Answered: What two types of receptacles are…

What two types of receptacles are permitted to be used to replace a defective receptacle in an older home that is wired with knob-and-tube wiring where no equipment grounding means exists in the box?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter6: Ground-fault Circuit Interrupters, Arc-fault Circuit Interrupters, Surge Protective Devices, Immersion Detection Circuit Interrupters, And Appliance Leakage Current Interrupters

Section: Chapter Questions

Problem 12R

See similar textbooks

Related questions

Q: In both exposed and concealed locations, where a cable wiring method is installed parallel to…

A: In both exposed and concealed locations, where a cable wiring method is installed parallel to…

Q: An electrician is installing switches and receptacles in a house where the wall and ceiling…

A: A continuity tester equipment is used to determine if an electrical path between two point is…

Q: . Identify and explain the safety procedures and precautions that should be followed for fire…

A: There is always a danger when installing some form of wire or wiring system. If the wires are not…

Q: Show the connections for a ceiling outlet that is to be controlled from any one of three switch…

A: The given figure consists of the 120 V source, two three-way switch, and one four-way switch. it is…

Q: Describe the functions of earthing/grounding in providing safety to user when a live wiretouches the…

A: Earthing: Earthing/ grounding is of low resistance wire and high melting point which prevents from…

Q: What should be done with light sources that are connected at each end of a cable while it's being…

A: For proper safety, we should always take care of certain measures and steps needed to be taken while…

Q: 20. Four electricians are discussing wiring under raised floors in information technology equipment…

A: Given, Four electricians are discussing wiring under raised floors in information technology…

Q: You are asked to replace an ungrounded receptacle (two wire) and there is not a source of ground…

A: The NEC Per sec.210-7(d)(3) allows the following installations while replacing the 2-wire…

Q: The _______ point is where the facilities of the serving utility and the premises wiring connect. A.…

Q: A transfer switch shall be required for all fixed or portable optional standby systems for buildings…

A: According to article 702 - Optional Standby System A fixed or portable optional standby systems…

Q: What is the 277-volt–single-phase–60-hertz system used for? Select one: A. RECEPTACLE BRANCH…

A: 277-volt–single-phase–60-hertz system has the voltage of 277 volt- and frequency of 60 hertz it is…

Q: 9. How is equipment containing ungrounded electrical systems required to be marked? A. With green…

A: An ungrounded system is a system that is not grounded intentionally. The neutral wire of an…

Q: homeowner wants to add 12 general-purpose receptacle outlets to the electrical drawings before the…

A: Please refer the attached images for the complete answer..

Q: When used as service equipment, a panelboard (load center) must be ______________________ that is…

Q: 11. What are at least two instances where a splice is allowed to be made in underground consumer's…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: What does WP stand for on an outdoor receptacle?

A: A residential floor and lighting layout plan is shown in the given figure.

Q: A single-phased load is located 2800 ft from its source. The load draws a current of 86 A and…

A: Maximum voltage drop is 3% Edrop=480×3100=14.4 V So maximum allowed resistance is…

Q: The frames of ranges, wall-mounted ovens, counter-mounted cooking units, and clothes dryers under…

A: Materials that allow current to flow through them are called conductors. The materials that do not…

Q: what wire size is needed on a one 20 amp, 120-volt bathroom circuit? what wire size is needed on a…

A: Proper wire size is an important fact to be considered in any of the electrical wiring installation.…

Q: Refer to the National Electrical Code or the working drawings when necessary. Where applicable,…

A: We are authorized to answer one question at a time, since you have not mentioned question you are…

Q: Overcurrent devices do not have to be readily accessible if ____. Select one: A. LOCATED WITHIN A…

A: Overcurrent devices do not have to be readily accessible if LOCATED ADJACENT TO THE EQUIPMENT WHERE…

Q: What is the NEC code for a receptacle by a pool

A: NEC stands for National Electric code. It is standard for safe installation of Electrical wiring and…

Q: In your own words and from your own understanding, avoid plagiarism or copying from the Course…

A: we need to explain the molded case circuit breaker

Q: Not more than ____ ft of high-voltage cable shall be permitted in nonmetallic conduit from a…

A: The following is a list of some of the requirements for neon design by National Electric Code(NEC):…

Q: The required 125v, 1 ohm, 15A or 20A receptacle on rooftos for heating, air-conditioning and…

A: These equations comes under the class of equipment that needs to be serviced or maintenance.…

Q: Explain the method of carrying out insulation resistance test on an electrical installation

A: Insulation resistance is the quality of an electrical system that degrades with time, temperature,…

Q: At least one of the insulating ____ must be removed from receptacles that do not have a contact yoke…

A: At least one of the insulating ____washer--- must be removed from receptacles that do not have a…

Q: What is the NEC code for receptacle near a pool

A: NEC stands for National Electric code. It is standard for safe installation of Electrical wiring and…

Q: Q.12 What provides branch-circuit protection, and where is it located? Select one: A. BREAKERS…

A: 12. A fuse is an electrical gadget used to shield the circuit from overcurrent. It comprises a…

Q: Which room makes use of Split-Circuit receptacles?

A: A lighting layout for a residential floor plan is shown in the question. We need to find out which…

Q: Receptacles that provide power for a spa or hot tub shall be ________. Select one: a.…

A: According to ARTICLE 680 of National electricity code (NEC), any outlet that supplies a hot tub or…

Q: 19. Which of the following is bonded to the grounding electrode system of the supply system by being…

A: Equipment bonding jumper is basically used to provide a connection between the equipment grounding…

Q: Is it acceptable by code to use switch legs that have less ampacity as the rating of the circuit?…

A: Ampacity : The maximum current, in amperes, that a conductor can carry continuously under the…

Q: 21.Which of the following wiring methods may be used inside the duct used for vapor removal and…

A: 21. As per the NEC guidelines, no wiring system should be installed in any duct used for vapor…

Q: If nonmetallic device boxes are used with receptacles or switches, how are metal cover plates…

A: According to the NEC codebook, receptacles must be listed for the purpose and must be marked with…

Q: You're evaluating the components of a multioccupancy building that won't have an on-site employee.…

A: In this question we will write about occupant compliance with NEC....

Q: of p o How many conductors enter the ceiling fan/light wall box? Switch ond out let boxes s tirst…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: Four electricians are discussing wiring under raised floors in information technology equipment…

A: "Control" for the disconnecting means should be gathered, labelled, and placed near the main exit…

Q: For residential wiring, not less than one 15-ampere lighting branch circuit should be provided for…

A: The National Electrical Code (NEC) is a regionally adoptable standard for the safe installation of…

Q: The space between a door casing and window casing is 3.5 in. Two switches are to be installed at…

Q: Terminals of switches and receptacles marked CO/ALR are suitable for use with _______________,…

A: The term CO/ALR is abbreviated as Copper Aluminium Revised. The switches are rated as 15 A and…

Concept explainers

Thermocouple

A thermocouple is a temperature measurement device. It includes diverse metal wires which are joined collectively to form a joint. At the same time as the junction is hot or cold, a small voltage is generated inside the measuring thermocouple electrical circuit, which corresponds to the temperature.

Question

What two types of receptacles are permitted to be used to replace a defective receptacle in an older home that is wired with knob-and-tube wiring where no equipment grounding means exists in the box?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the Code requirement for receptacles connected to circuits of different voltages and installed in one building?_____________________
Which room makes use of Split-Circuit receptacles?
a. The Code requires a minimum of two small-appliance circuits in a kitchen. Is it permitted to connect a receptacle in a dining room to one of the kitchen small-appliance circuits? _______________ What Code section applies to this situation? _______________ b. Are outdoor weatherproof receptacles permitted to be connected to a 20-ampere small-appliance circuit? _______________ c. Receptacles located above the countertops in the kitchen must be supplied by at least _______________ 20-ampere small-appliance circuits.
Is a GFCI receptacle permitted be installed as a replacement in an old installation where the 2-wire circuit has no equipment grounding conductor? _________________
What does WP stand for on an outdoor receptacle?
ladder diagram for bottom half of a switched receptacle is to always be hot plus a duplex receptacle that is controlled from two locations using a coast 3-way wiring system multiwire circuit
Which of the following installations for a kitchen waste disposal that operates on a 15-ampere, 120-volt branch circuit requires AFCI protection? (Circle the correct answer.) a. The disposal operates by a switch that is installed above the kitchen counter. b. The disposal operates by a switch that is installed under the counter next to the disposal. c. Both (a) and (b) d. Neither (a) nor (b).
Refer to the specifications in the back of this text following Chapter 33. a. What electrical codes must be conformed to? ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ b. What is the wiring method to be used in the workshop? ________________________________________________________________________ c. What size conductors are to be used for the lighting branch circuits? ______________________ AWG the small-appliance branch circuits? ______________________ AWG d. What section of the specifications tells us the size of the service entrance to be installed for this residence?
When a metal junction box is installed as part of the cable wiring to a clothes dryer or electric range, may this box be grounded to the circuit neutral conductor?
Assuming all terminals are rated 75 degrees Celsius, and you have six (6) #10 AWG THHN/THWN conductors in a conduit and the conduit is run inside an office building, What is the largest size circuit breaker or fuse permitted to protect this wire?