What is the difference between using a digital spectrometer card or using an ancient electric spectrometer (observation with the naked eye)? What are the advantages and disadvantages of each?
Q: help me calculate the Rn, In or Isc, and current at Zc using NORTON’S THEOREM
A: The given circuit is as shown below,
Q: Q2. (a) For the transistor circuit in Figure below, what is VCE when VIN = 0 V? (b) What minimum…
A:
Q: Question No. 1 The switch S₁ of figure 5 has been closed for a long time. At t=0sec, S₁ is opened,…
A:
Q: The voltage of a source is e = 220 cos (wt - 1200) while its three loads take currents given by…
A: A closed path, where electric current can flow defined as an electric circuit. It is various…
Q: In the system shown in the below figure, the switch is closed at t = 0. a Determine voltage…
A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…
Q: PID CONTROLLER IN TEMPERATURE CONTROL SYSTEM Please give me a paragraph of introduction about…
A: PID CONTROLLER SETTING IN TEMPERATURE CONTROL SYSTEM.
Q: S Two sinusoidal voltages of maximum values 120 V and 80 V, respectively but differing in phase by…
A: We need to find out the equivalent voltage for given voltages .
Q: What would you say is the best way to explain the typical synchronisation error known as a race?
A: Race condition is an undesirable condition in the system. It occurs when a device attempts to…
Q: Q1. An information as v/(t)=x (1) cos 10' √√3t, is desired to be transmited through a char If the…
A: Given circuit is shown below. Above circuit is Low pass filter. Transfer function is Vos=Vis×11+sCR
Q: Given an Emitter-Stabilized Bias Common Emitter amplifier with the following data: Vcc = 12 V, lc =…
A:
Q: Find the Req at terminals a-b
A:
Q: An air-filled coaxial line with e=₁ and µ-u, has a line inductance L'=(1/54)µH/m. What is the line…
A: We need to find out the capacitance of co axial cable
Q: Determine the transfer function of the given signal flow graph. R(S) 1 G6 G1 G2 A G3 1 G7 G9 G10 1…
A: Transfer function: It is obtained in the signal flow graph by using the mason’s gain formula. The…
Q: Mage
A: Given AM wave form is shown below. a. From the above figure The maximum voltage of a signal is…
Q: Q3:Obtain the solution of the following difference ec
A:
Q: 2. For the given two stage amplifier circuit, hfe's = ß's = 150 and VBE = 0.7 V. Determine Avs VCC…
A: Two stage amplifier: Two stage amplifier has two transistor that are connected as common emitter and…
Q: Q5: Apply the Nyquist criterion to determine stability for the following system. Suppose k=75. R(s)…
A: The system diagram is shown below, Where, k=75
Q: 12) If Vab = 223 Vrms in a balanced Y-connected three-phase generator, find the magnitude of the…
A: 12) Given: A balanced Y- connected three phase generator Line voltage, Vab = 223 Vrms To find the…
Q: ES An inductive load takes a current of 6 A and 1152 W from a 240V, 60 Hz ac supply. Find the…
A:
Q: Sketch and explain the output voltage using the ideal diode approximation. The generator signal is a…
A: In this question we need to Sketch and explain the output voltage using the ideal diode…
Q: Bandwidth of a signal in the 250…255 MHz frequency band, b. The gain in decibels of the system with…
A: Note According to the bartleby's guidelines we have to solve only first three subparts of a…
Q: Use Mason's Rule to reduce the following signal flow graph to a single transfer function. G₁(s)…
A:
Q: +||| VT = 15 V Fig. 5.5 W R₁ = R2 = 150 Ω R3 = 220 Ω = 100 Ω Series string resistance.
A: circuit is solve as first calculate req of circuit then calculate total current in the circuit
Q: 1. CALCULATE ALL THE CURRENTS AND VOLTAGES FOR EACH RESISTOR USING EITHER KIRCHHOFF'S LAW OR MESH…
A:
Q: Determine Vx in this circuit using Thevenin theorem. Draw illustrations if needed. Show complete…
A:
Q: mework 1: Find the Laplace transforms of these functions: r(t) = tu(t), that is, the ramp function;…
A:
Q: Given: 120V, 60H₂, 30, 6 Pole, Y-connected IM RI 0.08₁ X₁ = 0.3 S = 0.03 XM = 633 R2₂=0.07, X₂=03…
A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: Q.4 Using Laplace transform, obtain the i(t) in the circuit shown below as a function of time for t…
A:
Q: Solve index of modulation and Sketch each in "TIME DOMAIN a. Em= 5V; Ec=10V; m=? b. Em-10V; Ec-10V;…
A:
Q: (b) A 28 GHz plane wave of amplitude 1 V m-¹ is propagating in a material of conductivity = 2 S m¹…
A: Brief description: For the above given question by calculating loss tangent we need to define type…
Q: 2.Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. R LOKO
A:
Q: What is the luminous intensity of a 100 watt tungsten
A:
Q: Q1. Determine IE, VBE, VCE, and VCB in the circuit. Assume BDC = 150.
A:
Q: In a balanced three-phase Y-Y system, the source is an abc sequence of voltages and Van = 139∠12°…
A:
Q: Q. No. 2: Determine the values of i2, 14, V2, V3, and V6 in Fig.(2). -4V- 6 A SA ********** 6V A 2A…
A:
Q: The load shown below is connected to a 360 V, 50 Hz three-phase supply with a positive phase…
A: The load shown below is connected to a 360 V, 50 Hz three-phase supply with a positive phase…
Q: The received power and noise power measured at a receiver is 0.5 mW and 150 nW, respectively.…
A:
Q: 1. Find Ix in the circuit of figure shown below using Kirchhoff's law and Maxwell Analysis. 10 Q2 1…
A: To find ix in the given circuit using kirchoff's law and Maxwell analysis
Q: 2. A function f(t) has Fourier transform, F(w) = w¹e-². What are the Fourier transforms of: (a)…
A:
Q: From the figure shown below, find the modulation index, then write an equation represents the shown…
A:
Q: R(s) + 100 (s + 5) s(s+ 3)(s² + 4) System 4 FIGURE P10.1 c-) Find the gain margin and phase margin…
A:
Q: 2 A C3 C₁ C₂ C3 = 2mF C4 = Cs = G6 = 4MF VAB = 10V A) CTOTAL - B) Q TOTAL M VIORAL V₂4 = C₂ = Cs Y|…
A: According to bartleby expert guidelines I need to answer only two sub parts . I have answered the…
Q: (a) (b) Reduce each of the following state tables to a minimum number of states. Present Next State…
A: State table show the behaviour of sequential circuits and show that function stable and internal…
Q: rated load. If the driving engine(Pin) is developing 30 hp, and the armature resistance is 0.05 ohm…
A:
Q: Q2: If Z = - j 2Ω, find V, in the circuit using nodal analysis. 12230V +V, +V 2 2260 + j1Ω jin 0…
A: 2) To find the value of VL using nodal analysis
Q: Q1.Determine IE, VBE, VCE, and VCB in the circuit. Assume BDC = 150.
A:
Q: Q2.Find Q-point when VBB= 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. 1.0 KO RB www 20 ΚΩ Bpc = 50 t…
A:
Q: For V1=73 V, V2=71 V, R1=35, R2=21, R3-31 & C1=0.002 Farrad in the shown circuit, the switch has…
A:
Q: why is FM less prone to noise as compared to AM?
A:
Q: 5. Minimize given functions: i. F (C, D, E, F) = (1,3,7,8,10) +Eg(9,11,14) using K-map and realize…
A:
Step by step
Solved in 2 steps
- 1. What are the main components that make up a photoresist? 2. What is a two-component resist? What are the two components? 3. What does the concept of dose involve? 4. What effect does the dose have on the molecular weight of a negativeresist? (Does it cause it to decrease or increase?5. Identify one problem that can arise when positive resist is applied to athermally grown oxide wafer (silicon substrate). How can this problembe resolved?3. What are the main applications of using diodes in commercial power supplies such as laptop power supply? Please provide an original response, thankWhat are the main components that make up a photoresist? 2. What is a two-component resist? What are the two components? 3. What does the concept of dose involve? 4. What effect does the dose have on the molecular weight of a negativeresist? (Does it cause it to decrease or increase?) 5. Identify one problem that can arise when positive resist is applied to athermally grown oxide wafer (silicon substrate). How can this problembe resolved?
- 1- What is the appropriate display type (common anode/common cathode) that must be used with 7447 display decoder?Why?2- We would like to limit the current in the LED segments to 10mA. Assuming that the turn-on voltage for the LED’s is 1.7v, what is the proper value of the resistors to be connected between the 7447 decoder and the 7-segment display?3- Assume that the resistors provided in the lab are 220Ω. What would the current flowing into the LED’s be?4- Design a decade counter circuit using the 7490 counter, the 7447 decoder, and a 7-segment display. Show the pin numbers on the IC’s in your designExplain the principle used in Scanning Electron Microscope with advanatages, disadvantages and applicaionsCompare briefly between the practical and theoretical results.
- Describe how a LCD and Plasma TV work. Provide details about the nature of the pixels and contrast ratio, and source of light that each uses.Which photodiode array statement is false? All are true. Not all are exact Individuals may sample a variety. Seven valence electrons per two-atom hole Doping Si-cluster with group 3 atoms produces holes. Holes and electrons arise in N-Si doped with group 5 elements.What semiconductor materials would be more suitable for a single junction pv device for ground or roof based applications using absorption data for four semiconductor materials. Assume typical solar spectrum AM 1.5, and that materials have comparable absorption coefficients. 2. Based on data, can you suggest a photovoltaic devices with higher conversion efficiency than the one discussed in number 1? Explain your answer