What is the mass diagram and how does it help in identifying various solutions to techniques in earth work operation and calculation of earthwork volume?

Q: Identify some poignant experiences of construction industries on Quantity surveying matters or…

A: Quantity surveying : Quantity surveying is the act or profession of estimating the cost of goods and…

Q: Describe critical depth and critical velocity with the help of specific energy curve

A:

Q: Setting out of the building C is required to be done immediately afterclearing the site, before…

A:

Q: The City Council proposed to utilize government-owned land with an area of 12,150 square meters.…

A:

Q: what is the approximate elevation of international Falls above sea level?

A: Answer As per Elevation map of International falls, elevation of International falls ranges from…

Q: What is the required number of boreholes for a structure that has ground floor area of about 200 m2?

A: Given data- Ground Floor Area (GFA) = 200 m2 To find- The required number of boreholes for a…

Q: What will be the impact of changing the spatial discretization scheme (meshing)? Discuss may include…

A: The impact of changing spatial discretization scheme: Mesh refinement increases the computational…

Q: The areas in cut of two irregular sections 45 m apart are 44 m^2 and 66 m^2 respectively. The base…

A: Given values: Area of 1st cut, A1 = 44 m2 Area of 2nd cut, A2 = 66 m2 Distance between the cuts, L =…

Q: 1. Complete the differential level notes shown below, perform the customary arithmetic check,…

A: Leveling is the process in which we measure the levels of the various point of field in a linear or…

Q: What causes salinity in soil problems?

A: salinity in soil is the amount of  salt content present in the soil and the process of withstanding…

Q: Which information sources can be used for recommending improvements in construction methodology of…

A: Construction Methodology : 1. Construction methodology or project execution methodology is referred…

Q: What are 2 terms for a structure that is built when there is an abrupt change in ground elevation?

A: When there is abrupt change in ground elevation , we built earth retaining structure which are of…

Q: Detailed description of the procedure adopted for surveying including the setting out of the…

A: Question is based on the building survey . In the question procedure adopted  for surveying…

Q: Given the map on the right of an area, you are tasked to suggest the possible location of a well to…

A: The well must be constructed in the dark blue region where, there is enough water available and can…

Q: Explain water stage and its measurement.also describe selection of site for stage?

A: The construction of a structure must follow the design criteria and the limitations of the…

Q: If you needed a map to measure the area of soils in your state that are suitable for agriculture…

A: "Since you have posted multiple questions. We will solve the first question for you. To get the…

Q: A contractor is to construct a tank to contain water for his construction project, given that the…

A: The given values are as follow, The height of the tank (h) = 2.40m The diameter of the tank (d) =…

Q: What is irrigation?

A: Given data  Irrigation engineering  To be discussed  What is Irrigation

Q: You are a site engineer. Inform your customer that his suggested map for the house is not feasible…

A: To xyzsubject -Map of House is not Feasible Due to soil salinitysirI am writing this letter Beacuse…

Q: Enumerate the five catagories of water resources planing and explain each

A: - Water resource planning is a specialist discipline that focuses on the planning and management of…

Q: describe what we mean by elevation, depth, relief, and slope.

A: Elevation:- The altitude of an entity above water level will be its elevation. Although elevation…

Q: Site facilities and services do not include: A. Site office B. Guardhouse C. Storage area D.…

A: Finding out facilities provided on site.

Q: Is the contractor responsible for subsurface investigation?

A: A contractor is a person or an organization that can take out the tasks for the construction…

Q: Define the uses of Bore log report ?

A: Soil boring: In the geotechnical investigation, soil boring is the practice that is used to…

Q: A contractor is to construct a tank to contain water for his construction project, given that the…

A: Given data:                                        The tank height  (h) = 2.4m…

Q: 7- An AON diagram is different from an AOA diagram in that it can show four types of relationships.…

A: Note- Since we only answer up to 3 sub-parts, we’ll answer the first3. Please resubmit the question…

Q: Discuss how volume studies are being conducted

A: Traffic volume studies are conducted to determine the effectiveness of traffic control…

Q: build the sequence to be followed for preparing estimate of project work for 3 ph load

A: Estimate- It is a detailed document that provides information regarding the total expected cost of…

Q: What is the main objective of using the line of balance chart?

A: A line of balance chart can be defined as it is a graphical interpretation of the schedule of…

Q: 1. Foundation 2. Column 3. Retaining Wall 4. Beams 5. Girder 6. Slab 7. Structural Steel/Metal Works…

A: The question asks to write the importance of the following in construction: 1. Foundation 2. Column…

Q: Make an outline notes on the following and provide a simple schematic diagram on  each if…

A: Before alignment of rail road is finalised , engineering Survey are to be carried out in the…

Q: Review the Seive Analysis and Hydrometer Analysis procedures by BS and ASTM and upload your…

A: Procedure of sieve analysis by British Standard: Material Required: Specimen Sieve Shaker BS 410…

Q: Make a grain size distribution graph from the ff table.

A: To draw the grain size distribution curve (GSD) from the given sieve analysis result.   The grain…

Q: Calculate the amount of foundation excavation works for the diagram below if you know that the…

A:

Q: Three wells are arranged as depicted below with B located on a cartesian coordinate system, in…

A: Note: As per our guidelines only three subparts can be solved for a question so for other subparts…

Q: Determine the Departure Misclosure and Latitude Misclosure for the four sided parcel shown below.…

A:

Q: In the process of dividing a tract of land by a line running in a given direction, the surveyor…

A:

Q: Once you finish overlaying layers pertaining to all requested parameters, you can proceed to find…

A: ArcGIS:ArcGIS  family of client software, server software, and online Geographic Information System…

Q: 1. A contractor is to construct a tank to contain water for his construction project, given that the…

A: Given:- The height of the tank = 2.40 m The diameter of the tank = 2.80 m The dimensions of the GI…

Q: Why water analysis is important?

A: Water quality is becoming worse day by day. Earlier rainwater was the purest form of water. But now,…

Q: precipitation over a catchment area. Describe their advantages and disadvantages as well. describe…

A:

Q: features and arrangement of the building construction site.

A: 1. Site should be accessible - To tranport all required materials required for construction site and…

Q: Open sumps and ditches  II.    Well point systems  III.   Deep well drainage

A: Dewatering is done in order to make the site workable and to do the construction without any…

Q: What are Boring reports and Soils reports?

A: Soil report:

Q: You've been selected as the geotechnical engineer by a commercial developer. She wants to build a…

A: Geotechnical Engineering is the branch of civil engineering which deals with the properties,…

Q: omplete the different leveling notes by providing data to the unknown quantities. show solution

A: Given: The leveling notes are given below, STA BS HI FS ELEV BM1 1.256…

Mapping

Mapping is the process of representing the surface of the earth, objects on it, and the relative positions of the objects, to a suitable scale. In mapping, a large area of land is measured, surveyed, and plotted. The details of the objects present in the nearby surrounding area are located using conventional signs. All these processes are carried out on a flat paper known as a map.