What should be the effective diameter of the largest pore in a tensiometer cup used to measure pressure heads of -8.0 m?
Q: Q1:: Consider a large cubic ice block of (1 m') surface area floating in seawater. The specific…
A: The given question is based on the Archimedes principle, the loss of weight of the immersed body in…
Q: A pressure gage in kPa scale is installed in an underwater submarine. What should be the reading in…
A:
Q: Question 4 a) Determine the rise in water level h as a result of surface tension between two glass…
A:
Q: What is the approximate capillary rise of water in contact with air (surface tension 0.073 N/m) in a…
A:
Q: If the value of the atmospheric pressure reading using the barometric gauge is (750 mm) and the…
A:
Q: 1. Is there a difference between the values of the nozzle velocity (Va) and the jet velocity (v,)?…
A: As per our guidelines we are supposed to answer only one question. Kindly repost the other questions…
Q: What is the time Rate of Capillary Rise?
A: The capillary rise is defined as “the ability of water to flow upward due to the force produced by…
Q: Determine whether the block shown is in equilibrium and find the magnitude and direction of the…
A:
Q: A block of steel ( s.g. = 7.85 ) will "float" at a mercury-water interface as %3D shown in the…
A: Answer = 238.26 mm
Q: A 425-Newton stone cube having 28-centimeters sides is lowered into a rectangular vessel. If the…
A:
Q: A plate is sliding down a plane at an angle of 30 ° as shown in figure 5. The plate weighs 15lb,…
A:
Q: For the same condition as the previous problem (After a solid block is put on a scale in the water…
A:
Q: Q4) Use water as a drilling mud to drill a well to a depth of 3000 feet. Calculate the pressure…
A: Given Data: Depth of well is D=3000 ft. Assume unit weight of mud as γ=80 lb/ft3.
Q: A differential manometer is attached to a pipe as shown. Determine the pressure difference between…
A: 2 rules :- 1. Pressure in a liquid at a particular level is same everywhere. 2. There is increase in…
Q: Situation 1. A 19-mm diameter tube is inserted in sea water and later in water. Assuming the tube is…
A:
Q: Describe Components of Menard-type pressuremeter.
A: pressuremeter: Pressuremeter test on soil is very easy and quick way of calculating stress-strain…
Q: A square plate is expanding uniformly each side is increasing at the constant rate of 1.5 cm/min.…
A:
Q: Q1:- Consider a large cubic ice block of (1 m) surface area floating in seawater. The specific…
A: The above question is based on the archimedes principle, the loss in weight of the submerged body is…
Q: Show complete solution. Please include the diagram if necessary, given, find, and solution. A…
A: Given: open cylindrical tank depth D =18.0 feet . open cylindrical tank radius R= 7.00 feet. first…
Q: 2. An open U-tube having a diameter of 12mm contains mercury at a depth of 130mm. If 0.014 liters of…
A:
Q: A line was found to be 2865.35 m long when measured with a 30-m tape under a steady pull of 6.5 kg…
A: Given, Measured length (Lm) = 2865.35 m Standard length of tape (Ls) = 30 m Applied pull (P) = 6.5…
Q: A line was found to be 2,865.35 m long when measured with a 30-m tape under a steady pull of 6.5 kg…
A:
Q: Situation H. A 100m tape weighing 3kg that is standard at 10°C and a 30N pull is used to measure a…
A: Length of tape = 100m Weight of tape = 3kg Standard temperature = 10°C Measured length of Tape =…
Q: TWO CONCRETE BLOCKS WEIGHING 1800 N EACH FORM PART OF THE RETAINING WALL OF A SWIMMING POOL. WILL…
A: Retaining Wall: A wall that holds or keeps soil in situ behind it. Concrete slabs, concrete slabs,…
Q: 2.52 A water column in a glass tube is used to measure the pres- sure in a pipe. The tube is 1/4 in.…
A: When a small diameter tube is inseated into a liquid, there may rise or fall occurs in liquid level…
Q: A plate at 0.010 mm distant from a fixed plate, moves at 10 cm/s and requires a force of 1 N per…
A: given- speed du=10 cm/s=10×10-2 m/sdistance dy=0.010 mm=0.010×10-3 mshear stress τ=1 N/mm2=106 N/m2
Q: Define vibrating wire piezometer.
A: Vibrating wire piezometers are used to regulate the pressure of pore water in soils.
Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.05 N/cm²…
A: Given data- Pressure inside water droplet-P=0.05 N/cm2Surface tensionσ=0.075 N/mTo Find-Diameter of…
Q: Calculate the wall thickness for a cylindrical vessel carrying internal pressure of 1.5 ksi. Use…
A:
Q: How is the magnitude, direction and location of the hydrostatic force determined? Derive the…
A: pressure- the intensity if the pressure at a point is defined as a external normal force per unit…
Q: A figure shows a differential manometer connected at 2 points A and B. At A pressure is 100 kn/m^2.…
A:
Q: 7. A simple U-tube manometer can measure negative gauge pressures.
A: A simple U-tube manometer can measure negative gauge pressures. This is true statement
Q: Question 1 You are presented with a bucket of water (y = 72 dynes/cm, T= 25C) that has a thin…
A: ASKED: To determine the rise of water in the thin cylindrical tube. Given, Surface tension γ = 72…
Q: Explain about the Dilatometer and Pressure meter Tests.
A: The Dilatometer test is an on-site testing process, which is used to estimate the deformation and…
Q: A block of steel ( s.g. = 7.85 ) will "float" at a mercury-water interface as %3D shown in the…
A:
Q: A closed cylindrical tank is to be made from a material 230.91m² in area. If the volume of the…
A: h =7m explanation is given in below step
Q: Situation 3: A calibrated test of a 0.00785 m² circular sharp-edge orifice in a vertical side of a…
A: Given data : The value of weight of water W=22300 N The value of horizontal distance X=1.92 m The…
Q: An open tank 3.2m wide by 4.7m long is filled to a depth of 5.7 m with a liquid whose specific…
A: Determination of ABSOLUTE pressure at bottom of tank
Q: Explain The major component of Menard’s prototype pressuremeter apparatus.
A: A pressure meter is a device that is used for determination of the relations of stress strain of…
Q: 1. A thin walled cylinder whose diameter is 9.73 meters has a thickness of 18 mm. What is the…
A:
Q: A water column in a glass tube is used to measure the pressure in a pipe. The tube is 14 in.(6.35…
A:
Q: A differential manometer is attached to a pipe as shown. Calculate the pressure difference between…
A:
Q: The Center of Pressure Apparatus was designed to determine the hydrostatic force exerted by a fluid…
A: The cross-section of the apparatus=75 mm×100 mm The depth measured from the base of the vertical…
Q: What happens to the pressure within a container when thevolume of the container increases? Whose law…
A: Whenever the temperature, as well as quantity of gas in a closed environment, stays constant, the…
Q: Water flows through a 5 inch diameter pipe at 10 ft/s. If a test is performed using mercury moving…
A: Given, For water Velocity = 10 ft/s Diameter = 5 inch For Mercury Velocity = 4 ft/s
Q: A differential manometer is attached to a pipe shown. Calculate the pressure difference between…
A:
Q: 3 m 2 m 3 m 2 m D B 12 kN
A:
Q: Question 2 Refer to the given figure below. Given: a = 1.55 m b=1.11 m c=0.73 m Carbon…
A:
Step by step
Solved in 2 steps
- Bourdon-type pressure gauges are used in thousands of applications. A deadweight tester is a device that is used to calibrate pressure gauges. Investigate the operation of a deadweight pressure tester. Write a brief report to discuss your findings.Explain about the Dilatometer and Pressure meter Tests.If the specific weight of glycerin is 79.2 ft/lb³, what suction pressured is required to raise the glycerin 9 in vertically in a ½ diameter tube? The answer was already given, please show the solution. Answer: -0.412 psi
- Describe Components of Menard-type pressuremeter.Hi, I need help with this question please. Thank you. A cantilever thin-walled cylindrical tube of inner diameter ? = 30cm and thickness ? = 1cm is subjected to a torque T and internal pressure p as shown below. The free end of the tube is closed. Strain gauges A and B mounted on the surface of the cylinder give readings ?? = 7.5 × 10^−6 and ?b = 19.7x10^−6, respectively. The bar is made of steel having Young's modulus E=200 GPa and Poisson's ration ? = 0.3. a) Determine the torque, T, and internal pressure, p. b) Determine the absolute maximum shear strain ???? at point C.Determine the pressure required to decrease the volume of the following fluids by 2%:a. waterb. glycerinc. SAE motor oil5. Calculate the shear modulus for a given cylindrical metal specimen and test results of T = 1700 N.m, L = 20 cm, D = 5 cm, ɸ = 0.02 rad. Can you tell what the material is?
- Show complete solution. Please include the diagram if necessary, given, find, and solution. A large, open cylindrical tank is 18.0 feet deep having a radius of 7.00 feet is layered with 6.00 feet of water (SG = 1.00) 8.00 feet of oil (SG = 0.650) and 4.00 feet of mercury (SG = 13.6). Compute the pressure (psi) at the bottom of each layer.Part 2Two pipes are connected by a manometer as shown. Determine the pressure difference, between the pipes in kPa.The wall thickness of a 3-ft diameter spherical tank is 3/4 in. Calculate the allowable internal pressure if the stress is limited to 7 ksi. CHOISES ARE: 583.333 psi 156.25 psi 208.333 psi 222.222 psi 300 psi 243.056 psi 166.667 psi
- Looking for assistance with Mohr Circle. I'm not asking for the whole problem to be worked, but can someone walk me through test1 (data for it is at the bottom of the screen) for total stress mohr circleRefer to the photo provided. Please make sure your handwriting is readable. Internal pressure and axial tensile force are applied to an open cylindrical tank 605 mm in diameter and 3.02 mm thick, resulting in the final stresses illustrated in the Mohr's circle. If a = 40.10 MPa, b = 100.06 MPa, and c = 45.05 MPa. 1. Determine the kPa value of the internal pressure. 2. What is the axial force's magnitude in kN?The initial head is 300 mm in a falling head permeability test. It drops by 10 mm in 3 minutes.How much longer (in seconds) should the test continue, if the head is to drop to 180 mm ? a. 1681 b. 7145 c. 1457 d. 2532