What is the current through the LED? R1 330 a LED1 LED_red 6 V

Q: B.a. The metal halide lamp is designed for a specific operating position. Which one of the following…

A:

Q: R1 = 100 S2, 1.0 ks2, 10 kS 2, 100 ks2, 1.0 MS2, or 10 MS2, 1% 1/4W D1 = 1N34A, 1N4148 DMM1 (+) R1 +…

A:

Q: Please give complete solution and give what the problem is stating thankyou Ill give feedback as…

A: Given: A circuit consisting of similar diodes in practical model. According to question: In…

Q: 1. Enter the color code and numerical values in the Table 1.1, for the four band "thin- film" carbon…

A: Color code and numerical code is entered in table as shown below

Q: Determine the current flowing through the LED if its forward voltage is 2.0 volts. * D1 D3 R1 1K 5V…

A:

Q: Determine the current flowing through the LED. (assuming its forward voltage is 2.1 volts) * A D1 D2…

A:

Q: Q11. What is LED?

A:

Q: A 9V battery is connected to two parallel plates that are separated by 2cm of air. What is the…

A:

Q: Identify Rth and Vth for the circuit shown. 1202 310 2 R 32002 Rth: ohms (ROUND TO THE NEAREST WHOLE…

A: Thevenins equivalent

Q: Find the color of the FF. resistance value. B. 1MΩ

A: It is given that: R=1 MΩ

Q: 41. A silicon solar cell produces about a. 0.5 volts/cell b. 1.0 volts/cell C. 1.5 volts/cell d. 2.2…

A: Approximate value of the voltage across Silicon diode is 0.5 to 0.7 volt per cell so the closest…

Q: Find the energy absorbed by the element over a 10 seconds interval, when voltage is 4V and current…

A: In this question , we will find energy absorbed by  element with given data...

Q: b) Find the value of the resistance and its error part (give your results in two form such that %…

A: Given, Color code of resistor Green-Blue-Violet-Gold

Q: Try to do calculation based on the value given and   Find value of ammeter for each resistor…

A: According to the question, for the figure shown below We need to calculate (1) The value of the…

Q: QUESTION 1 You wish to turn on the four most significant LEDS in the LED pack on our board. Before…

A: As per company guidelines we are supposed to answer only one question because are interlinked.…

Q: Problem #1 Given the Circuit 1 BAT1 9 V ww R1 D1 RED Circuit 1 1.1 What is the Maximum value of the…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Calculate the value of R resistor for LED current 20mA.

A:

Q: Complete the information in the table about LEDs Cod No. 334-15/X2C3-1TVA

A: the LED (light-emitting diode ) 334-15/X2C3-1TVA is generally manufactured by the everlight From the…

Q: Give the drain current equation of JFET.

A: The output characteristic of a JFET is shown in the figure below:

Q: Rd 1 M Ohm Hidss%3D8MA, Vp =-2V 350 k Ohm 068kOhm

A:

Q: Figure out the amount of time these devices would need to be in operation before 1 million Coulombs…

A: Given data, Charge Q=105 C (a) i = 0.0041 A Charge is given by, Q=i×t105=0.0041×tt=2.43×107 sec

Q: Find Vout 10 ohms SVMM 100 ohms + • Vout

A:

Q: Give an electronic device which can be found in your house that uses both AC and DC

A: In our house-hold electronic devices like Mobile,laptops ,digital watches uses batteries which  uses…

Q: First blank choices: a.) D1 b.) D2 c.) No LEDs d.) both LEDS Second blank choices: a.) D1 b.) no…

A: We can draw the circuit as When we close the switch SW1, then the emitter diode of the transistor…

Q: How many lumens are there in natural daylight b. Amount of light given per second from a particular…

A: In this question we will write about how many lumens in light hitting the sun and amount of light…

Q: D2 D1 D3 R1 1K

A:

Q: A 1000 ft length of No. 8 AWG copper wire has a resistance of 0.628 ohm at 20∘C. Determine the…

A: Given data:         ength of copper wire=l=1000 ftCross section =8 AWGResitance of wire,R=0.628 Ω We…

Q: For the Turn ON voltage of different LED's refer Table 1. Table 1 Type of LED Red LED Turn On…

A: The circuit diagram is, From the table, the turn-on voltage of the orange and blue LED is,

Q: First Approximation: Total Current = A Total Resistance = ohms Voltage across R1 volt %3D

A: First solve the network by using diode as a 0.7 Volt battery then find the current and rest…

Q: Determine current Vo1 in volts, when E=18V, R1=1417 ohms, R2 = 2940 ohms.

A:

Q: Question 2 Determine number of electrons transferred when a current of 5mA flows a fixed point for…

A: Given data, Current, I=5 mA Time t=10 minutes

Q: Write about any two geothermal power plants. Write the Significance of Geothermal Energy

A: The enormous amount of energy available inside the earth in the form of heat is known as geothermal…

Q: -10 micra coulomb 20 cm 30 degree +5 micro coulomb +5 micra coulomb

A: We can observe that there is an equilateral triangle with the following values AD=20 cm=a…

Q: You wish to turn on the two LEDs located at the outside of the LED pack, so the first thing you will…

A: Al means lower 8bits of the accumulator here, we want to turn on the two LEDs located at outside of…

Q: Q2/Answer Any Two 1. State the applications of Clamper.2- What are the disadvantages of LED? 3- Why…

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: KL 33006

A: An encoder is a device that converts information from one format or code to another format or code,…

Q: 17 Determine the current flowing through the LED if its forward voltage is 2.1 volts. * D1 R1 5V 1K

A: The solution is given below

Q: What is the accuracy of a measurement of 26.5gm taken as against 25gm?

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again. The…

Q: 4. Determine whether or not each of the following systems are (i) yon) = |xcn)| (i) ycn) = xC2n)…

A: Linear system have superposition and homogeneity property.

Q: Indicate which of the following statements refer to LCD displays and which refer to LED displays:…

A: (a) Emit light- LED display (b) Reflect ambient light- LCD display (c) Are best for low power…

Q: otal charge is 750 microcoulomb . Determine values of V1 , V , and C2 .

A: When the same charge is present across all capacitors, they are in series. When same potential…

Q: The efficiency for incandescent light bulbs is typically about 14 lumens per watt (lm/W) and that…

A:

Q: If the measured values of R1 = 323.1 Q, R2 = 324.2 Q and R3 = 324.7 Q, calculate the difference in…

A: Since you have asked multiple question I will answer the first part for you . Since R2 and R3 are in…

Q: 5V A D1 R1 500

A: We need to find out the current for given circuit

Q: What is the value of the resistor shown below in ohms? Don't use scientific notation.

A: Color Coding of Resistors:- Since resistors are often small, it is challenging to print resistor…

Q: 3) Calculate the reşistance od a (100m) wire having a cess-sectional area A Od mm) and resistivity…

A: To find the resistance of a wire  And new resistance when it's length is increased to three times

Q: PS1 (1) Determine the voltage and current meter indications in each circuit. .3kOhm RS 2.7k0ha D7…

A: The above circuit is connected in Easy EDA and Circuits cloud using si diodes

Q: 5 Determine the current flowing through the LED. (assume an LED forward voltage of 2.1 volts) * A D1…

A: The solution is given below

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.