What is the period if the clock frequency is 4 kHz

Q: Determine the output frequency for a frequency division circuit that contains 12 flip-flops with an…

A: Question. Determine the output frequency for a frequency division circuit that contains 12…

Q: hat divides the input clock sign esponding timing diagram for 10

A: A counter is a sequential circuit whose state represents the number of clock pulses fed to the…

Q: Signal to Noise Ratio is the ratio of the two

A: answer is b. Powers

Q: In 7 segment decimal decoder, the number of inputs is ?

A: In 7 segment decimal decoder has 4 inputs. Every 7 segment decimal has 4 input lines and 7 outputs.…

Q: During sound digitizing the sound frequencies ranged from  200 Hz to 2.2  kHz. Based on Nyquist…

A: Dear Student, According to Nyquist the sampling frequency should be at least twice of the maximum…

Q: Design a synchronous 2 Bit uP Co unter using SR

A: The sequence of output of circuit would be  00 -> 01 -> 10 -> 11 -> 00...

Q: 2- The FM modulator has k 30 kHz/V modulated with frequency deviation =127.2khz . Calculate the rms?

A:

Q: of At = 3 sec is created between the two waves. The freque %3D Answer: f = 1/6 Hz %3D

A:

Q: 4 x 4 decoder possible?

A: Decoder : Decoder is a combinational circuit that has ‘n’ input lines and maximum of 2n output…

Q: *.Amplitude refers to the amount of voltage in one point in a circuit true False

A: Actually, the amplitude is the maximum amount of voltage in a given circuit.

Q: If R = 200 Ω and C = 20 μF in the circuit in the figure, what is the time constant of the circuit in…

A: Time constant= R×C          = 200 × 20 × 10^-6 = 4 ms

Q: What is the wavelength of a signal with 120MHZ frequency assuming a propagation speed of 3x10° m/s.…

A: The formulae for wavelength of a signal is  λ = v/f where λ  is the wavelength of signal, v is the…

Q: Produce the Circuit and Truth Tables for the expressions below: (A v B) Ꚛ~ (A^C) C Ꚛ ((A ~v C) v (B…

A: Since you are asking multiple questions, we are answering first question for you. If you want to get…

Q: Draw the timing diagram  4321H   LDA A607 H

A: Given:    Draw the timing diagram  4321H   LDA A607 H

Q: A signal waveform has a frequency of 8 MHz, and the width of the positive pulse is 0.08 us. What is…

A:

Q: The truth tables for: 1. (A XNOR B) NAND C

A:

Q: middle 4 digit---5206 letters----EhJ 7 segment output---EhJ5206 print that specific combination…

A:

Q: The Nyquist theorem specifies the minimum sampling rate to be twice the highest frequency of a…

A: The rate at which samples are collected is known as sampling rate.

Q: given the two binary number X=1101101 and Y=1000011, what is X-Y?

A: Here we are given two binary numbers of 7-bits each and the operation is subtraction between them.…

Q: The arithmetic shift to the right: O A. Leaves the sign bit unchanged. O B. Loses the sign bit. О. O…

A: ANSWER : Option A Explanation : The arithmetic shift to right : The arithmetic shift-right leaves…

Q: 1) Write a MATLAB program to find the Trigonometric Fourier Series of the following periodic signal:…

A: Here is the detailed explanation of the code

Q: periodic signal completes one cycle in 0.001 s. What is the frequency? a. 1 Hz b. 100 Hz c. 1 KHz d.…

A: 4. A periodic signal completes one cycle in 0.001 s. What is the frequency? a. 1 Hz b. 100 Hz…

Q: Calculate the operating frequency of the LR circuit in which: R= 100 N, L=50 H, Z=6002.

A: Answer:

Q: If signal does not change at all, its frequency is Zero how?

A: signal does not change at all at 0 frequency is detailed in step2.

Q: Equalizer filter when fm =100Hz and pulse duration 0.02 ms Your answer

A: Lets see the solution in the next steps

Q: Construct a digital system that takes in a single decimal digit and outputs the remainder when the…

A: In given problem, we have a single decimal digit and we can represent single decimal digit using 4…

Q: Question 8 If the period is 5s, the corresponding frequency is 0.2 Hz 0.3 Hz 0.4 Hz 0.5 Hz

A: Phase  is the absolute value of the highest intensity, proportional to the energy the signal…

Q: 1- What are Zeros and Poles for frequency response

A: According to the Bartleby guideline we are suppose to answer only one question at a time. Kindly…

Q: Tell the reading of this micrometer setting. Blank 1mm Micrometer Reading 20 5 15 20 25 15 10 5…

A: Here we have to find the reading of given micrometer setting, Steps for finding readings: 1) Read…

Q: The .. lyer changes bits onto electromagnetic signals ....... Your answer

A: We have total seven layers in OSI reference model and these all having the each individual work…

Q: Using the serial functions and serial monitor, determine the number of words transmitted in a string…

A: Arduino is the tool where you can connect hardware and software both together and solve problems .…

Q: A periodic signal completes one cycle in 0.001 s. What is the frequency?

A: Frequency = 1 / time period

Q: Signal to noise ratio is calculated as signal voltage divided by noise voltage Select one: O True O…

A:

Q: A periodic signal completes one cycle in 0.001 s. What is the frequency? a. 1 Hz b. 100 Hz c. 1 KHz…

A: Task : Find the frequency for given periodic signal.

Q: If each step takes 3nS, then what will be the length of clock cycle?

A: The given question has asked to find the length of clock cycle if each steps takes 3nS.

Q: A signal has a fundamental frequency of 750 Hz. What is its period (in ms)?Round your answer to two…

A: The formula for calculating the period of signal=1 Frequency of signal   Frequency is measured in…

Q: Simplify these expressions into simplified SOP form: a) W=AA+AB'+A'BB°C b) X=(A'+B)'+(A+B) c)…

A: a) W=A.A+A.B'+A'B.B'C ⇒W=A+AB'+0                       [Since, A.A=A and B.B'=0] ⇒W=A.(1+B') ⇒W=A.1…

Q: Define clock skew.

A: Clock skew: Clock skew is also known as timing skew. It refers to a digital circuit system in which…

Q: 35. The period of a signal is 10 ms. What is its frequency in Hertz? a. 10 b. 100 c. 1000 d. 10000

A: The period of a signal is 10 ms. What is its frequency in Hertz? a. 10 b. 100 c. 1000 d.…

Q: Q1/By, using IC {7408 , 7432,7404,7400,7402, and 7486} draw the following equation and find the…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: If the period is 5s, the corresponding frequency is 0.2 Hz 0.3 Hz 0.4 Hz 0.5 Hz

A: Frequency = 1/period =1/5 =0.2Hz

Q: A stereo amplifier with a gain of 30 dB has a 1µV input voltage. What is the output voltage of the…

A: Explanation:  Voutput = input voltage * gain   = 30*1 = 30

Q: The unit of the signal rate is a. Bits per second b. Baud c. micro seconds d. Hertz

A: Answer :-  ( a ).  Bits per second.

Q: 35. Find the color code for the following 10% resistors: a. 68 N c. 22 kN b. 0.33 2 d. 5.6 MN

A: Given question is   Find the color code  for the following 10% A) 68 Ω B)0.33 Ω C)22 Ω D)5.6 Ω…

Q: In a frequency-domain plot, the horizontal axis measures the ________.

A: Given question is from physical layer's functioning.

Q: In 8421 code, input states 1001, 1010, 1011, 1100, 1101, 1110 and 1111 are invalid and the…

A: Given that, input states 1001, 1010, 1011, 1100, 1101, 1110 and 1111 are invalid input states. That…

Q: A periodic signal completes one cycle in 0.001 s. What is the frequency? a. 1 KHz b. 100 Hz

A: This question is related to Network Transmission in Periodic Signals.

Q: Convert the binary number to Gray code, and design the circuit 1100011 110 Convert the Gray code to…

A: Given :-               1.     Binary code = 1100011                       Split binary code into 4…

Q: Calculate the baud rate for the given bit rate and bit combination: a. 2000 bps, dibit b. 6000 bps,…

A: For the given problem, we need to calculate baud rate  Baud rate is the number of signals units per…

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.