What precautions are practiced by electric companies in terms of loading capacity? When is a distribution box needed in terms of electrical supply?

Q: - What is the amount of power saving in the AM-DSB-SC, when compared to other types of AM systems?

A:

Q: Generation engineers are more inclined to an operation in a closed system as compared to an open…

A: Nowadays Electricity is a major part of any country's growth. The demand for power supply is…

Q: 2- What is the amount of power saving in the AM-DSB-SC, when compared to other types of AM systems?

A:

Q: Draw & explain the single line diagram of a Typical A.c power Supply Scheme?

A:

Q: What is meant by utility-controlled load management?

A: utility-controlled load management is the process to balancing the electricity supply on power grid…

Q: What are power loss and voltage drop and how are they related?

A: The voltage drop across the resistor is defined by the ohm's law. The voltage difference across the…

Q: What are the poles according to their duties?

A: The function of poles is to support the conductors. poles should be capable to carry the load due to…

Q: When is a distribution box needed in terms of electrical supply in a residential area?

A: A distribution board is the main electrical supply system for any commercial or residential. The…

Q: Explain the Wiring Diagram of Direct On Line Starter

A: WIRING DIAGRAM OF DIRECT ON LINE (DOL) STARTER: 1. A DOL starter is the most common way to start a…

Q: What does matched load mean?What happens if the load is not matched?

A: In this question, we will define matched load..

Q: Explain differential current and voltage differential scheme of bus bar protection

A: Differential current bus bar protection Voltage differential bus bar protection

Q: ix. What is the purpose of surge tank in hydro electric plant?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What is Per Unit system and why it is used in Power system calculations?

A: Various parameters of the power system is represented in the per-unit system

Q: 2-What is the amount of power saving in the AM-DSB- SC, when compared to other types of AM systems?

A:

Q: 1. The number of devices required to perform the no-load test and the short-circuit test for…

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: 4. Why is less overshoot desired for practical systems?

A: Overshoot: It is the manifestation of a function or signal that exceeds its target.

Q: a Explain the procedure for preventing an overload or a short circuit in a domestic wiring b. What…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: LOOK! THINK! DO! WORKPLACE HAZARD/ACCIDENT What is the Can the hazard OHS strategy? hazard? harm…

A:

Q: how does Wholesale Electricity Spot Market works?

A: The wholesale electricity exchange (WESM) could even be a venue for commerce electricity as a…

Q: 2) What are the salient features of supply voltage control method?

A: It is one of the control methodologies based on DC linking the supply voltage without any current…

Q: What are the possible consequences of failure of the entire DC supply system in the station

A: It is known that at  the power generation unit ,DC supply system  is responsible for source of power…

Q: Explain the reasons for applying system grounding in electric power systems.

A:

Q: Block diagram of Arduino car speed Detector ana explains operating

A: consider the given question;

Q: 1. What is the ideal line percent regulation rating? 2. Shunt voltage regulators require  __________…

A: The objective is to determine line regulation and voltage sampling.

Q: The Voltage Regulation of a Transmission Line should be _____? A. very high percentage. B. more than…

A: C. Zero or nil Option C is correct.

Q: What is the smart grid?

A: A smart grid is a grid which involves the large variety of the production of the electricity like…

Q: Why is this important for transmitting electrical power to residential and industrial needs?

A: The requirement of electrical energy is increasing day by day. It is the most utilized or consumed…

Q: 1- What is the amount of power saving in the AM-DSB-SC, when compared to other types of AM systems?

A:

Q: Research on "Power Outage Detection and Locating Methods", roguirod nribo ito

A: Power outage is also called as the cutting of power or the power out,the blackout of power, the…

Q: 2. What is the purpose of conducting Short Circuit (SC) test?

A: Electrical machines can be either generator or motors and transformers. They can be either Ac…

Q: 04/Why is less overshoot desired for practical systems.?

A: For the system to be stable the rise time must be less so that the speed of response is increased…

Q: Describe the function of DC - DC switching mode power supply unit with neat block diagram.

A: SMPS : Switch mode Power Supply   This works like DC chopper.

Q: Which stability is called as load stability? Why it is called like that?

A: Under the normal conditions, after the system is subjected to a disturbance the ability of a power…

Q: Identify and describe the step-by-step process used to pull cable and the step-by-step process used…

A: 1. The first step is to to lay electrical conduction of 2mm thick and 25 mm in size for the PVC…

Q: . What is “accessible” as applied to wiring methods? What is “accessible” as applied to equipment?…

A: In an electrical system, there are various terms which are used for different phenomenon and gives a…

Q: What are the causes of short circuits? What are the effects of short circuit in to electrical…

A: Short circuit is an abnormal condition and occurs rarely. Short circuit occurs when there is a low…

Q: What is the total number of systems?

A:

Q: hat is “Voltage collapse”? Why does voltage instability occur? What are the countermeasures to deal…

A: Voltage collapse is the process in which the voltage at significant part of the power system becomes…

Q: Is there a central processing unit in the power circuit in the mobile?

A: Processors, often known as CPUs, are found in all modern cellphones. The CPU in a smartphone is the…

Q: Transient stability of the power system can be improved by using? O single Lines O Parallel

A: Transient stabilty  refers to the ability of power system to restore synchronism after large…

Q: What is ampere circuital law?

A: This law gives the relation between the magnetic field and the current which created the magnetic…

Q: Discuss the factors contributing to unsafe load. essay at least 30 words.

A: Load- In terms of electrical, the load is defined as the equipment or any other elements which are…

Q: What are sets of service-entrance conductors?

A: Since three questions are present and nothing is mentioned, as per the guidelines, in the following…

Q: what do you mean by super conductor

A: A superconductor is a material that does not offer any resistance when the current flows through it…

Q: can you discuss how and why distribution feeders are operated radially?

A: Radial distribution system is used in electrical power systems to provide electrical power supply to…

Q: Explain prevention of Arc restriking Theories in circuit breaker.

A: Solution: There are two theories regarding the prevention of arc restriking.   1. Splepian theory or…

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.