?What is the function of exciter It absorbs reactive power O It generates reactive power None of these O O It delivers D.C. power to the generator field

Q: Solve the approximate value of lc of Figure 45. VCC 16V $3.9kQ Q1 1.32 mA 1.44 MA 12mM 1.5 mA V R1…

A: Collector current. Current is the rate of change of the flow of the charges. The current that flows…

Q: For the root locus shown below, the break in point is -25 -20 -15 -10 03 O-18 -10+9i -10

A: Given: Root locus

Q: A balanced delta connected load having an impedance 20-j15 is connected to a delta connected,…

A:

Q: A single-phase ac voltage source has 200 Vrms and a system connected consumes an active power of 300…

A: Given: A single phase ac voltage source has, Supply voltage, V = 200 V (rms) Active power consume, P…

Q: Identify the source and load sides of a three-phase three-wire transmission system by a, b, c, and…

A: The reading of a wattmeter P is given by P = VI cos ϕ where V and I are the RMS values of voltage…

Q: 5.1 A 0.18-um fabrication process is specified to have t = 4 nm, µ = 450 cm²/V-s, and V, = 0.5 V.…

A: Given values: L=0.18 μm, tox=4 nmμn=450 cm2V, Vt=0.5 V Determining the capacitance per unit area of…

Q: The following are the symmetrical components of phase B current. Positive sequence component =…

A: In this question we need to find a positive sequence component of phase A  I.e     IA(1)

Q: 04) For the circuit shown below a)Find V and I b) IF R, is shorted, find I ww 20 R.100 w 302

A: In this question,  We need to determine the value of voltage v and current I as shown the circuit?…

Q: A diode is a two terminal device. The application of a voltage across its terminals leaves three…

A: Diode- Diode is an electronic device which has two ports for supply connection. It is made up by the…

Q: Solve the collector current of a voltage- divider bias circuit with Vcc=9V, R1-560k ohms, R2=560k…

A:

Q: 10. The primary and secondary winding of a 50 kVA, 6600/220 V transformer have resistance of 7.8 ohm…

A:

Q: Given Vo = 3.5 4122, V₁ = 5.0 Z-10, V₂ = 1.9 292, find the phase sequence components VA, VB and Vc.

A:

Q: of the system with specification given, Ka = 25,600? A.

A:

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the output voltage…

A: We need to find output voltage for given circuit

Q: Combination of Resistors deals with the equal current in series connection and equal current in…

A: given statement that combination of Resistors deals with the equal current in series connection and…

Q: For the circuit shown below if Vi is reduced to 100 mV, the voltage VL = pnp IL B V₁-200 mV R25KQ V₂…

A:

Q: Solve the approximate value of VCE of Figure 46. VCC 32.7ΚΩ V=10.6V Q1 V₂ R1 20uA R2 38.2ΚΩ Beta =…

A:

Q: 2) +5√ I&q=0.8 MA ود RB 3 B = 100 RB = 10k₂ a) re b) Bi, Zo, AV, Ais us fore Vo 4k 20 Rc = 4 km

A:

Q: * For the circuit shown below if Vi is = reduced to 100 mV, the voltage VL pnp + B R25 KQ VL V₁=200…

A: Given

Q: 270V 50 Hz 2002 VO Figure A2 The delay firing angle of the AC controller in Figure A2 is set at 65°.…

A:

Q: Refer to the given circuit below. Determine the Thevenin Equivalent EMF if R3 is to be analyzed. R₁…

A: given here a circuit and asked to determine the thevenin's equivalent emf to analyze the R3 .   here…

Q: Jse mesh analysis to find vo(t) if iş = 10cost(30t + 20°)A 0.1% | 20 Ω 40 Ω 50 με 100 mH

A:

Q: A transmitter and receiver operating at 1 GHz

A: Active Power- It is power utilized by the load. Reactive power- It is the power which remains within…

Q: 1. A 3 phase, overhead transmission line has a total series impedance per phase of 200 ohms and a…

A: The Performance calculations of long transmission lines need is based on various parameters of which…

Q: Solve for le of Figure 43. VCC 21V V₂ R1 $500kQ2 R2 $2.1kQ Q1 Beta = 110 R3 1.2kQ Figure 43 Vc VE

A:

Q: Show your solutions clearly and systematically. The D latch of Figure 1 is constructed with four…

A: Given The D latch of Figure 1 is constructed with four NAND gates and an inverter. By using four…

Q: For the F(x) function shown in the figure, find P(0<x<0.5) F(x) O 0.5000 O 0.5999 O 0.4999 O Other:…

A: We need to find out the probability of given interval

Q: An impedance coil has a resistance of 20Ω and an inductive reactance of 40Ω. For what value of…

A:

Q: If the waveform of a voltage has a Form Factor of 1.15 and c Peak Factor of 1.5, and if the peak…

A: Given: A voltage waveform with, Form factor = 1.15 Peak factor = 1.5 Peak value, Vm=4.5 kV

Q: Reduce to a single transfer function: R(S)- S S 200 S S 115 C(s)

A: Given problem can be solved by block reduction technique as stated below.

Q: B Figure 1 (for numbers 6 to 9). VB is 3V, Vcc is 9V, RB is 10K and RL is 1K and (beta)=100. IE R₂…

A: Given data Vb=3v Vcc=9v Rb=10k Rl=1k Beta=100

Q: why does the V(BE) is -0.7 and when input to saturation it change to positive

A: Given

Q: A coil wound 3000 turns in the form of an air-cored torus with a square cross section. The inner…

A: Given,The number of turns is,N=3000The inner diameter of the torus is,Din = 60mmDin = 0.06mThe outer…

Q: If f(t) = t is the input to the system H(s) = 1/(s+100), the output of the system would be: O A.…

A:

Q: 4-Is the residual magnetism on the generator is necessary how can you cancel these residual…

A: The residual magnetism in the generator is necessary because it helps in the voltage build-up of the…

Q: 0.35-H inductor is connected across a 12-V AC power source whose frequency can be varied. Calculate…

A: The phasor current can be solved .

Q: The closed-loop transfer function of a negative unity feedback system is given by

A: Open Loop System (OLS)-A system having a input in the system which does not depends on the system…

Q: Convert into rectangular, polar and exponential form: Given: Z1= 2-j3

A: To convert the given complex number into rectangular, polar and exponential form: Z1 = 2-j3

Q: +1 R 0.5 0.5 H Figure 1 a. What is the direct transmission gain from input R to output C? b. What is…

A: Here we discuss about the concepts related to the block diagram of the control system.   NOTE :-…

Q: closed and switch 2 is opened, or if switches 2, 4, and 7 are closed and switch 1 is opened, or if…

A: We use 7 switches to operate , If, Switch 1,3,5,7 - closed Switch  2 - open If, Switch 2,4,6 -…

Q: Solve the collector-base voltage of an emitter stabilized bias circuit with Vcc=18V, RB-720k ohms,…

A:

Q: Figure 2 (for numbers 10 to 14). Vcc= 6V, RB =10k, RC=1k, B(beta)=100, hie=1k. Vcc O Vo A V₁O Zo'…

A: Given data Vcc=6V Rb=10k Rc=1k Beta=100

Q: When a load is put on a motor, it   will produce a torque which opposes the rotation and reduces…

A: - Electrical motor is supplied with electrical energy at an input and the output in the form of…

Q: Determine the systems stability using the Routh Hurwitz Criterion for Stability.  1. Number of Poles…

A: Routh Hurwitz Criterion When the table is completed, the number of sign changes in the first column…

Q: 1) Calculate the per-unit values for complex powers S2 and S3. 2) Calculate the magnitude of the…

A: We have to determine S2,S3,V1,V2

Q: For a common emitter transistor circuit, the collector current is 20 mA and emitter current is 20.1…

A:

Q: For the network of figure below, determine the value of IRs Rs Vo 9152 Vz=16 VA PZAX=400 mW RL 2…

A:

Q: Solve the collector voltage of an emitter stabilized bias circuit with Vcc=18V, RB-720k ohms,…

A:

Q: What is the difference between a balanced voltage relay and a Translay relay ?

A: There are different types of relays used in the power system for the protection purposes like over…

Q: What is the maximum emf produced by a generator if it is rotating with an angular velocity of 3.2…

A: