What is wrong with this circuit? V₁ 24 V R₁10 kn D₁ 1N4744A 15 V 4.790 VR₂2.5 k RL

Q: The diagram shows an RL circuit with a switch. e 110.0 V, R1 11.0 N, R2 = 39.0 N, R3 = 64.0 N and L…

A: The current through the resistor can be calculated based on the state of the inductor. Incase of…

Q: A DC shunt generator has a field winding resistance of 110 ohms and a load current of 250 amps at…

A: Solution- DC shunt generator, from the diagram- Ia = IL+Ish

Q: 5.a) 5.b) A 4 pole, 3 phase induction motor operates from a 50 Hz supply. Calculate (a) Speed at…

A: Induction motor like a transformer ,stator is the primary and rotor is the secondary when maximum…

Q: How to get the 868 rpm in the solution below?

A: The given calculation is shown below:

Q: I, 60/0° V +1 j15 Ω j100 Ω m j50 Ω j0 Ω ell 80 Ω j 10 Ω 40 Ω-j20 Ω ww j80 Ω +1 1, 20/90° V Find 11,…

A: Detailed solution is attached with the notes.please go through and follow up in case of queries.…

Q: xplain basic requirements of lightning arrestor

A: On the category of arrester under consideration, quality is dependent. A distribution arrester, for…

Q: Sketch the root locus diagram for a unity feedback system G(s) = K(s+3)/s(s2+2s+2) (s+5)(s+9). Thus…

A:

Q: 2. in Volts: Vx For the following circuit find Vo IKR ۵۶۷ 3ke3R₁ R₂ ake R3 V₂

A:

Q: carrying? Ans. 10 45 percent 10.44 A 100-KVA transformer is at 80 percent of rated load at power…

A:

Q: When Sa and Sb are set to position 0 and 1 respectively, the reading of V1 is equal to

A:

Q: For a balanced load, the current in a neutral conductor of a three-phase, four- wire system is equal…

A: In a three phase balanced 4 wire system there are 4 wire in which 3 of them represent three…

Q: Show your solution for this problem. A 400V, 3-phase star connected alternator supplies a…

A:

Q: Use mesh-current analysis to solve i1,i2 and i3. 70 V + 20 Ω 14 Ω Μ Το 10 Ω 12 Ω Μ 12 + 42 V

A: Given circuit,

Q: A 40 MVA, 11 kV three phase, 50 Hz, 4 pole turbo alternator has an inertia constant of 15 sec. An…

A: Given a 3-phase turbo alternator with, Power rating, S = 40 MVA Number of pole = 4 Frequency, f = 50…

Q: The resistance and inductance of the circuit in Fig. 8.50 are 100 2 and 20 mH, respectively. a. Find…

A:

Q: the resistance

A:

Q: -61 -4-3-2 2 3 2 1² U 1 0 1 2 3 • 4 A 5 O 56 12 x[n] -111-4-1 2 -2-1¹ -6-5-4-3-2 (i) 2-3x,[n] (iii)…

A: As per our guidelines we are supposed to be the first three questions only. Kindly repost the other…

Q: (1) Find the Fourier transform of the signal shown in figure below. f(t) cos (5t)

A:

Q: What is the peak output voltage for this half-wave rectifier? + Pri 169.706 V 60 Hz 0 Deg express…

A:

Q: Q3 (a) Describe the rules how to construct (draw) the root locus if the angle of asymptote are +60°…

A:

Q: The following function is: f(t) = 3u(t)- 5u(t-1) + 2u(t - 2) O a. O b. O d. Represented in Laplace…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.…

Q: Problem 9 (HW 12): Find the Fourier Transform of

A:

Q: :) Consider the JFET self-bias configuration circuit. Given that V₂= -8V and Ipss = 12mA. Assume VDD…

A: It is given that: VP=-8 VIDSS=12 mA=12×10-3 AVDD=20 VRD=3.3 KΩRG=1 MΩRS=1 KΩ

Q: the circuit shown in the figure, assume LED1 has a forward voltage of 2 volts and 2002 forward…

A: In this question,  We need to determine the current I1 as shown the circuit.  LED froward voltage VD…

Q: In how many seconds after t=0 has the current i(t) become one half of its initial value in the given…

A:

Q: Z = 40 + j20 Ω, Z, = 25 Ω Z = 2 + j, Z, = 50 – j30 Ω,

A:

Q: Use a 0.05-µF capacitor to design a high-pass filter to have cutoff frequency of 100 krad/s. Draw a…

A: The required circuit can be designed with the help of capacitor and resistor. The capacitor will…

Q: SOLVE Vo in the circuit using superposition theoren

A:

Q: A bulb rated 110V, 60Watts is connected with another bulb rated 110V, 100 Watts across a 220V mains.…

A:

Q: Explain insulation coordination

A: Coordination is required in electrical systems for proper functioning of the equipments. Insulation…

Q: Fig. 39.17 shows the negative voltage feedback amplifier. What is the value of feedback fraction?…

A: Given negative voltage feedback amplifier circuit, R1=2 kΩR2=18 kΩ

Q: round intermediate calculations. Round your answer to 2 decimal places.) y, the PCB machine produces…

A:

Q: 1. Find and draw the Fourier Transform of the signal shown if figure below: f(t) -T A coswot

A: 1) To find the Fourier transform of the given signal f(t) = cos(wot)  And also draw it's Fourier…

Q: The value le for a transistor where lg is 50 μA and Ic is 3.65 mA is 3.7 mA O 3.6 MA 3 mA O2.9 mA

A: Given, In a transistor, Base current, IB=50 μA Collector current, IC=3.65 mA

Q: Vin = 10 V O a. 3.75 mA Ob. 2.5 mA 4k Ohm 4 k Ohm O c.- 1.25 mA O d. 5.7 MA The current it in the…

A: Here opamp is with positive and negative both feedback but negative feedback is dominating so it's…

Q: An electric circuit contains a 1-H inductor, a 4-$ resistor, and a voltage source of sin t. The…

A:

Q: What are the working principle of air blast circuit breaker

A:

Q: A star connected 3 phase, 12 MVA, 11 kV alternator has a phase reactance of 10 %. It is protected by…

A:

Q: A 188 KW, 200 volt, three phase, delta-connected induction motor has a full load efficiency of 94 %…

A: Given data, Output Power (Pout)=188kW Line Voltage (VL)=200V Full load efficiency ηfl=94% or 0.98…

Q: A 0.8 mA meter movement with an internal resistance of 90Ω is to be converted into a 0-130 mA…

A: Shunt resistance: Resistance is the property of a material that resists the flow of the current in…

Q: Figure 5-22 V = 24 V H A G ww B R₁ 1 ΚΩ F R₂ = 1.2 ΚΩ E D R₂ = 1.5 ΚΩ 5-18 In Fig. 5-22, how much is…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: A resistor and capacitor are connected in parallel to a 277-V, 60-Hz power source. The resisitor has…

A: Given: Voltage 277 V Frequency 60 Hz Resistance 50 ohm Capacitance 40 uF

Q: Two inductors are connected in series with L₁= 27 mH, L₂ = 12 mH, and M = 0.0144 mH, find the…

A: Given, Two inductors are connected in series. L1=27 mHL2=12 mHM=0.0144 mH

Q: In order to connect a LED to one of the pins: O You need to define that LED as an OUTPUT in the…

A: An Arduino circuit with LED and a button, when we press the button the LED should be ON and when the…

Q: The transfer function of the following closed-loop system is: O O R(s) O G(s) 1-G(s)H(s) H(s)…

A:

Q: AC has replaced DC as the main source of electricity mainly because AC is required to run induction…

A: There are two main sources of electricity namely AC and DC. In domestic applications AC is used.

Q: A 3 phase, 200 V, induction motor has stator impedance of (0.07+j 0.42) ohm/ph while equivalent…

A:

Q: 5. Please refer to the parallel-based clipper circuit shown below for this problem. For simplicity,…

A: Given:  Required: (a) Plot the output V0(t) for 0≤t≤T                  (b) Plot the voltage…

Q: Given is the following circuit: Uo R₁ R₂ R5 Re R3 RA Res Rr R₂ U₁ The resistors are as follows: R₁ =…

A:

Q: f preceden

A: Given as,

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.