What is the Thevenin's voltage and resistance for the given circuit? 41/1 VS 30 V R1 220 22 R2 680 +411 A RL 1 ΚΩ B R3 470 2 R4 560 2

Q: 9 9 C(s) > = (²-) ( ₁² + ² 5 + 9) = s(s+ 7.854)(s + 1.146) system poles = [−7.854, −1.146] c(t) = 1…

A: C(s)=(1/S)(9/s2+9s+9) C(s)=9/S(S2+9S+9) C(s)=9/S(S+7.854)(S+1.146) System poles, S=0 , S=-7.854 ,…

Q: (d) Given a vector à = -1+2j-2k in Cartesian coordinate. (i) Sketch vector A

A:

Q: . Design a combinational circuit to convert a 4-bit binary number to gray code using (a) standard…

A:

Q: For correct operation as an ac amplifier a npn BJT must be correctly DC biased to establish an…

A: For the given BJT CE amplifier circuit the role of the resistor needs to be briefed.

Q: If Vc(t) = 4Cos105t V in the circuit given below then find Vs(t)? Vs(t) m 2mH :80nF

A: Vc(t) = 4cos105t V Vs(t)= ?

Q: Q3) For the control system shown in below. Obtain the closed-loop transfer function C(s)/U(s). where…

A: here we have to find the closed-loop transfer function CsUs

Q: A 2-wire distributor AB is fed at B at a voltage of 230V. The length of the distributor is 500 m and…

A: In this question we need to find the following The cross - sectional area of each conductor Point…

Q: Problem 3 Consider a 100 kVA, 7200/240 V, 60 Hz transformer. Assume that the open-circuit and…

A: “Since you have posted question with multiple sub parts,we will provide the solutions only to the…

Q: A baseband signal with maximum frequency of 34 KHz is sampled at 67 KHz. Determine the Nyquist…

A: Maximum frequency of the signal fm=34 KHz. Sampling frequency fs=67 KHz.

Q: Given this question for PMDC motor For Full-load and Half-load states, write the motor Torque -…

A: To obtain the motor Torque-Speed transfer function for both the full-load and half-load states, we…

Q: VSF=11.69×10-9×100+1.8663=3.0353 V how come need to times 10^9?

A: here we have clear the calculation of VSFVSF

Q: C(s) 9 2 +9. s(s + j3)(s − j3) = (-) (₁²49)

A: Cs = 1s9s2+9

Q: Determine the suitable measure of the signals depicted in Figure 1. Justify your answer and show you…

A: The above question is based on power and energy signals. Note that here as multiple questions are…

Q: 150 ΚΩ Problem: Given the circuit below determine the following a. Vcmin b. Vcmax c. Icmax d. VCB at…

A:

Q: A 200V, dc shunt motor has shunt field resistance of 200 ohm and an armature resistance of 0.25 ohm.…

A:

Q: - Factor to obtain a product of sums: (a) K'L'M + KM'N + KLM + LM'N' (b) KL + K'L' + L'M'N' + LMN'…

A:

Q: 4) Two single phase transformers in an open delta bank served a 3 phase balanced load of 100 KVA. If…

A: Rating of transformer S = 100 KVA. Initially two single phase transformers are there then one…

Q: Define System Dynamics independently. Explain feedback and balancing loops in your own words.…

A: System Dynamics is an approach to studying complex systems that focuses on understanding the dynamic…

Q: Device controllers' duties?

A: Device controllers play a crucial role in managing and maintaining various electronic devices.

Q: 4) Two single phase transformers in an open delta bank served a 3 phase balanced load of 100 KVA. If…

A: Rating of transformer S = 100 KVA. Initially two single phase transformers are there then one…

Q: (ii) A battery has an unknown internal resistance r's and an unloaded terminal voltage of 12 V as…

A: Give Data: A description of a circuit as, Battery voltage Vb=12 V Series internal resistance =rs…

Q: www 2

A: We need to draw the output voltage waveform of A1 and A2 for the given Circuit. R3=1.5 kohm, C1=10nF…

Q: B: Mention four factors (physical state- by them.

A: Mention the four factors (physical state& condition) that the phenomenon of corona is affected-:

Q: A digital transmission system has a bit rate of 45 megabits/second. How many PCM voice calls can be…

A: In a digital transmission system, The bit rate is 45 Mbps. Word length is of 8 bits.

Q: ▪ Question 3. Consider Is it BIBO stable? 10 *-[-]+[J]. x 0 y = [-2 3]x - 2u X u

A: The question is based on the bounded-input bounded-output stability of a system from its state-space…

Q: Ohm's law describes the relation of voltage difference and current passing across an element. Select…

A: Need to tell whether a given statement is true or false.

Q: Consider the following step response of a system. We want to find a model that represents this…

A: In this question we need to find the following the following Transfer function of the given system…

Q: d) Now sketch the ac circuit model of the amplifier shown in figure 3.1. Using the Q-point…

A: For the given BJT CE amplifier circuit the AC model of the circuit needs to be drawn and the voltage…

Q: Three - 25 KVA single-phase transformers are connected in delta – delta. One of the transformers has…

A: it is asked to find the maximum real power of delta-delta transformer if one of transformer is…

Q: 3. Given a closed-loop transfer function is T(s) = G(s) 1+G(s)H(s) = K(s² +5+6) 2 3 s³+15s²…

A: In this question we need to find the steady state error

Q: 1 C ► TF 2V

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Four strain gauges are mounted on a cantilever beam in a configuration like that shown in Figure 3.…

A: "Since you have posted a question with multiple sub parts, we will provide the solution only to…

Q: 2kIx 14 zk 2x Nodal Analysis Probz Vz IX → 1) АМА T 0.5k find V₁, V₂ (node 1 & mode 2) Io, Ix

A:

Q: Determine the Fourier Series corresponding to the following periodic function, and then determine…

A: To determine the Fourier series corresponding to the following periodic function, and then determine…

Q: (1) Find the input output relation between x(t) and y(t). (ii) Prove that the system is time…

A: From the given system the relationship between the input and the output needs to be calculated and…

Q: P4: Find the capacitor voltage for t> 0 (t = ∞) for the circuit below. Show the details of your…

A: here we have to find the voltage across the capacitor for t<0 and t>>0

Q: Question 2. Equivalent circuit parameters of a three-phase, 2P=6-pole 50 Hz, 2400 V, 950 rpm stator…

A: Pole, P=6 frequency, f=50 Hz Rotor speed= Nr=950 rpm Supply line voltage, Vl=2400 V   Synchronous…

Q: 3 y(t) (V) 1,(t) 152 mor 0.4 H 1.6F :JT.GF (t) Obtain the complete response (t) and the current i(t)…

A: The given circuit is shown below. Initial conditions are written below. vC0=0 V. i0=0 A. It is a…

Q: A resonant inverter with bidirectional switch has C = 3uF, L = 25uH and Vs = 220V. Its secondary is…

A: Given that, C=3 μFL=25  μH and VS=220 V The switching time of the transistor is 10  μs fo=12 kHz

Q: Problem 4 Controllability and Observability Consider the following continuous-time state space…

A: For the given state space model of the system, the system is whether controllable and observable…

Q: A 4-bus network having the following L & U matrices: [-j16.75 j11.75 j2.5 j2.5 L U= Z42 is: ܘܘܘܟ 0…

A:

Q: A combinational circuit is specified by the following Boolean function: F(x, y, z)=(2, 4, 6, 7)…

A: The given boolean function needs to be implemented with the decoder and the external gates.

Q: 2u(t) www 1 + ܝܚ 2 W (2u(t-2)

A:

Q: a) Sketch the following signals, and state whether they are odd or even (or neither), and continuous…

A:

Q: Find the voltage across the capacitor as a function of time for t> 0 for the given circuit. Assume…

A: Given: with the assumption that the circuit is in steady state for t<0 and Vi = 60 V.  To find:…

Q: B-8-29. Consider a unity-feedback control system with the open-loop transfer function G(s) Determine…

A: Gs = Kss2+s+4Hs = 1therefore,  GsHs = GsPhase margin P.M. = 50°

Q: 1. The full-wave controlled bridge rectifier shown has an ac input of 120 V rms at 60 Hz and a 502…

A: The above question is based on a single-phase full-wave rectifier with a resistive load. Standard…

Q: Find the currents I₁, I2 and 13 in the following circuit using: Gaussian elimination 414 b. Cramer's…

A: here we have to find the currents I1 , I2 , I3 using gaussian elimination and crammer's rule.

Q: Final answer is already given in the given photo below so just kindly provide a COMPLETE and CLEAR…

A: Cs=9ss2+2s+9

Q: Z11 a' Z12 w www w A Z13 Z14 B Consider the balanced three-phase network. Z12-40, Z13-130.…

A: In this question We need to determine the voltage Van as shown the circuit.  We are solving this…

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.