What is the current through the load

Q: Please Answer the following: 1(a):  Recall that NAND is a universal gate. Implement an OR gate…

A: The OR gate needs to be implemented by using the NAND gate and the NOR gate needs to be implemented…

Q: Vs(t) Let vs(t) = e-3tu(t) (in volts), R = 3 mQ, C = 3 F, and vc(0") = 0. Then the current…

A: Given:A circuit, with  and the current flowing through the circuit is, we need to find:the value of…

Q: In the figure, & = 119 V, R₁ = 9.01 Q, R₂ = 29.20, R3 = 38.30, and L = 2.34 H. Immediately after…

A: The inductor opposes any sudden change in current. In steady state, the inductor behaves as a short…

Q: 232 for owin I Check discreze time signar description = linearity, T C x cm) } ก X (ก) for in or ion…

A: Given y(n) = T{x(n)} = n x(n) Need to find this output system y(n) is linear, causal, memory and…

Q: (c) Your friend Lynn Year looks at this circuit and says this can be modeled as a voltage controlled…

A: According to the question, for the given circuit as shown belowWe need to find the value of…

Q: 3. Consider the precision rectifier depicted in Fig. 8.58, where a parasitic resistor Rp has…

A: For a given precision rectifier the waveform at the nodes X and Y needs to be drawn based on the…

Q: A supermarket has a one entrance-door and one exit-door. The customer capacity of the supermarket is…

A: According to the question, we need to write the FBD program.

Q: Suppose a system uses bipolar symbols such that a data 1 is transmitted as a period at 1 V and a…

A: According to the question, a system uses bipolar symbols such that data 1 is transmitted as a period…

Q: Question #13: Hand draw the Bode Diagram (both magnitude and phase plots) for the following transfer…

A:

Q: This circuit represents a small signal amplifier.If C1= 1.5 µF, C2= 0.43 μF Assuming the transistor…

A: The amplifier circuit is given ashere

Q: In, suppose that E = 50.0 V, R = 240.0 2 and L = 0.170 H. With switch S₂ open, switch S₁ is left…

A: Since you have posted multiple subparts in this case we will solve the first 3 for you,The circuit…

Q: A +12V G R1 3.3 k 5 11 R3 www B 68 KR5 F 14 5. 12 R2 4.7 kO 33 k R4 www C 6.8 k R8 E 13 R7 2.2kO www…

A: given

Q: Part A Derive the expression for the current f (t) for t>0. Express your answer in terms of the…

A: The circuit diagram,

Q: Calculate the total complex power ST= Calculate the total impedance and power factor ZT= pf = 2 L=…

A: In this question, we need to determine the total complex, apparent, average, and reactive power also…

Q: Calculate the K value that makes the steady state error "0.2" when the R input is a unit step. R…

A: We need to find out Value of K for given steady error for given system .

Q: What’s a complex example of a Non-Inverting Amplifier?

A: According to the question, we need to discuss a complex example of a non-inverting amplifier.

Q: Please give me a complex Non-Inverting Amplifier circuit.

A: According to the question, we need to discuss a complex example of a non-inverting amplifier.

Q: 2- Use mesh analysis to find current io(t) in the figure below. ( 1 µF HH 10 cos 10% V 2 kf2 io 0.4…

A: The circuit diagram,

Q: If the total power is 450 kW in a power measurement of a 3- Phase delta connected load by 1-…

A: Total power = 450 KW

Q: Q21. Consider a star-connected system with a reactance of 692 and resistance of 852 per phase is…

A:

Q: Q3. Find I1, V₁, and V2, and write the answers in polar form. V₁ 3/30° A -jΖΩ να ΖΩ ΖΩ 3/60° A

A:

Q: Compute the primary current for (a) I' = 10 A and ZB = 1 , for (b) I' = 13 A and Z³ = 1.3 №. (c)…

A: The type CO relay consists of an over current unit (CO), an indicating contactor switch (ICS), and…

Q: For the next four items, consider the circuit shown below that is assumed to be operating at 1 kHz.…

A:

Q: 4. Derive the transfer function, H(f) = Vou / Vin and draw the asymptotic(approximate) Bode…

A: For the given circuit the transfer function of the circuit needs to be calculated, type of filter…

Q: In the circuit shown in Figure P4.a, the switch is closed at t = 0. The capacitor voltage is charged…

A:

Q: 4 mA V₁ R₁ · 0.5 ΚΩ R₂ M 1 ΚΩ tii 5 V V₂ R3 2.5 k

A:

Q: Calculate the in the most simplified form, for the given block diagram Find the result for G₁-G₂- GI…

A: We need to find out transfer function for given bolck diagram.

Q: Consider the circuit shown, where = 18.0 V, R₁ = 150 2, R₂ = 15.00, and L = 9.00 H. E a R₁ R₂…

A:

Q: Use nodal analysis to find current i, in the circuit. Let i, 6 cos(200t + 15°) A. 0.1 vo is 20 2 Vo…

A:

Q: It is known that G (s) = Jansone (s + 0.5) s² (s + 1)(s + 3)' For the unity negative feedback system…

A: The type of system is obtained from open loop transfer function by observing the number of open loop…

Q: A circular ring of charge of radius a lies in the x-y plane and is centered at the origin. Assume…

A: The radius of circular ring, The charge density,

Q: VI 12V + ov 1k0 RI 1k0 RS R3 1k0 Figure 2: Circuit 2. 1k0 R2 5. What is the total electrical…

A: The circuit diagram,

Q: 1. For the circuit below, Vi(t) = 10cos(500t), R₁-502, R2-10092, C-47μF and L=50mH. Find the current…

A:

Q: Find the Thevenin equivalent circuit at terminals a - 30 92 120/45° V+ 01 60 92 = www Vth Vn 402 V,…

A:

Q: Write a FBD program for the follwing scenario: There are ten leds on a protoboard and one button…

A: According to the question, we need to write an FBD program for the following scenario: There are ten…

Q: Find the gradient of the following scalar functions.   a) T = 3/ (x^3 + z^4)

A:

Q: For the given circuit, determine the total impedance, total current and total phase angle. C2

A:

Q: o not give answer in image and hand writing

A: ddddddd

Q: 1. Us 12052 €400. M 202 I tas f 300P +1, U₂ Find the transfer function H(s) = Vo(s) Vs(s)

A: In this question, we need to determine the transfer function. We solve this problem using the…

Q: 2. For the below figure 34 a) Derive the output and minimize the output function using Kamaugh map…

A: Given:a figure, we need to do:a) derive the output and minimize the function using k-map. b) draw…

Q: For the circuit shown in 2, if the power dissipated in R₂ is compared to an ideal network with R₁ =…

A: We need to find out power dissipation in R2 for given circuit.

Q: using the methodology of meshes and supermeshes to achieve a better understanding of the method. Get…

A: Given circuit:Asked to find the mesh currents and power delivered by the current source by applying…

Q: Determine the unit sample response {h(n)} of a linear-phase FIR filter of length M = 4 for which the…

A: we need to determine:unit sample response h(n) of a linear phase FIR filter of length M=4. where,

Q: Study the circuit below. What will happen when SW1 is closed? What will happen when SW1 is opened?…

A: The given circuit of the problem is shown belowNow let us analyze the circuit and the components in…

Q: Calculate the maximum horsepower of an induction motor at 0.8 power factor and 85.5 percent…

A:

Q: Find the transfer functions for the following block diagrams:

A: For the given block diagram the transfer function of the system needs to be calculated.Based on the…

Q: For the next three items, consider a series R-L-C circuit energized by a sinusoidal voltage source…

A: In this question, we need to determine the phase angle between voltage and current. Also need to…

Q: A 100 kVA, 2500/125V, 50Hz, step down transformer has the following parameters: RH = 1.5 Ω, Χμ = 2.8…

A: Given information,Rated output  kVA.Induced EMF ratio  Volts.So turns ratio is .Supply frequency…

Q: Find the current in the mian branch and V. AB

A: According to questions, we need to calculate main branch current and V.AB.

Q: 5. Metal Halide lighting is used instead of incandescent or fluorescent because_____ a. produces…

A: The question is about comparison of lights with respect to their properties.

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.