What affects the evaporation rate?

Q: Explain with the help of diagram the working principle of low temperature and adsorption dryers.

A: The general working principle of adsorption dryers is simple: moist air flows over hygroscopic…

Q: What are the types boiling occur in evaporator? Define them

A: Define : the type of boiling occur in evaporator

Q: O C. Distillation unit

A: Distillation unit is not used in the solar thermal power plant  Correct answer is option 'C'

Q: describe the five types of reservoirs and draw pressure-temperature phase diagram of each fluid

A: Types of Reservoirs : Single phase gas reservoir: It primary consist of recovery mechanism of…

Q: Define the ff: Developed Boiler Horsepower Rated Boiler Horsepower Steam Generator Factor of…

A:

Q: What do you mean by breakthrough curve for fixed-bed adsorption system?

A: Given: breakthrough curve for fixed-bed adsorption system

Q: What is the principle of operation of vapor absorption system?

A: To Discuss :  Principle of operation of vapor absorption system.

Q: Describe the desirable properties of refrigerants suitable for ice plant applications. Name a few of…

A: Solution:: Desirable properties of refrigerants suitable for ice plants: • It should be cheap• It…

Q: Which of the following gasifiers has the Lowest thermal output?

A: Answer is Downdraft

Q: What is the length of the finned section of pipe in this baseboard hot waterheating system?

A: Find    Calculate the length of the finned section of the pipe

Q: Discuss reverse-airflow cleaning methods in detail.

A: given: Discuss reverse-airflow cleaning methods in detail.

Q: the maximum surface temperature on the circuit board (°C)?

A: Given: Cp=5193 J/kg°Cν=1.233×10-4 m2/sρ=0.1635 kg/mPr=0.669k=0.1565 W/m°CChannel dimension =0.46…

Q: intercooling pressure for minimum

A: Given; The compressor of a gas turbine plant, operating on an idealintercooled Brayton cycle…

Q: What are the advantages of Contact condensing systems?

A: In contact condensing systems, the direct contact between the two mediums takes place. The…

Q: aturated vapor.

A: Kindly refer attached files.

Q: 9

A: Dehydrator & Desalter

Q: Why in which cases is the flue gas treatment is used?

A: Given Data : Treatment of flue gases

Q: What is lower explosive limit in thermal oxidiser?

A: Many process and manufacturing industries are having to install “thermal oxidisers” (Incinerators or…

Q: D00 m3 tank at a rate of 0.4 m/s. nlorine. The treatment unit uses a ill cause the chlorine…

A: Given data-Volume     =2000 m3Velocity V=0.4 m3/sPollutant  =7.94 CFU /LStock        =750…

Q: A- What is meant by the term superheat?.

A: Solution:   Note: Dear Student! As per our guidelines, we are only allowed to answer a single…

Q: kindly differentiate the canning methods of process in boiling water bath and using autoclave with…

A: Canning is the process in which foods are placed in cans and jars and heating them to a specified…

Q: What is the difference between mobility and mobility ratio in enhanced oil recovery.

A: Given question : What is the difference between mobility and mobility ratio in enhanced oil…

Q: 1) For same cooling media temperature, If ,highest condensation pressure is obtained. Select one: a.…

A: According to Bartleyby's policy we can answer only one question at a time so if you want the answers…

Q: In general, steel produced by the Basic Oxygen Furnace is of a better quality than the one produced…

A: Basic Oxygen Furnace It is a pear-shaped structure with a closed bottom and an open top. It is used…

Q: -The blockage of the capillary tube may be due to dirt or the presence of moisture Inside the icing…

A: The capillary tube is the simplest of the refrigerant controls. It is the most popular method for…

Q: What is chilled and condenser treatment process?

A: A chiller is a mechanical system used for the purpose of refrigeration in industries. It helps in…

Q: To prevent dehydration in air blast freezing method the air velocity under controlled :time should…

A: Ans: Third option is correct. 160

Q: Select the type of coolant which is very toxic. O a. Mix of Long-Life ethylene glycol and Propylene…

A: Given data

Q: The name for the process in which water vapor changes back into a liquid is deposition sublimation…

A:

Q: II- The bi-metallic thermome variation. (a) very high, (b

A: Bimetal thermometers work on the principle based upon the different expansion rates of different…

Q: boiling point

A: 446deg.c-answer

Q: How much total heat must be Temoved from 10kg water to : a) (ool it from 30°C to 0°C 。) Solidify it…

A: Given:mass of water, m= 10 Kg

Q: Define the low pressures (below the triplepoint value), solids evaporate without melting first…

A: At the triple point of a substance, all the phases exist together in equilibrium with each other. At…

Q: Heat added in the process ?

A: Given; For 1.5 kg of water in saturated state;Pressure=2 Barvf=0.001061 m3/kguf=504.0 kJ/kghf=505…

Q: Boiling

A: given:T1=1100XT2=4500X

Q: A merciry makes an emole of 130 with respect to the \rertical when in contact with Clean gleed. How…

A:

Q: Generally speaking what is the first step in air treatment

A:

Q: 1. Describe briefly the principles of condensers. 2. What are the main parts of typical condenser?…

A: A device which by cooling condense a substance from its gaseous state to its liquid state is called…

Q: Where do you see condensation in the setup?

A:

Q: If the air leaving the cooling coil were to be 55 degrees f dry-bulb and 53 degrees wet-bulb, what…

A:

Q: is a closed vessel in which vaporization of water takes place. ne: Feed water heater Condensor

A: Option (d) Boiler  is correct option

Q: What is the critical temperature for N2? In R

A: The critical temperature of N2 is −146.9 °C (126.2 K).