What distinguishes the old telephone networks and exchanges from their digital equivalents is the use of analogue technology.

Q: The amplitude of the voltage source is x=75V, then find ZL for the maximum average power transfer…

A:

Q: 5. We have seen that a differentiator has the Fourier property dx (t) dt ⇒jwX (jw) The derivative of…

A: ii) we need to find the ratio of this transfer function to the true transfer function of…

Q: Note: the value of each flip-flop, before the first clock pulse, is “0” so initially the state of…

A: The value of each flip-flop, before the first clock pulse, is “0” so initially the state of the…

Q: 1. For the circuit shown in figure 4, write the Boolean expression for x, y, z and F A- Вс C- D-…

A: Consider the circuit

Q: For controlled half wave rectifier, R=44ohm, f=50Hz and Vm=280V and a=0,9 rad. Calculate the rms…

A:

Q: the voltage VR1 VR2 wwwwwwww R₂=1022 R3=1502 R₁=502 using Vs=100 V VR3 oltage rule

A:

Q: 2) Fill in waveforms for Q and D_OUT D P.. D_IN CLK CLK D_OUT D_IN D_OUT Ti

A: given logic diagram is

Q: H.W: What instruction would you select for each of the following discrete input field devices to…

A: Devices that receive discrete digital signals—also known as digital input devices—can only transmit…

Q: For the system shown in figure below, Answer the following Question 1-  Which root locus is correct…

A: In this question we need to find the following Which root locus is correct  How many Poles in the…

Q: The discrete time x[n] signal is defined as x[n] = 28[n+ 1]+ (3- n)(u[n] -u[n - 3]). Accordingly,…

A:

Q: Vx I X R₂ R₁R₁VB D₁ Ideal In the circuit above, plot Ix and IR1 as a function of Vx for two cases:…

A: We need to draw graph between voltage and current for given circuit.

Q: The circuit shown below has a sinusoidal input voltage given by v(t) = 15 cos(10t + 20°) V Find the…

A:

Q: The rectifier above drives a 950-22 load with a peak voltage of 3.15V. For a 100-µF smoothing…

A: RL = 950Ω, peak voltage = 3.15V. C= 100-µF, calculate the ripple amplitude if the frequency is 50…

Q: Q3. Find I1, V₁, and V2, and write the answers in polar form. 2/30° V 292 A 2/45° A -j22 {202 2/60"…

A:

Q: Consider the four- input NOR logic gate in figure below, The transistor parameters are VTNL =-IV,…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: For controlled half wave rectifier, R=80ohm, f=50Hz and Vm=280V and a=0,2 rad. Calculate the average…

A: It is given that: R=80 ohmf=50 HzVm=280 Vα=0.2 rad=0.2×180π=11.46°

Q: In the circuit shown in the figure, the switch #2 can be toggled to either position a or b. In…

A:

Q: Neat handwritten solution only PLEASE

A: Given: A discrete time complex signal,  x[n]=ej83πn+ej5πn+π3, To find: Fundamental period of the…

Q: Resistors connected in series-parallel combination Resistance combination Rab b 24 Vdc Figure 5.2…

A:

Q: Question 3) The amplitude of the voltage source is x=55V, then find ZL for the maximum average power…

A: For the given circuit we have to find the thevenin's equivalent value and the maximum average power…

Q: The circuit shown below has a sinusoidal input voltage given by v(t) = 25 sin(30t - 10°) V 120 0.15…

A: given input voltage is  v(t) = 25 sin30t -10° V  In polar form  v(t) = 25∠-10° V frequency  ω =30…

Q: 2. approach. In the network given below, find i, (t) for t> 0 using the differential equation

A: Need to calculate the value of current flowing through the inductor using the differential equation…

Q: For the Figure: L 3 A O 11 1₁ R₁ and B2-6 az www Vab R₂ 3 Ω 12 E 6 V RA www 6Ω R3 www + E34V

A:

Q: In the circuit above, plot lx and IR1 as a function of Vx for two cases: VB = -1.5V and VB = +1.25V.…

A: Given: A circuit,  To do: We have to plot Ix and IR1 as function of Vx.  a) When VB= -1 V, b) When…

Q: In case of 4-pole D.C. generator provided with a two layer lap winding with sixteen coils, the pole…

A: A DC generator with, Total number of poles, P = 4. Two layer lap winding.  Total number of coils =…

Q: For the system shown generate the transfer function J1= 2 kg*m² J2= 40 kg*m² D1-10 N*m/(rad/s) D2=…

A:

Q: The two-stage MOSFET amplifier in the figure below has the parameters as follows: mA Kp = 11 V2Kn =…

A: We need to calculate the  1) Voltage gain 2) Input Impedance 3) Output Impedance The dc parameter of…

Q: 5- a. For the series resonant circuit of Fig. (10), find I, VR, VL, and VC at resonance. b. What is…

A: In this question We need to determine the all unknown parameters.  We know Current in the impedance…

Q: Consider the circuit shown in Figure below. Take io = 20 mA. (Figure 1) Figure 40 x 0 12 10 μF 0…

A: current io = 20 mA  after switch open and doing source transformation circuit becomes…

Q: Let v = 60 cos(200t - 10°) V. 2 ΚΩ 100 mH m ΓΚΩ 10 με ΙΚΩ

A: Supply voltage; Vs=6 cos200t-10° V Inductance value; L=100 mH Capacitance value; C=10 μF Resistance…

Q: Determine the small-signal model of Q1 for the circuit above. (Is = 8 x 10-16 A, B = 100, and VA…

A:

Q: For the shown root locus in the figure below, answer the following questions 1-  Number of Poles…

A: We answer the following questions we use root locus.

Q: Find the Thevenin and Norton equivalent circuit at terminals a-b for the circuit shown below, where…

A:

Q: What is the electric field intensity at point P in the space- with three infinite planer charge ?…

A: We need to find out the electric field for the given charge distribution.

Q: 4. What will be resistance between A and D when The star is transformed to Delta 0.50 P 0.25 (2 (a)…

A: given that a star resistance network converted to delta…

Q: 1 V₁ 12.6 V D₁ 2 IDEAL_DIODE R₁ 12 kn What is the current through the diode?

A:

Q: 4.24 Use ABCD matrices to find the voltage V₁ across the load resistor in the circuit shown below.…

A:

Q: 6. Given f(t) = 2u(t), g(t) = e²tu(t), and q(t) = f(t − 1) * g(t), determine q(4).

A: Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Find vo for the circuit given in the figure, assuming that Ug = Vs с HH 292 = (6 cos (2t) + 4 sin…

A: In this question we need to find the voltage Vo shown in the given circuit.

Q: (7) Determine Is,Ic,IE, VB,and Vc in the following figure, where Bpc is 48. ww Rc >1.2KQ Vac 14.

A: Circuit diagram is given as,

Q: Circuit Parameters/- Vcc=7.7V, Is = 5.2x10-16 A lg = 7.8 μA, B = 100, VA=00, Re=200 02, Rc=1 k Rc…

A: In this question,  We need to determine the collector current IC  as shown the circuit.

Q: What will be the fundamental frequency for the following circuit if each inverter delay is 100 nsec?…

A: Logic circuit, Each inverter delay is 100 nsec. Propagation delay of one gate, Tpd=100 ns. Number…

Q: Assuming an ideal op amp, design and draw the circuits for the following. Your resistor values must…

A:

Q: 6. C = 1/2 F. Determine the type of damping exhibited by the circuit. 7.3.10 The parameters for a…

A:

Q: A DC permanent magnet motor has a windings resistance of 20 Ω. At 10 Volts, the motor current under…

A: at no load : supply voltage (Vt) equals to back emf Eb in the motor that is    Vt = Eb. Vt = 10 V no…

Q: 3) Calculate Va in the circuit below. 8/90° A 4Ω m 20 ΜΑ ΣΩΣΤ 420" A -3 Ω ΖΩ αλλά 24/0° V

A: In this question we need to find the voltage Vo using mesh analysis. To use mesh analysis we need to…

Q: -2m. ——2.5m- -4.5m-

A: In this question we need to find the following Find the capacitance value of a phase Find the…

Q: Q5) A disk charge of radius a-1 m exits at p <a & z= 10 m carries charge of density ps= 20 nC/m².…

A: Electric field is force per unit charge.  Electric flux density is given as product of permittivity…

Q: 2 Tovo =R₂ For the circuit above, draw a rough sketch of what the output voltage would look like.…

A: Given: A half wave rectifier with capacitor attached in output,  with input as sinusoidal signal…

Q: Create a logic circuit system for the following expressions. A'B'+ABC (XY)'Z X+Y+Z

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…