What is the current in the 12- 2 resistor when a potential difference of 100 V is applied to the circuit in the figure below? R1 100 R2 R4 120 40 R3 140 R5 80

Q: blanks: be consumed by the Ho The two windings of a transformer is linked Three phase synchronous…

A:

Q: A4 The maximum power dissipated in a 4 22 load is 100Wwhen connected to a d.c. voltage 'V' and…

A:

Q: 7. The system of Figure 9.4 shows a 3-phase Y connected generator feeding a A connected load. If the…

A:

Q: For the system shown in figure, the line impedances are as indicated in per unit on 100MVA base.…

A:

Q: Explain about the testing of circuit breakers

A: Given: The objective is to give an explanation about the testing of circuit breaker

Q: Q3:- Calculate the electron and hole concentration under steady-state illumination in an n-type…

A: We need to find out electron and hole concentration

Q: 30. The waveforms in Figure 6-81 are observed on the inputs of a 74HC151 8-input multiplexer. Sketch…

A: When enable(bar) input is low then the multiplexer works. If enable(bar) input is high then the…

Q: Question No.95 What is the number of right half plane poles in closed-loop transfer function: C(s)…

A: Given the closed-loop transfer function, CsRs=505s5+35s4+30s3+210s2+40s+280

Q: The switch in Fig.4, has been in position a for a long time. At t-0, it moves to position -…

A:

Q: 22// Find the current at 10 2 by using hevenin's theorem? 292 192 10v +11+ 592 VIL 1092 H 20v

A:

Q: Use Norton to solve for the current and voltage at 10 ohm resistor. 1 20 Ω 2 Μ 10 Ω 3 120 V 30 Ω 40…

A:

Q: I₁ 120 V 1. Calculate the current I1, I2 and 13. 2. Calculate the total power dissipated in this…

A: Consider the the given circuit with the values of the resistance.

Q: generate radiation in antenna dipole

A: Frequency modulation- When modulation is done by taking frequency of information signal modulated…

Q: Consider the following network. What is the value of current 1₁ ? O-4mA O none of the above. 8 mA A…

A: Given circuit,

Q: The switch in Fig.4, has been in position a for a long time. At t-0, it moves to position H…

A: We need to find out the current for given circuit

Q: After execute MOV AL,00H, the ZF and PF are not affected PF=ZF=0 O PF=0, ZF=1 PF=1, ZF=0 PF=ZF=1 O…

A: Brief description : For the above given questions we need to check status of all the flags under the…

Q: In the circuit shown below power factor is ΘΩ +j2Ω th Μ 12Ω7 j5023

A: Given circuit:

Q: A current of 10 A flows in a coil having 125 turns. If the coil inductance is 50 mH, the flux…

A:

Q: 5. As depicted in Figure 9.3, a 3-phase A connected generator feeds a Y connected load. The…

A: Given data, Line current VL=120V                    Vph=120V Impedance (Z) =5ohm

Q: For the 3-phase, 3 wire system below. Compute for the line currents, total real power, total…

A: Convert star network to delta by using Z1=ZaZb+ZbZc+ZaZcZb…

Q: A resonant circuit has a peak output voltage of 4.5 mV. What is the voltage output at the upper and…

A: Given, In a resonant circuit Peak output voltage, V0peak=4.5 mV

Q: V2 (s) For the network shown Figure 1, determine the voltage transfer ratio V₁ (s) gain, poles and…

A: Brief description: For the above given second order system we need to calculate the transfer…

Q: The switch in the given figure has been in position A for a long time. Assume the switch moves…

A: Given, The switch is at position A for long time. It is moved instantaneously from A to B at t=0…

Q: 5. Find the input impedance at 20 krad/s for the circuit shown in Figure 4. 3mH 200 £2 m 0000 3v |…

A:

Q: For the circuit shown below, R-10 KQ, L-20 mH, C-100 uF (assuming zero initial condition) Vo The…

A:

Q: where G(s)- s+1 S²+45+5 the poies of the closed loop system are OA-1 and 4 None OC2 and 3 OD t Of 1…

A:

Q: // Find I1, I2 & 13? here R₁= 1022, R₂-4022 & R3-2092 =10v & v2=20v R₁ V₁ R₂ R3 V₂) I

A: From the given network, calculate I1, I2, I3

Q: or the transfer function: 1 G(s) = s² + s +1 nd the (a) impulse response (b) step response to this…

A:

Q: 2. The Illogic Company has developed a new logic family which has the following characteristics: VOH…

A: A group of logic circuits built with power supply and compatible logic levels known as a Logic…

Q: Β1 Using KVL, find the currents through R₁ and R3 in the circuit shown below. b) R₁ R3 ww 1Ω 4Ω B₁ 2…

A:

Q: Q3: Find hybrid_parameters for the network in figure re ΤΩ ΖΩ Figure 2 ΖΩ ΤΩ 141, 228

A:

Q: Find hybrid parameters for the I' network in figure ". ΤΩ 2Ω 2Ω ww ΤΩ •41 ΖΩ I, Ο +

A: In this question,  We need to determine the hybrid parameters for the given network ?  We are…

Q: Q3: Find hybrid parameters for the network in figure *. 1Ω ΜΕΤΑ 2Ω 2 Ω 1Ω www. 41₁ 2Ω

A:

Q: H.W. a. Find the voltage v, for the circuit in Fig. 8. b. Sketch the v₂ and i curves and phasor…

A:

Q: Fourier series and spicfy the type of symmetry it has (2) plot the amplitude and phase spectra. f(0)…

A: A signal which repeat itself after a fixed interval of time is called periodic signal. Fourier…

Q: For figure2; (1) determine the Fourier series and spicfy the type of symmetry it has (2) plot the…

A: Given figure is shown below. Time period is T=12sec given signal is even symmetry since ft=f-t.…

Q: 1. Determine the following for the network shown below: *Use Mathematical Approach a. ID b. VGS c.…

A:

Q: A three phase transformer of 220 / 11000 line volts is connected in star/delta. The protective…

A:

Q: The physical address of the following memory location specified in the instruction MOV [BX+0200H],…

A: Procedure to find physical address  MOV = DS*100 MOV BX = DS*10 +BX MOV BX+0200H = DS *10 +BX…

Q: A certain transistor is to be operated with VCE = 8V. If its maximum power is 100mW, what is the…

A:

Q: 10. A low-pass-filter has a cutoff frequency of 24 MHz. What is the fastest rise time that a…

A: Given data, A low pass filter has Cutoff frequency, fc=24 MHz

Q: Sketch and explain completely by writing both figures about the operation of Buchholz relay?

A:

Q: Determine the capacitance of each of the capacitors in the Figure below. Take: Er1 = 4, Er2 = 6, d=5…

A:

Q: The switch in Fig.4, has been in position a for a long time. At t-0, it moves to position E…

A:

Q: The shaft torque of a diesel motor driving a 100V dc shunt-wound generator is 25Nm. The armature…

A:

Q: H.W. (1) Find the total admittance and impedance of the parallel network of Fig. 23 10 kn Z₁ XL R6k0…

A:

Q: S-2 The transfer function of a system G(s) = find the zero-input response, " s²-s-2 assume all…

A: Brief description: In the above given question we need to calculate the value of zero input response…

Q: A wye-connected load with ZA= 12 /45, Za= 15/30 and Z=10 /0 is connected to a four-wire, 208 v…

A:

Q: SIGNAL Mention the function or work of each component in the circuit? + Vcc Rc2 Cc R₁ HH Cin HH R₂3…

A:

Q: 2. Determine the nominal resistance values of these resistors, given their band colors, and also…

A: Brief description: By the help of concept of colour coding of the resistor we need to derive the…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.