Answered: What is the maximum filtering velocity…

Engineering

Civil Engineering

What is the maximum filtering velocity for cement, clay, zinc and wood fumes in Pulse-Jet Baghouses?

Solid Waste Engineering

3rd Edition

ISBN:9781305635203

Author:Worrell, William A.

Publisher:Worrell, William A.

Chapter2: Municipal Solid Waste Characteristics And Quantities

Section: Chapter Questions

Problem 2.8P

See similar textbooks

Related questions

Q: 2. Determine the diameter of a landfill gas header pipe (assuming SDR17) for the following…

A: Solution: Given: Pressure = 40in.WC Temperature = 100o F Flow rate = 5000 ft3/min Design velocity =…

Q: Briefly explain the methods used to check the quality of water in form of flowchart. The methods…

Q: Advantages and disadvantages of trash pump

A: Simply put, trash pumps have a strong pumping capacity. Without their name, the pumps do not pump…

Q: Q / 2: A city discharges 115000 m³/d of wastewater into a stream whose minimum rate of flow is 8.5…

A: Given Data W→ WastewaterR→ Stream θw = 115000 m3/day = 1.331 m3/secθR = 8.5 m3/sec Velocity of…

Q: Describe briefly the nature and operation of rapid gravity filters used in drinking water treatment.…

A: Solution: Rapid gravity filters are mostly used in drinking water treatment as they have proved to…

Q: can you differentiate actual and potential infiltration

A: Introduction Water on the surface of the ground infiltrates the soil through the infiltrate. It is…

Q: For a fixed gas flow rate and drift velocity, calculate the ratio of plate areas for two…

A: The relation between area of plane and efficiency of precipitator is as follows : A=-QWEln(1-n)…

Q: Q2) For the given plan, find the diameter of the sewer pipe #3 at full flow condition (assume full…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: ea has 20 one-story warehouses; all warehouses are noncombustible structures, and their average…

A: According to given data Cylindrical water tank of bottom radius = 50 ftAvg. floor area= 0.50 acre

Q: a = 22.00 m, b = 13.42 m, c = 9.58 m

Q: Why would water samples for the Membrane Filter Technique need to be fairly clear and not turbid?

A: Membrane filter technique is used to determine the amount of microbiological contamination in…

Q: Find the migration velocity for an existing electrostatic precipitator, which the collection plate…

A: Given:- The collection plate area = 110 m2 The gas flow rate = 2.5 m3/sec The collection efficiency…

Q: What are the required gas velocity ranges for best operating conditions for an electrostatic…

A: It is used for controlling air pollution. It removes contaminants like harmful particulate matter…

Q: uck! Question 10 Discharge velocity is the same with seepage velocity if the value is inm per sec. O…

Q: What are the features of nature that influence the rate of infiltration?

A: The rate at which water enter into the soil is known as infilteration.

Q: (c) Calculate the size and number of slow sand filter units to serve a population of (432000) with…

Q: Max average daily flow = 16 MGD Minimum depths 10’ for primary clarifier and 15’ for secondary…

A: Given that , Maximum average daily flow = 16 MGD= 16×10⁶ gallon / day, Minimum depths 10' for…

Q: Design a circular clariflocculator for treating water required for a population of 65,000 with a…

Q: What is the magnitude of the velocity where the flows are fully mixed?

A: Continuity equation: - In this equation principle of conservation of mass is applied that is AV =…

Q: What effect does the discharge through the flow channel have on the height of the jump in the…

A: when the flow is changed from super-critical condition to sub-critical, a jump is formed at the…

Q: The flow totalizer reading the month of September was 121.4 MG. What was the average daily flow…

Q: Water flows in a river. At 8 a.m. the flow past bridge 1 is 2150cfs. At the same instant the flow…

Q: QUESTION: A city of 5000 persons is to be served by a low rate trickling filter with a synthetic…

Q: What is the effect of Inlet gas velocity on the efficiency of a cyclone seperator?

A: Cyclone separators are used to remove the particulate matter in air or other gas streams at low cost…

Q: Primary Treatment Equipment

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: What are the long-term effects of smog ?

Q: The elapsed time between the time rainfall begins and the time water begins to pond on the soil…

Q: to remove surface water on highway surface must be used O cross slope O shoulder slope O curb and…

A: Given multiple question is from highway engineering .

Q: A mechanically cleaned bar screen is used in preliminary treatment for the following conditions:…

A: 1)Given datawask water flow rate(Q)=1,00,000 m3/d=1,00,00024*60*60 m3sec=1.157 m3/sApproach velocity…

Q: 4. To monitor turbidity and chloride concentrations of incoming flow, an engineer designed a…

A: The given data is shown below: Operating velocity=13 m/s & 8 m/sPeak flow=9.5 MGD

Q: Relating to the use of geosynthetics on construction projects, briefly describe what is meant by (a)…

A: Geosynthetics can be defined as it is a synthetic product, which is used to support the terrain. It…

Q: Briefly describe what is meant by (a) the separation function, (b) the filtration function, (c) the…

A: Given: To describe the (a) the separation function, (b) the filtration function, (c) the drainage…

Q: An aeration tank with a volume of 0.42 MG receives a primary effluent flowrate of 2.35 MGD. The…

A: Given data Volume of tank = 0.42 MG Discharge received in primary effluent = 2.35 MGD Suspended…

Q: ) What are the effects of hot weather on fresh e?

A: 1. As the hot weather has high temperature it increases the evaporation losses and hence increase…

Q: Q/How to increase rainwater infiltration in an urban environment?

A: We should stop cutting down of trees. We should make pit regularly at some distance so that water…

Q: interception losses include evaporation through flow and stemflow consist of only evaporation…

Q: ngement between two tanks. The amount of water collected at the discharge in t 60 seconds was g =…

Q: The three statements below all refer to standard single-barrel reverse flow cyclones used to remove…

A: Solution True and False are in second step

Q: A raw sewage sample was brought in for total suspended solids and volatile solids analysis. A…

Q: In city X the storm drains are designed for a 25 year storm event. When determining the antecedent…

A: The design duration of storm =25 year.

Q: (a) Sketch a typical Streeter-Phelps oxygen-sag curve and state its limitations. (b) dD ,is the net…

A: Limitations: The model ignores BOD removal by sedimentation, the conversion of suspended BOD to a…

Q: Describe about the aquitards or preventors of flow.

A: An aquitard is any geological formation that transmits water at slower rates than an aquifer, of a…

Q: sional distribution of pollutant concentration in a channel can be described by c(x, y) =…

A: solution Given that cx,y=7.9+0.13x+0.21y-0.05x2-0.016y2-0.007xyinitial guess =x0,y0=1,3Steepest…

Q: (i) Determine the peak flow rate (in m³/d) generated by the population (ii) Determine the minimum…

Q: 4.2 A mixture of two gas flowsis used to calibrate an air pollution measurementinstrument. The…

A: It is required to determine the concentration of calibration gas after mixing. QdCd=Inlet+QcalCcal…

Q: There is a small spill of a toxic material on a paved surface of a chemical plant. This spill has…

A: Calculate the length of the spill as follows: Length of spill, L = 2.5×12×0.0254…

Q: What is the minimum flow rate through a 4-in diameter pipe carrying carbon tetrachloride at 20°C…

A: Diameter of the pipe is given as 4 inch d=4 inch d=4 inch×0.0254 m1 inch ( 1 inch =0.0254 m)…

Concept explainers

Types of Cement

Cement is a fine mixture of limestone, chalk, or marl and clay which when mixed with water, becomes compacted due to the formation of strong molecular bonds. Due to hydration, cement turns into a hard mass when left for a sufficient amount of time upon mixing with water. The water turns the cement compounds into gel-like submicroscopic particles having higher surface areas. It is due to the hydration properties of cement, they are often known as hydraulic cement. For instance, Portland cement is a popular example in this category.

Question

What is the maximum filtering velocity for cement, clay, zinc and wood fumes in Pulse-Jet Baghouses?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

How would you describe the optimal features of a filter grain used in sewage effluent depth filtering?
The intermittent sand filter needs to be drained and cleaned. If the treated wastewater volume in the filter is 18,000 gal. How many minutes is needed to empty the filter if the withdrawal rate is 500 gal/min?
With laminar flow in a circular pipe, at what distance from the centerline (in terms of the pipe radius) does the average velocity occur?
Describe briefly the nature and operation of rapid gravity filters used in drinking water treatment. Use sketches where appropriate.
A raw sewage sample was brought in for total suspended solids and volatile solids analysis. A portion of the sample was poured into a tared evaporating dish and weighed. The sample was then heated at 105°C for 4 hours, weighed, heated at 550°C overnight, and weighed again. The data are as follows: • Tare wt. 42.9073g• Wt of sample 104.4680g• 105 °C wt. 45.4140g• 550 °C wt. 43.3236g What is the TSS in g/L? What percent of the solids are volatile?
A filter plant has 3 filters, each measuring 10 x 7 ft. One filter is out of service, and the other filters together are capable of filtering 280 gal/min. How many gallons per square foot per minute for each filter?
Q/How to increase rainwater infiltration in an urban environment?
Why would one use a "low pass filter" when designing a water filltration system?
a.) briefly explain why there is flow observed in the sewer when there is no rainfall?
Q3 Consider a flow field represented by the stream function ψ = 24 x3y - 26 x2y2 + 24 xy3. Is this a possible two-dimensional incompressible flow? Is the flow irrotational? Discuss the reasons against your findings.
can you differentiate actual and potential infiltration
Solve the problem using NSCP 2001