What is the inductance L of the primary of a transformer whose input is 150V at 60 Hz and the current drawn is 3.5 Amps? Assume no current in the secondary. 4.(10 points) What is the inductance L of the primary of a transformer whose input is 150V at 60HZand the current drawn is 3.5 Amps? Assume no current in the secondary.

Answered: What is the inductance L of the primary…

What is the inductance L of the primary of a transformer whose input is 150V at 60 Hz and the current drawn is 3.5 Amps? Assume no current in the secondary.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: The region in which 4 <r<5, 0<0 <35°, 0.6n < Ø< 1.2n contains the volume charge density of Py = 10(r...

A: Charge: It is a basic physical property of the material. It experiences a force when placed in a mag...

Q: Find AVERAGE true power for an RLC circuit with given parameters. Z= 3277 ohms, R = 1000 ohms Vs=...

A: The solution is given below

Q: 5.71 For the circuit involving ideal op amps shown in the image below, if R1 = 17 %3D k2, R2 = 20 k2...

A: Brief description: Operational amplifier is an active device which is used for followings, Inverting...

Q: (2) A binary channel with maximum allowable rate is 36000 bps is available for PCM voice transmissio...

Q: Use superposition theorem to find Vx in the circuit

A: In this question, We need to determine the voltage Vx using the super position theorems. Here 2 in...

Q: respect to terminal a and b 1202 1KL 0-2A a 12V 1ar 202 252 Find the and Norton withe

A: The solution is given below

Q: is an Area on a device characteristic where the ratio between applied voltage and resulting current ...

A: Ohm's Law: According to Ohm's law, the current flowing through a conductor between two places is pro...

Q: 3. The radiation resistance of an antenna 72 ohms, loss resistance is 8 ohms .What is the directivit...

Q: Exauple: A Television signal having a bandwidth of 4.2 MHz is transmitted using binary PCM system. G...

A: In this question Television signal is transmitted using binary PCM system .....We have to find out c...

Q: For a control volume in transient operation, the Change of energy inside the control volume during t...

A: Control volume : Control volume is a special type of space which is only used for doing any analysis...

Q: E a

A: We need to find out electric field at given point due to given charge point

Q: 5.33.1 For the circuit involving an ideal op amp shown in the image below, if R1 = 21 k2, R2 = 24 kS...

Q: (3) Determine the minimum transmission bandwidth required to transmit the following signals: 9,(t) 2...

Q: Find Pa,s Ô Find the P,Q ,S for the ollowing g Pr, Qr , ST 71 2+3j 230V 3+1j gv +-j j 43/44

A: In this question, We need to determine the apparent power active power and reactive power. We know...

Q: an input signal ranges from 20–40 A (microamps), with an output signal ranging from .5–1.5 mA (milli...

Q: 3) Is there maximum power transfer from: a) source to amplifier? b) amplifier to load?

A: The maximum power transfer theorem asserts that the load's resistance must equal the source's resist...

Q: 57. In the circuit of Fig. 3.93, only the voltage vz is of interest. Simplify the circuit using appr...

Q: biased in triode, what is the gate-to-source capacitance, Cgs, in femtofarads? Assume the gate diele...

Q: 1. Determine the overall transfer function of the control system shown below: W(s) Gw(s) R(s) E(s) U...

Q: : What happens if we start the motor without a starting rheostat ? Explain : What happens to the spe...

A: Point to Note Main field in any machine is generated by excitation current Speed is inversely prop...

Q: If you wish to store a large amount of energy in a capacitor bank, would you connect capacitors in s...

A: Given: 2 capacitor C1 & C2

Q: Signals and systems Only 29. a

Q: A transformer has induced emf of 220 V at 60 Hz, what is the induced emf when the frequency is 50 Hz...

A: This question belongs to electrical machine . It is based on the concept of relation between induced...

Q: Given the point D(−4, 5, 3) and A = yax + (x + z)z ay, express the D and A in Cylindrical Coordinate...

A: Types of coordinates systems Cartesian coordinates systems Cylindrical coordinates system Spheric...

Q: transform the circuit in phasor domain representation

Q: 240 k2 10 k2 V; (0.02 V, w = 300 x 103) -Vo +

A: We need to find out maximum frequency that can be used .

Q: A feedback control system has a characteristic equation s +(1+K)s² +10s +(5+15K)= 0 The parameter K ...

A: The solution is

Q: Find the force(F) on a 10µC charge at (1, 1,3)m if four like charges of 200µC are located on the x a...

Q: (1) 16 analog signals (each is bandlimited to 8kHz) are transmitted simultaneously over a channel vi...

Q: 3. A germanium diode has an ambient temperature of 25'C, what is the barrier potential of a silicon ...

Q: ohms. Find the resistance

Q: 3. Analyze the circuit to calculate V, from the circuit given below. V1= 0.1 V 100k 20k 400k 10k 20k

A: This questions belongs to analog electronics . It is based on the concept of virtual ground in ideal...

Q: Q For the circuit shown calculate (a) the current drawn from the source, (b) the p.d. across each re...

A: This question belongs to circuit theory . It is based on the concept of calculation of current and v...

Q: (a) Calculate the current in the circuit shown in the figure below if ɛ = 9.0 V, Rị 6.0 12 and R2 12...

Q: In a certain circuit connected in circuit. There are 3 loads connected in Series connection. What is...

A: In this question, We need to determine the total voltage if there are 3 loads connected in Series c...

Q: A-1.63pC charge located at the origin in free space produces a field at point P(-2, 1, -1). Find E a...

A: We need to find out electric field at given point due to given point charge .

Q: FIND THE VALUE OF V, USING MESH METHOD. J412 2/0 A 3 45 A

Q: (2) suppose the open-loop amplifier (or simply the OpAmp) in the above feedback amplifier has the fo...

A: The magnitude response is the ratio of the frequency amplitude of the output signal to the frequency...

Q: eRcrislly avsilaule throz-phase inčuctive motor operates at a fuil loni of 120 hp i hp =746 W) at 95...

Q: 24230° v, z, = 2 + j2 2, z = 4 - j3 0, j10 2, and z, %3D For the circuit below, E, 10 j12 Q. Calcula...

A: Given

Q: Q2 is 4R, the distance from Q2 to Q3 is 5R and the distance from Q1 to Q3 is 3R. (Q1 = 10C, Q2 = 5C ...

Q: Given a set of capacitors: 7 nF, 6 nF, 5 nF, 4 µF, 3 pF and 10 µF, solve the following problems: a. ...

Q: A –1.63pC charge located at the origin in free space produces a field at point P(-2, 1, -1). Find Ē ...

A: Given

Q: Find the value of K for the system given below that will place the closed-loop poles as shown.

Q: If one of the sources in Figure 1.1 had been inserted with the opposite polarity, would there be a s...

Q: Consider the voltage of a baseband signal varies over 13V. This signal is sampled nd quantized throu...

Q: A point charge 5nC is located (2, 0, 4) and a point charge -2nC is located at (−3, 0, 5). Find E at ...

Q: SOLVE THE FOLLOWING PROBLEMS COMPLETELY The series combination of a 4-ohm resistor and a variable r...

Q: 8. Each three single phase transformer each rated 60 kVA are banked delta supplying a 3 phase load o...

A: Given: Each three single-phase transformers each rated 60 kVA are banked delta supplying a 3 phase l...

Q: 2420°v A I 520°A I, -j10 j10 ll I3 5430°A 20 -j1a2 I4 Is

Question

What is the inductance L of the primary of a transformer whose input is 150V at 60 Hz and the current drawn is 3.5 Amps? Assume no current in the secondary.

4.(10 points) What is the inductance L of the primary of a transformer whose input is 150V at 60HZ
and the current drawn is 3.5 Amps? Assume no current in the secondary.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the capacitor, EC, is 104 V; and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. Find the missing values. ET ER78V EC104V IT IR IC Z20 R XC VA P VARSC PF C
With reference to the attached circuit image: If the capacitor is now removed from the attached circuit and is placed in parallel with the secondary of the transformer. A) What is the impedance seen at the supply (HV side) B) What is the power dissipated by the tube
Two coupled coils have inductance of L1 = 0.8 H and L2 = 0.2 H, respectively. If the coefficient of coupling is 0.75, find the turns ratio N1/N2 for the coils. Show Solution Please
With reference to the attached example circuit: If the capacitor is now removed from the attached circuit and is placed in parallel with the secondary of the transformer. -What is the the current supplied by the source?
Consider a 100% efficient transformer with n,pri turns in the primary coil and an input cur 1.5 A. If the secondary coil has 3,000 turns what is the output current.here nprimary=300 turns
S5. a) A voltage of 220V is applied to the primary input of an ideal transformer. A 100Ω load is also connected at its output. If the number of primary turns of the transformer is 200 and the number of secondary turns is 40, find the primary current, secondary voltage and current?
With reference to the attached example circuit: If the capacitor is now removed from the attached circuit and is placed in parallel with the secondary of the transformer. Answer to be solved without using complex numbers. -What is the the current supplied by the source?
The following parameters are used in an EDM process, the supply voltage is 150V. The resistance and capacitance in the circuit are 50 Ohms and 15 microfarads respectively. The tool is made of brass and kerosene is used as the dielectric. A hole diameter of 20 mm is to be cut into a plate of thickness of 3mm. If the discharge takes place at maximum power conditions. The value of constant K4=0.18, calculate the MRR, and machining time.
A transformer has 150 primary turns and 75 secondary turns. Its primary is excited at 200 V and the secondary is loaded with an impedance of 5 <30° Ω. Calculate the primary current and its pf. State assumptions made
An AC circuit contains a 24-Ω resistor, a 15.9-mH inductor, and a 13.3-µF capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. ITank = ILine / Q = VA = P / PF = PF = P / VA Angle 0 =
Q.1. A power suppply having 220 V AC input and two fixed outputs as 10 V DC and 20 V DC is requested from you. For this purpose, a transformer with 220 V AC input / 15 V AC output, some capacitors, some silicon diodes, and zener diodes are presented.a) Design your power supply and point out DC voltage outputs b) Explain the operation of the network and all the components used in the design .c) Calculate and plot input and output signals of the network.Hint: For design, remember clipper, clamper, rectifier,voltage multiplier and zener circuits
Differential Equations: A resistor of 25 ohms and a capacitor of 0.04F are connected in series with a 50V source. If q(0) = 2/3C, calculate the current after 1 minute.