What capacitor in series with a 100 2 resistor and a 15 mH inductor will give a resonance frequency of 1020 Hz ? Express your answer in microfarads. 195| ΑΣΦ ? C= 6.15 105 ● Submit Previous Answers Request Answer HF

What capacitor in series with a 100 2 resistor and a 15 mH inductor will give a resonance frequency of 1020 Hz ? Express your answer in microfarads. 195| ΑΣΦ ? C= 6.15 105 ● Submit Previous Answers Request Answer HF

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: G (s) K (1 + 0.5s) (1 + 0.5s + 0.25s2 H(s) 1

Q: The power consumed by a coil is 300 W when connected to a 30 V dc source and 108 W when connected to…

A: We need to find out reactance of inductor for given power

Q: closed and switch 2 is opened, or if switches 2, 4, and 7 are closed and switch 1 is opened, or if…

A: We use 7 switches to operate , If, Switch 1,3,5,7 - closed Switch 2 - open If, Switch 2,4,6 -…

Q: What is the induced voltage Vs in the transformer, if the primary voltage Vp-220 V with number of…

A: Given, Primary voltage, Vp=220 V Number of primary turns, Np=50 Number of secondary turns, Ns=10

Q: Determine the signal level sensed by the amplifier if the circuit has an input impedance of 1 kohm…

Q: 2. A separate excited motor with PN 18kW UN 220V, IN-94A, n№=1000rpm, Ra=0.150, calculate: (a) Rated…

A: Given A separate excited motor with PN-18kW, UN 220V, IN-94A, n=1000rpm, Ra=0.150, calculate: (a)…

Q: dy+ay(t) = Skx(t) The steady-state gain of the step response y(t) is 10 and the rise time is 4, what…

Q: A wire is 21.0 m long at 3.50°C and is 1.66 cm longer at 36.5°C. Find the wire's coefficient of…

A: Given, A wire has L0=21.0 m at T0=3.50°CL=1.66 cm at T=36.5° C

Q: You are designing a filter and the design equations produce a resistor value of 1 KQ and a capacitor…

A: Brief description: In the above given question they have mentioned a filter circuit. For the given…

Q: a. Formulate KVL on input or base loop! b. Calculate and determine IB! c. Calculate and determine…

A: The required parameters can be calculated by using the DC analysis of the amplifier circuit.

Q: Identify the source and load sides of a three-phase three-wire transmission system by a, b, c, and…

A: The reading of a wattmeter P is given by P = VI cos ϕ where V and I are the RMS values of voltage…

Q: A uniform line charge of 2 µC/m is located

Q: We wish to design the CE stage of Figure for a voltage gain of 20. What is the minimum allowable…

A: The given circuit diagram is shown below, Where,Av = 20VA=∞VBE=0.8 VRc=50 kΩ

Q: Given the circuit below, find the output voltage vout measured across the resistor. You are told…

Q: What is the equivalent transfer function of the following block diagram? G₁ Input (R) Output (C) G₂

A: The question is solved by block diagram algebra by assuming dummy variables and then writing…

Q: 6) The DC bridge shown below in the figure has a resistor Rv which is sensitive to the variation in…

A: Given, The DC bridge circuit is shown below, The temperature vs resistance plot is shown below,

Q: If you know that the phase crossover frequency is 3.16 (rad/s) for the following transfer function,…

Q: 17 he Joint pro. density function 19 ? two discrete discrete variable I and Y is given by 1

Q: For the network of Fig.1, with bypassed capacitance (CE), determine the re equivalent model circuit…

Q: Convert into rectangular, polar and exponential form: Given: Z1= 2-j3 1. 3^z1

A: Brief description: In the above given question they have a mentioned a complex number. For the given…

Q: Design an inverting linear summer circuit to perform function as Vo = -4V1 -10V2 + 5 V3 + 15 V4. Do…

Q: We wish to design the CE stage of Figure for a voltage gain of 20. What is the minimum allowable…

Q: 2. For an ideal amplifier, the input impedance should be output impedance should be OOohm and…

Q: Q2: What is the difference between Half Adder(HA) And Half Subtractor(HS)? Output of HA are SUM and…

A: The output of half adder are sum and carry out. Where as output of half subtractor are difference…

Q: A 10 cm length of a K-band (a = 1.06 cm and b = 0.43 cm) copper (o= 5.8x107) waveguide is filled…

A: Step 1 A 10 cm length of a K-band (a=1.06 cm and b=0.43 cm copper σ=5.8×107 waveguide is filled…

Q: 2) From the given digram of inductance comparison bridge circuit, determine the value of Rx and Lx…

Q: w 3.2 +1240V www jan www j3 4.52 16 (0°V -jan ====y=0V ref. 3410 A

Q: TOPIC: Industrial Electronics Choose one of the three measurement instruments (Voltmeter, Ammeter,…

A: Electrical measurement instruments is used for measure a various electrical aspects like voltage,…

Q: If the waveform of a voltage has a Form Factor of 1.15 and c Peak Factor of 1.5, and if the peak…

A: Given: A voltage waveform with, Form factor = 1.15 Peak factor = 1.5 Peak value, Vm=4.5 kV

Q: Jse superposition to solve for in (t) 20 με 50 cos 2000r V 40 mH 2 sir 4000r A 80 Ω 60 Ω 100 Ω 24 V

Q: A basic D’Arsonval movement with a full-scale deflection of 50μA and internal resistance of 500Ω is…

Q: 10. The primary and secondary winding of a 50 kVA, 6600/220 V transformer have resistance of 7.8 ohm…

Q: Jse mesh analysis to find vo(t) if iş = 10cost(30t + 20°)A 0.1% | 20 Ω 40 Ω 50 με 100 mH

Q: A circuit consists of a battery connected to three resistors (65 , 30 , and 180 2) in parallel. The…

A: Given, The three parallel connected resistors are R1=65 ΩR2=30 ΩR3=180 Ω Total current, I=2.7 A

Q: Given: Vcc = 6V RB =10k RC=1k B(beta)=100 hie=1k. Identify: a. What is the voltage gain of the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Determine I(t) in the circuit below. 10√/2 sin (10t) 2.076 cos (10t+4.764°) A 2.076 cos (10t +…

Q: Find I in the circuit shown in the figure below using superposition. 6 ki 2 kf2 2 kil www 30 V (+ 12…

Q: Find the total capacitance in micro farads of the combination of capacitors shown in the figure…

Q: The output power in the induction motor of 1200 W input power and 87% efficiency is: Select one:…

A: Given, Input power of induction motor, Pin=1200 W Output power of induction motor, Po=? If the…

Q: A full wave rectifier circuit is given with peak output voltage Vy =15 V, R=10 kN, C= 50 µF, T…

A: For the full-wave rectifier, the ripple voltage is given by the expression as shown below:…

Q: A diode is a two terminal device. The application of a voltage across its terminals leaves three…

A: Diode- Diode is an electronic device which has two ports for supply connection. It is made up by the…

Q: The initial and final values of f(t)=15-10t-10e e-20r are respectively (a) 5 and ∞ (b) 5 and -co (c)…

A: Given function, ft=15-10t-10e-20t

Q: 2. A 15-km, 60Hz, single phase transmission line consists of two solid conductors, each having a…

Q: Multiple Choice directions: Circle the letter of the answers 4. This waveguide component allows…

A: Antenna- Metal device, which captures and transmits radio electromagnetic waves. it is know as…

Q: Two generators operating in parallel supply a total load current of 150 A.The terminal potential…

A: The circuit diagram of the above parallel combination will be like:

Q: 4.41) If the Q- factor of a coil at resonant frequency of 1.5 MHz is 150 for a series resonant…

A: Given data, Q-factor Q= 150 Resonance frequency fr=1.5 MHz

Q: Reduce to a single transfer function: R(S)- S S 200 S S 115 C(s)

A: Given problem can be solved by block reduction technique as stated below.

Q: 2. Determine Vo #y 201 0 -SY $ 130, UNIVER +

Q: Ex: use phasors and nodal analysis to find U₂ in 2 the circuit that shown below. (2) 3152 m -sjur U2…

Q: Silicon R₁ = 1000 24Vp Analyze the circuit using any circuit analysis method to compute for the…

A: Given: Supply AC=24Vp(peak) at 60Hz Diodes=Silicon Load Resistance=1000Ω

Question

What capacitor in series with a 100 2 resistor and a 15 mH inductor will give a resonance frequency of 1020 Hz ?
Express your answer in microfarads.
195| ΑΣΦ
?
C= 6.15 105
●
Submit Previous Answers Request Answer
X Incorrect; Try Again; 3 attempts remaining
HF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An inductor L is connected in parallel to the series combination of capacitor C and resistor R. If L = 0.02122 H, C = 0.000421 F and R = 5 Ω, the impressed voltage E = 120 volts AC. Determine the voltage drop across the capacitor and the Quality Factor Q.
A series RLC circuit has a resistance of 25.0 Ω, a capacitance of 50.0 μF, and an inductance of 0.300 H. If the circuit is driven by a 120 V, 60 Hz source, calculate i. the total impedance of the circuit. ii. the rms current in the circuit. iii. the phase angle between the voltage and the current. iv. the resonance frequency of the circuit.
A circuit consists of an inductor which has a resistance of 10 Ω and an inductance of 0.3 H, in serieswith a capacitor of 30 μF capacitance. Calculate(a) the impedance of the circuit to currents of 40 Hz (b) the resonant frequency (c) the peakvalue of stored energy in joules when the applied voltage is 200 V at the resonant frequency.Answer: [58.31 Ω; 53 Hz; 120 J]
A 500 µH inductor, 80/π^2 pF capacitor and a 628 ohm resistor are connected to form a series RLC circuit. Calculate the resonant frequency and Q-factor of this circuit at resonance ? Please answer ASAP
a. draw the root locus system for k>0b, draw the root locus system for k<0
A 400 ohm resistor, a 20µF capacitor, and a 0.505 Henry inductor are connected in parallel and are energized by a 240V variable frequency source. (a) At what frequency will the circuit be in resonance? (b) Calculate the total current and the individual current in each branch IR, IL, and IC under conditions of resonance.
If A 20-µF capacitor is connected in parallel with a 1.2-mH coil to form a tank circuit, what would be the resonant frequency of the tank circuit? 324.87 Hz 10.27 kHz 1027.34 Hz 32.49 mHz
A coil of resistance 20 Ω and inductance 0.2 mH is in parallel with a variable capacitor. If the supply is at a frequency of 1 kHz, what should be the value of capacitance that will make the circuit run at resonance?
Find the value of 2 capacitors in parallel with an 8.2uh inductor to produce 1.8Mhz resonance frequency
At what frequency of a series ac circuit consisting of a coil resistance of 10 ohms and inductance 50 mH and capacitance 0.05 μF will resonate. Find also the current flowing at resonance if the supply voltage is 100v.
A 0.796 mH inductor produces an inductive reactance of 50 ohms at 10kHz. What value of capacitance will be needed to produce a resonant circuit at this frequency?
A coil of resistance 25 ohm and inductance 100mH is connected in series with a capacitance of 0.12 F across a 200V , variable frequency supply . Calculate : 1) draw the sinusodial waveform for VL, VC, VR of the circuit and explain the phasor diagram and how they are produced. 2) calculate resonant frequency 3) the current at resonance 4) the Q factor