What is the half subtractor
Q: An overcurrent relay having a current setting of 59% is connected through a 800:5 CT. The pickup…
A: Current setting 59% Ratio 800/5
Q: The closer the Fill Factor is to the higher the quality O zero O Maximum O Minimum
A: The fill factor gives the relation between maximum power that PV module produced in operating…
Q: 2. figure out the gain of each of the 3 sections of this circuit at the oscillation frequency. The…
A: According to the question, we need to calculate the gain for each Op-Amp. Let us consider the input…
Q: In a step-up converter, Vd =12 V, Vo = 24 V, I0 = 0.5 A, L = 150 µH, C = 470 µF, and fs =20 kHz. •…
A: A step up converter has, Source voltage (Vd)= 12 V Output voltage (Vo)=24 V Output current (Io)=0.5…
Q: What is the output of the following circuit? lov Ri qv Vo 3V -10 V 9 V 10 V 3 V
A: Given Find the value of op amp
Q: HW/Dao the VoCt) of the differentiator OPAMP 2.2K2 Vi is us Vo 0.001MF
A: For given differential circuit we will find out output voltage .
Q: The following transducer is used to measure the temperature. a. Bourdon tube b. Strain Gauge c.…
A: In this question we need to choose a correct option
Q: Find the overall susceptance across terminal a-b when Vs =
A: In this question we will find overall susceptance across ab...
Q: 5. In Figure, sketch the output waveform. What is the maximum positive voltage? The maximum…
A: Diode conducts when anode voltage is greater than cathode voltage, capacitor charges when diode…
Q: For the given input and the following circuit draw the output: (a) Draw the output from VAB (b) Draw…
A:
Q: Provide an introduction for a series circuit and parallel ciruit experiment.
A: Series circuit experiment, In series circuit resistors are connected end to end, one after the…
Q: What are the advantages for each of the capacitors; C1, C2. CE?
A: The capacitor is generally used as an energy storing device or filter. In the amplifier device, the…
Q: A step up converter is operated with a duty cycle of k = 0.75. The input voltage is V,= 20V, and the…
A: Duty cycle, k = 0.75, Input voltage, Vs = 20 V Inductance, L = 5 m H Load resistance, R = 20 Ω The…
Q: Design a circuit which have the following input and output voltage waveforms. [Hint: You have to use…
A: Given input and output waveforms are It is seen that input is clamped up by 10V since maximum…
Q: An ideal buck converter supplies 12 V to a resistive load of 9 Ohms from a 30 V source. The…
A: First we will write expression for current in inductor and than we will determine the minimum…
Q: In figure the values of Rx and Cx are Rp
A:
Q: 11. Find the value of R necessary to produce an output that is five times the sum of the inputs in…
A: The solution can be achieved as follows.
Q: What is the output voltage of the summing OpAmp when the following input voltages are applied R1in…
A:
Q: Breakdown voltage and peak inverse voltage are the same Select one: O True O False
A: Peak Inverse Voltage (PIV) or Peak Reverse Voltage (PRV) refer to the maximum voltage a diode or…
Q: Solve the following: Show your complete solution. Fixed Bias 5. Find IB Ic VCE Yc B-125 VB
A: The solution is given below
Q: What would be the likely output voltage VOUT of the figure below? Show your solution. R 9V Tr1 Dz…
A:
Q: What are the number of branches, notes and loops in the below figur 10 V 20
A:
Q: 2 The parameters of the _equivalent circuit are defined in general terms for any pperating…
A: Solve the problem
Q: hat is the full subtractor
A:
Q: 3. Determine the output waveform for the circuit of Figure below. R +10 V 1.0 k2 Vin OV -10 V
A: To solve above mentioned problem, one should have clear understanding of working of diode. A diode…
Q: At equilibrium the Fermi level at the Drain and the Fermi level at the Source are: Select one: O…
A:
Q: What is the minimum detectable temperature change that the A-to-D converter can resolve
A: The minimum detectable temperature change that the A-to-D converter is given by the expression as…
Q: The inversion mode is possible in single phase half controlled converter with RL load. Select one: O…
A: in the inversion mode the the half controlled converter works as a inverter.
Q: What is the output voltage of the summing OpAmp when the following input voltages are applied R1in…
A:
Q: Electromechanical converters dynamic response is the power electronic systems O Higher than OLower…
A: Answer is 'higher than' . Dynamic response indicates the time taken by a system to respond to the…
Q: RC R1 HE HE L. 8 mH 200PF
A: Oscillation frequency (fo) is given by f0=12πLeqcwhere,Leq =L1+L2+2MM= mutual inducatance =kL1L2…
Q: In what region the following circuit will be in? +1.8 V o VD O a. Triode O b. None- off the options…
A: We need to select correct option for given circuit.
Q: Compute the Approximate output voltage of a PV cell. a. 0.5V b. 150V c. 15V d. 1.5V
A: We need to select correct option for pv cell .
Q: Determine the curreut that Hlows Determine the current that Aloue the circut in the fiqure below…
A: Given
Q: collector current is z T O F
A:
Q: 17. If a signal voltage of 10 mV rms is applied to each amplifier in Figure 12-66, what are the out-…
A:
Q: In circuit below, determine the total current la Ia 452
A: Using series parallel combination find out the total resistance seen from the source. Total current…
Q: Determine The branch current of 15Ω
A: We will use KCL and ohms law find current in 15 ohm resistor. According to KCL sum of the entering…
Q: The inversion mode is not possible in single phase half controlled converter with RL load. Select…
A: in the inversion mode the half controlled converter operates as a inverter.
Q: Design a Half adder, Full adder, Half Subtractor and Full Subtractor.
A: The adder and subtractor circuit can be designed by using truth table and the Boolean expression can…
Q: Rectification is the process of conversion of Select one: O a. DC to DC O b. DC to AC O C. AC to AC…
A: Rectification is the process that converts AC signal to DC signal. The two type of rectifier…
Q: What is the source current
A:
Q: Design a buck converter such that the output voltage is 28V when the input is 48V. The load is…
A: Given: output voltage =28V. input voltage =48V. load = 8Ohm. voltage ripple =0.5% A buck converter…
Q: [1] Draw output waveform for the following circuits if input of 4V peak- to-peak with zero offset is…
A: Draw output waveform for the following circuit, if input of 4V peak-to-peak with zero offset is…
Q: Refer to the given figure. the output voltage is +2V -2 Vo - 2V o Vout +Vsat + -Vsat
A: Input is applied in inverting terminal of OP-AMP.
Q: A companding system with u = 100 used to compand from 0V to 10 V sinusoid signal. Draw the…
A:
Q: 5. Find the total resistance at terminal AB 19 A 10 B
A:
Q: Bridge Circuit
A: Wheatstone Bridge- It is a circuit constructed to find the unknown resistance with the help of the…
What is the half subtractor
Step by step
Solved in 2 steps with 2 images
- Assume the circuit in Figure 21-1 has a power factor of 68%, an apparent power of 300 VA, and a frequency of 400 Hz. The capacitor has a capacitance of 4.7125 F. Find the missing values. ET ER EC IT IR IC Z R XC VA300 P VARSC PF68 C4.7125FAn R-L series circuit contains two resistors and two inductors. The resistors dissipate powers of 96 watts and 125 watts. The inductors have reactive powers of 100 VARs and 78 VARs. What is the power factor?What is the full subtractor
- 2. figure out the gain of each of the 3 sections of this circuit at the oscillation frequency. The three sections are (R1, C1, and OP1), (R2, C2 and OP2) and (R3 and C3). frequency = 100 khz impedance of capacitor = 15.9 ohms.what is the equivalent or total RDesign a buck converter such that the output voltage is 28V when the input is 48V. The load is 8Ohm. Design the converter such that it will be in continuous current mode. The output voltage ripple must not be more than 0.5%. Specify the frequency and the values of each component. Suggest the power switch also
- Q5: By usind Full subtract circuit when the input(X,Y,Zi) equal (011) be (W,Zo * )outbut equalIf the value of R3 in the figure decreases, the positive output voltage Please choose one: a. increase b. reduction c. constantThe attached picture is switching voltages for a buck converter across a 10mH inductor. Please work out the following. Vin Vout ∆IL