What is the use of the LCD display?

Q: In a certain band-pass filter, the central frequency is 14 kHz. If the bandwidth is 4 kHz, the lower…

A: Given,In a band-pass filter,Central frequency, fc = 14 kHz.andBandwidth, BW=4 kHz.

Q: EXI find range that system is stable when P 70 integer R(S)- of (K) such n any Positive number. ? K…

A:

Q: What reactance does an 8-H coil have at 1,000 Hz? Express the answer to the nearer hundredth. X₁ =…

A: Given, Inductance of coil L=8 H. Frequency f=1000 Hz.

Q: f= requency is being applied to the 120-mH coil in this diagram? XL 2RL f=? XL-3,768 02

A: Given circuit: Inductance, L=120 mH. Reactance, XL=3768 Ω.

Q: 22: Using the properties of Fourier transform, find the Fourier transform of the following ignals:…

A:

Q: Consider a CE circuit, where trans-conductance is 50mΩ-1, diffusion capacitance is 100 pF,…

A: Given data: CE circuit has transconductance gm=50 m Ω-1. Diffusion capacitance, Cd= 100 pF…

Q: Example 2.9 The resistance of a long piece of copper wire is 48 2 at 20°C. a. What would the…

A: Given: R0=48 ΩT1=20°CT2=50°C Find : Resistance at 50°C Graph between resistance and temperature

Q: 23. (a) A 12V DC voltage source (of negligible output resistance) is suddenly connected across a…

A:

Q: A three-phase delta-connected generator supplies a full load current of 80 A at a voltage of 220 V…

A:

Q: 24. Answer the following: a. Obtain the voltage Vo in e circuit. 2 mA 2 mA ska b. Determine the…

A: We need to find out the output voltage for given circuit

Q: For the circuit of Figure 3.11, write loop equations in matrix form, and solve for the unknowns…

A:

Q: A bunglow has Following load connected in it (i) 40 Watt tube lights - 12 Nos, switched on for 4…

A:

Q: GIVEN THE FOLLOWING FACTS ABOUT A REAL SIGNAL X(T) WITH LAPLACE TRANSFORM X(S): A: X(S) HAS EXACTLY…

A: Given- X(s) has exactly two poles X(s) has no zeros in the infinite S-plane X(s) has a pole at s =…

Q: : At full load the coppe transformer are 6 kW and 2.5 kW respecti (ii) the load at which efficiency…

A:

Q: A 24.0 V battery is wired in parallel with three resistors, R1 10.0 Ohms, R2 - 60.0 Ohms, and R3 =…

A: The required parameters can be calculated by using the ohms law and current division rule.

Q: Q1. By first using combinations of resistors, calculate the source current of Circuit 1 and hence…

A: Given circuit:- Here, one voltage source and one current source are present, R, R, 2R, &2R are…

Q: Assuming an ideal op-amp, what value of RX will result in an voltage gain (vo / v1) equal to 52 +

A: Circuit is given as:

Q: For the network of Figure 5.16, replace all inductors by a single equivalent inductor. 000001 35 mH…

A:

Q: Find the exact 1012 2mll 3012 60μF 562 3pF 50m

A: Given circuit diagram,

Q: A 440 V, 6 pole d.c. A shunt motor has 1200 armature conductors connected in a lap. It draws a…

A:

Q: In a single phase 230/110 V transformer the gross sectional area of ​​the core is 44.4 cm². If the…

A: Given  area of ​​the core is 44.4 cm² maximum flux density of the core is 1.2 Wb/m² Transformer…

Q: 5) Determine all the currents and voltages in the figure below. 84 . I1 · 20Ω 12 10Ω L ΣΩ Σ0Ω

A:

Q: The table shows the values for the current, I, in an electric circuit and the resistance, R, of the…

A: a) b) From the above graph, it is observed that the resistance is decreasing with increasing…

Q: A 3-phase, 3-wire system has a normal voltage of 10-4 kV between the lines. It is supplied by a…

A: We have 3-Phase, 3-Wire system with, Normal Voltage (Vl) = 10.4 KV = 10.4 * 103 V Generator Positive…

Q: switch In the figure, suppose the switch has been closed for a time interval sufficiently long for…

A: Given- Voltage = 42 V R1 = 8 ohm R2 = 6 ohm R3 = 3 ohm C = 4 μF To find- Current at steady state =?…

Q: In the circuit given, the two Si transistors are similar. Given β=50, Vcc=12V, I1=5mA. Find I?

A: The given circuit diagram is shown below. The other given information are VCC=12 Volts. β=50. I1=5…

Q: Consider the series R-L circuit shown in figure below. For obtaining transient free response, switch…

A:

Q: Three impedances of 3 + j 4 Ω are connected in delta with a three phase, 500 volt, a.c. supply. Then…

A:

Q: 18. Obtain the equivalent resistance at the terminals a-b for each of the circuits given. 30 12 www…

A:

Q: A load of 500 kW has a power factor of 0.6 lagging. Combined power factor is to be 0.9 using over…

A: We got an 500 KW load with, Load power (P1) = 500 KW Load power factor (Cos ϕ1) = 0.6  Synchronous…

Q: A resistance of 10 ohm, an inductor of 300 mH and a capacitor of 50 uF are connected in series. If…

A:

Q: du 5. A control system is described by d²y dy +3 +2y= dt dt² dt and 'y' is output. The transfer…

A: Use following properties of transfer function  LTd2ydt2= S2ysLTdydt= Sys Apply laplace transform to…

Q: Tilt of the output waveform for the circuit is 1%. Given that input is a square wave ± 10 V, f = 2…

A: Given: Tilt of the output waveform is 1%. Input is a square wave of maximum and minimum amplitude…

Q: A. Given the comparator circuits (with supply voltages at ±15 V) below, draw and label the output…

A: Given: Circuits  Find  Output voltage

Q: A business uses two 3 kW fires for an average of 20 hours each per week, and six 150W lights for 30…

A: According to the question, it is given that Power P1 = 3 kW Time T1= 20 hours Power P2 = 150 kW Time…

Q: Find the laplace transform

A:

Q: The state-space of a control system given a: Design the state feedback gain matrix using the direct…

A:

Q: With the load ROD disconnected, compute the open circuit voltage Vab With the load connected,…

A: Given- Source voltage Vin = 12 V Load resistance, RLoad = 5 k ohm To find- Voltage across ab Vab = ?…

Q: R1 R2 120k 180k RD M1, MbreakN-X D¢ Following the circuit: RD=? 80uA 5V VDD a. Find the DC gate…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: rms Q) For the lossless T.L shown below, the line is driven with a generator that has E-30 V, and Zg…

A: According to the question, for the given transmission line as shown below We need to find λ, ZL,…

Q: A 6 KVA step-up transformer having a turns ratio of 1:4 has a primary voltage of 1000V.calculate the…

A: Given, A step-up transformer has, Rated KVA, S=6 kVA. Turns ratio N1N2=14. Primary voltage, V1=1000…

Q: Sketch the single-sided and double-sided spectra of x(t) = 2 sin (10nt -

A: Given, x(t)=2sin10πt-16π   To find: Sketch the single-sided and double-sided spectra.

Q: Evaluate VX A where A = p²z ap + p³a + 3pz² az az component ap component ao component

A: Given, A=ρ2zaρ+ρ3a∅+3ρz2az   To find: Evaluate ∇×A

Q: The amplifier of Figure 1 uses an LM741 compensated opamp, which has the following specifications:…

A: I am attaching detailed solution image of this question.

Q: A 3 Phase induction motor is wound for 4-poles and is supplied from a 60Hz supply. Calculate the…

A: Given: A three phase induction motor has, P=4f=60 Hz.

Q: For the fixed-bias circuit shown in Fig. 10.7, determine the operating point if Ipss = 10 mA and Vp…

A: We have an FIxed-Biased CIrcuit as shown in figure, Given Data, IDSS = 10 mA = 10 * 10-3 A Vp = - 4…

Q: Ao A₁ A₂ Address decoder 0 1 2 3 4 5 6 7 0₂ АННННН 0₂ {KKKKK. 00

A: Given data: An address decoder diagram is given in which the black box of the output represents 0…

Q: A circuit in which an electrical load can be disconnected without affecting other loads is known as…

A:

Q: Determine the Norton equivalent of the circuit drawn in Fig. 1 as seen by terminals a and b. 500 i…

A: Given:

Q: It is assumed a 12-volt automotive battery is completely discharged and at some reference time t =…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.