What is the frequency of the waveform shown in figure 6? i 300 ms Figure 6

Q: C, 0.1u Vo R.1 M 1 E=-3 V

A: Given    Let us consider diode is ideal    Vd = 0V    The given circuit is a clamper circuit.   The…

Q: d) x(t) = 4Sinc(6t)Sin(150t)

A: We will multiplication property of Fourier transform.

Q: Determine the voltage for a 7mH indicator in response to a current given by I=10 sin(5300t)mA

A: To determine the voltage across inductor of 7 mH when a current of  I=10 sin(5300t)mA is passed…

Q: QUESTION 3 An inductor and a 330 ohm resistor are connected in series with a function generator. The…

A:

Q: 1) Datermine the electric field at point o. -29 a) I b) a a -24 O. a - 24 +9 c) Ver lon

A: NOTE: As per guidelines will be solving only 1st three subparts. Please repost for others. The…

Q: Two parallel wires made of copper are placed in air. The inductance of each wire is 0.9 µH/m with…

A: Two parallel wires made of copper are placed in air.  Total inductance L= 0.9uH/m What is the…

Q: Calculate the total inductance across A and B for the circuit in Figure 3. L1 L3 24mH 12MH 24mH Bi…

A:

Q: 5. In a series RC circuit, R = 5 ohms, C = 0.01 F, and E = 100 V. When t 0, i = 0. Find the charge…

A:

Q: The current waveform is 10 sin (ωt + 90) and that of the voltage is 25 cos (ωt - 90). What is the…

A:

Q: A voltage v = 300 sin (377t + 600) is applied across a circuit with pure element  and draws a…

A: First find the angle between current and voltage: θ=Vθ-IθWhere,Vθ=Phase angle of voltageIθ=Phase…

Q: Le 4e 5t cos (25at) u (t) 4 ASta 82+ bs te The numerical values are A= and c= |, respectively.

A: In this question,  Find the value of A, a, b, c as given.  We are solving this problem using the…

Q: Sheet no.3 1.Determine the reactions at A and B when (a) a = 0, (b) a = 90°, (c) a = 30°. 330 N -250…

A: given data

Q: What will be the branch voltage when Rx is adjusted to 162? What is the magnitude and direction of…

A:

Q: What will be the branch voltage when Rx is adjusted to 162? What is the magnitude and direction of…

A: Given, A network has given. We have to find the current and it's direction in Rx branch. Current…

Q: The direction of electric field E at point A is A : (x,0) Down Left Up Right Moving to another…

A:

Q: A 220 V D.C. generator is run at full speed without any excitation. The open circuit voltage will be…

A:

Q: Determine the total inductance of each circuit in Figure 3. ll 4 mH L2 2 mH 100 mH

A: The solution can be achieved as follows.

Q: bläi 5 When the number of poles increase then the electrical angle between the adjacent poles remain…

A:

Q: the number of permutations o time is 1512 e fe is get

A:

Q: choose the correct answer.

A: In this question we will find unknown current using kCL....

Q: It take C'to charge to 8 V in Figure 12-75? 38. How long does it take C to discharge to 3 V in…

A:

Q: amplitude is 0.1 A, What Is itor in the circuit? (L=1 H)

A:

Q: A resistor and an inductor is connected in series across an AC supply. In this circuit, the current…

A: In circuit resistor R and inductor L is connected in series. So this circuit is RL circuit. So…

Q: Two series resistors are connected to an AC source. If there is 6.5 V(rms) across one resistor and…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: For the waveform of Figure 6 below, calculate the period of the waveform: 120 Vp OV- Vertleal…

A:

Q: 4e 5t cos (25nt) u (t) 4 A- 8ta 82+ bste The numerical values are A = and c = respectively.

A:

Q: The 0.5-nF capacitor of figure (1) has the waveform of voltage shown across it. Calculate and plot…

A:

Q: Sketch the waveforms of voltage and current for conditions of a, b and c. For purely resistive is Z…

A: Across resistor voltage and current are in-phase. Across inductor current lags the voltage by 90°…

Q: ww 20 Ω a o ww 10Ω ww- 80 Ω 60 2 50 Ω bo

A:

Q: Which of the following could be the boundaries of the given shape? R=5 A=74° B=9°

A:

Q: long hme. Att=0, %3D ) The switch in the circurt has heen in poson "a" for a The Switch moves…

A:

Q: In the case of wave winding, each-4 coil will have fewer turns ( emf) of thicker wire (higher…

A: As we decrease the no. Of turn,  induced EMF will lower.

Q: 04: Calculate the R.M.S value of the current waveform shown in figure below. (t) 5 7 8 9 10 11 12 t…

A: In this question we need to find a RMS value of the given waveform.

Q: An AC current is given by i(t) = 200sinπt. It will achieve a value of 100 after _____ sec

A: This question belongs to circuit theory . It is based on the concept of sinusoidal analysis in…

Q: The current passing through the resistor 40 when t<0 is teo 0.02FV 0.02f: lov 30.5 H 1A 2A 10A 1.5A

A:

Q: How do you simulate a voltage source with 1000Hz 0-5V sqaure wave in ltspice?

A: LTspice, Multism, and MATLAB are important tools and libraries to analyze and design electrical…

Q: What is the value of voltage Vi? (magnitude and angle)

A: apply KVL in right loop to find secondary voltage . now using following formula find primary voltage…

Q: A 220 V D.C. generator is run at full speed without any excitation. The open circuit voltage will be…

A: The solution is given below

Q: What are the expected voltages at points C and D of this circuit? 10,000 0 10,000 0 12V 12 V

A: The two bulb connected in series each having a resistance of 10,000 ohms. At a point before the…

Q: If the effective voltage across a resistor is 65 V, then The maximum voltage is: Select one: a. 9192…

A: Given:- Effective Voltage across resistor = 65V

Q: The voltage across a 10uF is shown in the figure below. Determine the current waveform. Show all…

A:

Q: Find the current Io in the circuit shown.         Note: The current Io required is in MAGNITUDE…

A:

Q: Q6/For two infinite sheets X+ 1 The electric field intensity at x-2.5 is O o es āx V/m V/m E0 O 2 PS…

A: We need to find out electric field due given surface charge density.

Q: Determine the current lo if Is = 87 and R = 23. 22 22 ww Is 52

A:

Q: 4. A series circuit consists of a 100-2 resistor and an X of 80 2. If the applied voltage waveform…

A: To find the Total impedance ,power factor , current and power in the circuit

Q: resistance Randa 4 µ F capacitor are connectedin series across a 200 V d.c. upply. Across the…

A:

Q: The current thru a 0.5H inductor is 10t Amperes. What is the voltage across it in Volts? Do not…

A: The question is about voltage across Inductor. Given data, Inductance (L) = 0.5 H , i(t) = 10t…

Q: t = 0 20 60 30 20mH 2A At t=0 the switch is turned on. Find the current i̟ at t=5ms? ll

A:

Q: The total inductance of the circuit shown in Figure 3.1 is 34mH. Determine the value of inductance,…

A: The total inductance of the circuit is 34mH. The circuit is given as:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.