occurs producing a total rainfall of 100mm, estimate the recharge into the aquifer assuming the piezometric surface in the aquifer is at the bottom layer 4 and all layers are saturated. (2) If the 4 layers are underlain by an impermeable strata instead of aquifer. Estimate the lateral flow per unit weight through the layers ASSUMING that the layer is deep by 0.1%Q#4: Design an irrigation channel to carry 35.5 cumecs of discharge with B/D ratio as 2.38 The critical velocity ratio is 1.2. Assume a suitable value of kutter’s rugosity coefficient and use kennedy’s method?A rectangular open channel is 4m wide and has a discharge of 10 cu.m./s when the depth of flow is 2m. If the same material has been used for a trapezoidal open channel having the same wetted perimeter, what would be the most efficient discharge without changing the slope? Q = Blank 1 cubic meters/sec.
- 17. Using horizontal direction in cm/day 18. if the hydraulic gradually for the soil formation is 0.75 19 aquifer in cubic meters per day pls ans:Design an irrigation channel by Kennedy’s theory to carry 5 cumecs of discharge with criticalvelocity ratio as 1, B/D = 4.4 and Kutter’s rugosity coefficient as 0.0225.In the Given Rectangular Dam, determine the magnitude of the resultant R and where itintersects the base AB. show fbd and complete solution, need asap :)
- A trough has an open-top 0.30 m by 6 m and closed vertical ends which are equilateral triangles 30 cm on each side. It is filled with water to half its depth. Find the volume of the water in cubic meters.The trough whose ends are isosceles trapezoid with vertical axis is 20 m. long. The lower base of the trapezoid is 2 m. and the upper base is 6 m. and 4 m. deep. The trough contains 100, 000 liters of liquid having a specific gravity "S". How deep is the water in the trough?A 3 m wide rectangular channel conveys 12 m3 /s of water at a depth of 2 m. Calculate the Froude number.