What is binning and what is it used for? A. This is the approach of separating the obtained fluorescent light to several detectors at once, which increases the sampling frequency.  B. It is a matter of combining the load of several pixels as if it came from only one pixel, which increases the sensitivity and speed of detection but reduces the spatial resolution. C. It is a strategy to increase the gain of the camera to get a stronger signal in low light conditions, even if it means getting more saturated pixels. D. This is the use of a detector that is always on, so that photons emitted under very low fluorescence conditions are detected more quickly and more

Q: Find the Fourier transform of the signal below. Show the details of your work. Write your answer on…

A: In this question We need to determine the Fourier transform of the signal.  We know

Q: 5. The figure below shows two star connected loads with three phase power. The voltage source is…

A:

Q: Consider the following second-order difference equation: y[n] +1.4y[n − 1] +0.45y[n − 2] = x[n] −…

A: Considering the second order difference equation, yn+1.4yn-1+0.45yn-2=xn-xn-1taking z-transform on…

Q: True or False 1.Basically, the rotor speed of the synchronous motor decreases as the load…

A: 1) Basically, the Rotor Speed of the Synchronous Motor Decreases as the load Increases. TRUE   2)…

Q: For the circuit below if i(t) = 3 + (A1 + A2t) e^-2t, find A1 and A2. 12 V (+ (A) B C D 4Ω ww A1 = 6…

A: At steady state inductor acts as short circuit and capacitor acts as open circuit.  Inductor does…

Q: ← Introduction to Control... The maximum a transformer temperature rise of is 50°C. It attains a…

A:

Q: An 8-pole, lap-wound armature has 1200 conductors and a flux per pole of 0.03Wb. Determine the…

A: It is given that:- P=8 Z=1200  ϕ=0.03 Wb N= 500 rev/min E(emf) = ?

Q: What type of response does the circuit below has? X 4.5 A (4 20 Ω t=0 A) Overdamped B) Critically…

A: In this question,  We need to choose the correct option We know A system is called over damping  if…

Q: A 75 2 transmission line is first short-terminated and the minima locations are noted. When the…

A: This is a problem of transmission line. The detailed solution is given in the next step

Q: What is the Laplace transform: L[2√°C (z)] az

A: QUESTION Find Laplace transform           L  [ 2  ∫t c(τ)]dτ

Q: Q1: Use nodal analysis to find Vo 6V 12 ΚΩ 20001. 4 ΚΩ x ww 2 ΚΩ 2 mA 4 ΚΩ Vo

A: Given circuit is

Q: Determine the node voltage Vx and the current Ix of the circuit, using (a) mesh analysis and (b)…

A: The required parameters can be calculated by using mesh and nodal analysis. The equation can be…

Q: Find the characteristic roots, s1 and s2, of the circuit below. 12 V (+ A B C D 4Ω S1 = 2 S2 = 5 S1…

A: For t>0 draw the circuit and apply KCL and write the differential equation governing the inductor…

Q: A 230 V dc shunt generator delivers 150A with friction loss of 1200W. The armature shunt field…

A:

Q: Given magnetic flux density, B = p a find the total flux crossing the surface = x/2, 1 s p ≤ 2 m and…

A:

Q: True or false  1. One of the alternative of using DC Voltage is to use inverter. 2. In long-shunt…

A: Given: Statements regarding power system. Power system: Power system is a branch of electrical…

Q: A belt-driven, 150 kW shunt wound dc generator is running at 450 rpm, full load to a bus bar at 240…

A: In this question,  We need to determine the speed of the motor.  We know, flux is constant in DC…

Q: Find an equivalent circuit for the arrangement depicted in the figure when looking towards the right…

A:

Q: G(s)H(s) = K(s+2)(s+1)/(s-1)(s-2) Make an accurate plot of the root locus for the given system…

A: Given: GsHs=Ks+2s+1s-1s-2 Required: Make an accurate plot of the root locus for the given system…

Q: 17 (22). Figure P24.17 is a graph of the potential change according to the x- coordinate when the…

A:

Q: What is the current trend of distribution substation? Can you give me an example.

A: The electric power distribution system is the last step in the supply of electric electricity. It…

Q: d , e

A:

Q: Q3. For a message transmission, the carrier v, (t) is modulated by the message m(t) with the form…

A:

Q: Hello, I just need help with PART A, PART B AND PART C AND can you label which one is which and can…

A:

Q: Consider a message signal 4cos2 1000t (volt) phase modulating a carrier signal 2cos2π10ºt. Assume…

A:

Q: 3) a) First put the numerator and denominator in exponential/polar form then find all

A: Given: F=-1-1i-2+12i-3+1i14

Q: The 'R+LC' circuit shown in figure 1 is an RLC circuit with a resistor followed by a capacitor and…

A: Given parallel RLC circuit: Let vc(t) be voltage across capacitor Since elements are in parallel, we…

Q: What type of response does the circuit below has? 4Ω A B www 1 H m 2u(-t) A + 50u(t) V 0.04 F HH + 0…

A:

Q: Thevenin's theorem to determine current in the 1kΩ load resistor and Norton's Theorem to check.…

A:

Q: In the given common collector circuit, Vcc=5V and R₁ = 1kn. Note that the BJT has the 0.2V. Place…

A: BJT is a current controlled Device in which base current control the mode of operation of BJT  Mode…

Q: 5, P-P sine @ 1kHz € 2K M IKS ww TOK Vo

A: 5) To find the output voltage of the given op-amp circuit

Q: terminals a and b. 100 V 10 Ω 20 Ω 5A 30 Ω 14 Α 40 Ω

A:

Q: Three identical coils, each of resistance 10 ohm and inductance 42 mH, are connected in star and the…

A: For each connection find the current in the phase  then calculate the total power consumed using…

Q: wer quickly Q1: Find the Norton equivalent circuit for the following circuit with respect to the…

A: We need to find out the norton equivalent circuit for given circuit.

Q: 1. Neglecting air resistance, determine to what height a vertical jet of water could rise if…

A:

Q: Use a K-Map to find the simplest Sum of Product expression for F(w, x, y, z) = w'xy'z + w'x'y'z +…

A:

Q: 4. Find vo(t) in the circuit below, for vi(t) = e-*t, 252 ww v/(1) 1F + v (1)

A:

Q: A 250 V de motor has an armature resistance of 0.25 2. It is drawing an armature current o 25A,…

A:

Q: Given the information appearing in Fig. 4.2, determine: (a) Ic. (b) Rc (c) RB. (d) VCE. 12 V RB Ig =…

A:

Q: Determine the H(w) = Vo(w)/Vi(w) and the cut-off frequency for the circuit below. Show the details…

A:

Q: x(n). Z Z-1 2 -3 + + -0.3 0.2 2-1 y(n)

A:

Q: A separately excited dc motor operates at a rated terminal voltage of 240V. It has a total armature…

A: Given: Ia=35 A, Ra=0.22 Ω, kn=0.22, V=240 Volts. Required: Motor speed.

Q: Six group of batteries are in parallel. Each group as 10 cells connected in series, each has an…

A: We need to find out the equivalent resistance and emf for given battary combination , we need to…

Q: Find the mesh currents i1, iz, and i3. 20a 16л ти 3ib 11 i3 In: тас Va + In in ти iz (1) 3

A: Given here a circuit and asked to find the mesh currents

Q: 3. Evaluate the following. Express your answers in polar form. a. 5+j30 4-j6 2 <15° 6+j4 14+j8 b.…

A: It is given that: b 28∠65°45∠-30°6+j8+5∠18°

Q: docs.google.com. Q.11 Choose the greatest range of frequency that makes the circuit shown act as a…

A: Given,

Q: Q4.The transmitted message from Q3 is received at the receiver (Rx) to extract the message, where…

A:

Q: Implement the following Boolean function f(A,B,C,D)={ 0,3,4,6,8,11,12,15) using two of 8-to-1…

A:

Q: 1. Calculate for the power delivered to the 2-kΩ resistor. 2mA (1 3ΚΩ ww 12mA ΣΚΩ ww ΙΚΩ GmA

A:

Q: A 220 V, 15 kW, 850 rpm, shunt motor draws 62.2 A when operating at rated condition. The resistances…

A: