What is the reaction at point B (kN)? a. 15.46 kN b. -7.35 kN С. 7.35 kN d. 17.66 kN Provided that there is an P2 P1 = 13.6 kN additional vertical load of P1 P2 = 7.25 kN 24.2 kN applied at point C, P1 d = 1.25 m find the reaction at point P1 B (kN) P2 2.5 m а. 4.75 kN a- b. 19.45 kN p- d. d. d с. 7.35 kN A В d. 27.56 kN

What is the reaction at point B (kN)? a. 15.46 kN b. -7.35 kN С. 7.35 kN d. 17.66 kN Provided that there is an P2 P1 = 13.6 kN additional vertical load of P1 P2 = 7.25 kN 24.2 kN applied at point C, P1 d = 1.25 m find the reaction at point P1 B (kN) P2 2.5 m а. 4.75 kN a- b. 19.45 kN p- d. d. d с. 7.35 kN A В d. 27.56 kN

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the Force Frequired to hold the bar AB in a horizontal position on the smooth inclines shown in figure below. Also determine the reactions at A and B 1.2m, 4.2m, 0.6m A 60 degrees and 45 degrees B 90N
FROM THE FIGURE 1. Determine the force in member AB. a. -3.12 kN b. -9.31 kN c. -2.36 kN d. -4.46 kN 2. Determine the force in member AC. a. -5.192 kN b. -2.362 kN c. -1.521 kN d. -3.722 kN 3. Determine the force in member AD. a. 3.173 kN b. 1.194 kN c. 2.313 kN d. 1.943 kN
Dam is concrete gravity dam that impounds water both on the upstream and down stream sides. if the coeffient of friction between the base and the dam is 0.34, determine the following: 1. total vertical reaction in kN 2. total horizontal reaction in kN 3. factor of safety against sliding 4. factor of safety against over turning 5. if the hydrostatic uplift varies linearly from 0 at the heel to zero at the toe, determine the foundation pressure.
what is the reaction at A? a. 7 kN b. 8.5 kN c. 33.33 kN d. 6.14 kN Reaction at B a. 6.14 kN b. 4.86 kN c. 9.33 kN d. 5.96 kN
The boom shown weighs 800N with its center of gravity at the middle. It is pin-connected to the wall at B and supported by cable AC. It also supports a 1200N pull at A. Determine the stress in AC and the horizontal and vertical components of the reaction atB.
A circular rod with uniform cross-section is free at both ends as shown 1. Determine the axial load at point B. a. 18.3 kNb. 12 kNc. 10.5 kNd. 10 kN2. Determine the axial load at point C.a. 18.3 kNb. 12 kNc. 10.5 kNd. 10 kN3. Determine the reaction at point D. a. 18.3 kNb. 12 kNc. 11.5 kNd. 10 kN
Determine support reaction at B . Given P=100 Kn L=10 m
A long trench was excavated in medium dense sand for the foundation of a multistory building. The sides of the trench are supported with sheet pile walls fixed in place by struts and wales as shown in figure. The wales are braced at every 4 m center to center. Determine the reaction of the strut A.
Find the support reactions and join force of the construction. If q=24 kNlm M = 10kNm and L=3 m
A billboard 3m high by 4m wide is supported as shown in the figure. The totl weight of the billboard is 30 kN. H = 1.5 m and tetha= 60 degrees. Wimd pressure, q= 1.6 kpa Wind pressure coefficient = 1.0. Determine the reactions at the support.
Question 3 5 pts What is the larger vertical reaction of a 6- m simply-supported beam carryinga triangular load which varies from 0 at one support and 15 kN/m at the other support? (Answer must be in kN.)
Determine sum of vertical support reaction at A and B