What will happened if circular orifice is replaced by nozzle in constant head Inlet tank.
Q: Impulse-Momentum A 3.0-kg block slides on a frictionless horizontal surface, first moving to the lef...
A:
Q: A general aviation aircraft is flying at a geopotential altitude of 10,000 ft with a true airspeed o...
A: Given: h=10000 ft=3048 mtxs; s=0.05 lbft3
Q: Ball (A), of mass 0.300 kg, initially moving at 5.00 m/s strikes a stationary ball (B) of the same m...
A: Given: The mass of ball A is 0.300 kg. The initial velocity of ball A is 5.00 m/s. ...
Q: DYNAMICS OF RIGID BODIES A projectile was fired at a velocity of 20m/s at an angle of35 degrees with...
A: The initial velocity of the projectile is given as, vo = 20 m/s The angle of projectile is given as,...
Q: DYNAMICS OF RIGID BODIES problem 1.A ball was thrown downwards at a velocity of 4m/s from a height o...
A: Given data, Height = 40 m Downward velocity of the ball = 4 m/s
Q: Consider a small object of mass m attached to one end of a string and whirled in a vertical circle o...
A: Given that a mass m attached to a string is whirled in a vertical circle of radius R which moves wit...
Q: A 1.50 kg snowball is fired from a cliff 12.5 m high. The snowball's initial velocity is 14.0 m/s, d...
A: Given, height of cliff, h =12.5 m initial velocity of snowball, u =14m/s mass of snowball, m = 1.5kg...
Q: There is a maximum depth at which a diver can breathethrough a snorkel tube (Fig. E12.17) because as...
A: The depth at which the diver present is given as, h = 6.1 m The density of water is given as, ρ = 10...
Q: 2 kN 2 m B 2m C 2 m D 4 kN 3 m E
A:
Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for...
A: Impedence matching : impedance matching is the practice of designing the inputi Impedence of a load ...
Q: QUESTION 1 When you are swimming at the bottom of a pool, the water above and around you exerts forc...
A: Depth of water h = 5.0 m Water density = 1000 kg / m3 Pressure P = g h = 1000 X 9.8 X 5.0 = 49000 ...
Q: A 1000-kg auto travels up a 3 percent grade at 20 m/s. Find the horse power required, neglecting fri...
A: Given: Mass of the auto: M=1000kg Auto travels at 3% grade Speed v=20m/s To find: The horsepower req...
Q: Q/What are the practical applications of the subject of Admittance and Current Locus
A: To answer: The practical applications of the subject of Admittance and Current Locus.
Q: What is the instrument used in Faraday’s experiment? a) Galvanometer b) Ammeter c) Voltmeter d) Mete...
A: A
Q: Vector A points along the positive x-axis and has a magnitude of 4.0. Vector B points along the posi...
A:
Q: A solenoid consists of N = 110 turns of wire in a coil of length d = 4 cm and cross-sectional area A...
A: Ampere Circuital Law The line integral of the magnetic field around a closed loop is equal to the pr...
Q: In the figure, a sound of wavelength A is emitted isotropically by point source S. Sound ray 1 exten...
A: Let Δx be defined as the path difference which is the difference between distance travelled by ray 1...
Q: Help me
A: dubbing mixers proceed to balance all of the elements and record the finished soundtrack. Dubbing is...
Q: Draw the electric field for a system of three particles of charges +1 µC, +2µC, _and -3 µC fixed at ...
A: Electric field lines are said to be imaginary path traced by positive test charge that is placed in ...
Q: You are working at a radar station for the Coast Guard. While everyone else is out to lunch, you hea...
A: Position for Ship distance=51.2km, θ=360PS=(-51.2sin360, 51...
Q: Blocks 1 and 2 with masses m1 and m2, respectively, are moving with a constant acceleration. If Ѳ is...
A: aIf θ is equal to 90 degrees, for what value m1 would the acceleration of the two blocks be equal to...
Q: . Calculate the relative size of the pulses in a GM counter produced by MeV protons and 4 MeV a-p...
A: To find: The relative size of the pulses in a GM counter produced by MeV protons and 4 MeV α particl...
Q: Derive the Lorentz transformation connecting a frame SS (the lab frame) to a frame S′S′ that moves w...
A: Since the matrix for the rotation of xy plane is, cosϕsinϕ-sinϕcosϕ And, the new coordinate is x'y' ...
Q: An elevator with mass of 200 kg rises with an acceleration of 1 m / sec^2. What is the tension in th...
A: Given data m=200 kga=1 m/s2
Q: are given: (x) = Bo + Br; = t,t 2 0; PIo) = 0.96; 3P(35) = 1.253P(65)-
A: Solution:
Q: A uniform rod of length L = 90 cm and mass M = 300 g is free to rotate on a frictionless pin passing...
A:
Q: iSin n x dx. 7.
A: Given integral is,
Q: A ball is thrown vertically upward with a speed of 15 m/s. Determine the time of flight when it retu...
A:
Q: A 1.5-kg circular disk rotates about a vertical axis through its center and perpendicular to its pla...
A: The angular momentum of a rotating body is related to its moment of inertia and angular speed as: L ...
Q: A spring that stretches 10 cm under a load of 200 g requires how much work to stretch it 5 cm from i...
A: Given data F=200 gX1=0.1 m
Q: Suppose the cup is used to shield the ball while not being allowed to contact your bare hand or othe...
A: Given: The cup involves the shield of ball that being not allowed on contacting the bare hand or ele...
Q: The electric field in the region between the plates of a parallel plate capacitor has a magnitude of...
A:
Q: Pick out the material that cannot be used to make permanent magnets. a) Copper b) Aluminum c) Steel ...
A: Introduction: To create a magnet from a non-magnetic metal piece, the metal atoms must be correctly ...
Q: Consider the system shown in the figure which is excited from its base by a sinusoidal displacement ...
A: Solution given below:
Q: (a) In Color Plate 19a, red light with a wavelength of 633 nm strikes a grating at normal incidence ...
A: (a) The diffraction angle formed by the grating when light is incident on it is given by- nλ=dsinθd=...
Q: In reference to the figure, the plank is uniform and weighs 500 N. How large must W be it T1 and T2 ...
A: From the given figure 2T1=500+W ⋯⋯1 Taking moment about the point 1 500×0.2 L+W×0.4 L=T1×0.4 L100+0....
Q: How do the allowed orbits for electrons in atoms differ from the allowed orbits for planets around t...
A: Answer: Electrons in an atom occupy a large, empty volume of space around the nucleus like the plane...
Q: Find the resistance value of the carbon resistor if the colors of the four bands are red, red, red a...
A: Correct option- c) 22× 102 Ω ± 10% Given- The colors of resistor are Red, Red, Red and Silver. Th...
Q: How can we map out CMBR?
A: Given: A mapping of CMBR is given as,
Q: Which among the following has a relative permeability much larger than 1? a) Diamagnetic materials b...
A: The relative permeability is given by:
Q: A 1380 N was applied to a 271 kg block, find the normal force if the angle 0 = 85.5 degrees. %3D F S...
A: The force applied to the block is F = 1380 N The mass of the block is m = 271 kg The force is applie...
Q: A f:X-Y where X,Y e Z* , and 0SX<23 and, 0< Y<59, X is hour of Q.No.1. clock and Y is minute of digi...
A: (a) Yes , f is well defined. For every X \epsilon [ 0, 23] there is some Y \epsilon [0, 59].
Q: A pion of positive electric charge (n*) and mass m, = 139,6 MeV/c², resting in the laboratory, decay...
A:
Q: A city has two high schools. The first school has a maximum enrollment of 900 students and the secon...
A:
Q: What is the velocity of a particle if it's momentum and kinetic energy are equal
A:
Q: The power output of a certain public-address speaker is 6.20 W. Suppose it broadcasts equally in all...
A:
Q: What is the relation between angle of dip and magnetic latitude? a) tanδ=4tanλ b) tanδ=4tanλ c) tanδ...
A: B
Q: Pick out the temperature at which iron becomes paramagnetic? a) 800 °C b) 700 °C c) 600 °C d) 500 °C
A: A
Q: uonenba x(k + 2) + 3x(k + 1) + 2r(k) = e(k) %3D where k = 0 otherwise 1, e(k) = %3D 0, x(0) = 1 %3! ...
A:
Q: Ferromagnetic materials does not show hysteresis. a) True b) False
A: Introduction: When a ferromagnetic material is magnetized in one direction, it will not get back to ...
What will happened if circular orifice is replaced by nozzle in constant head Inlet tank.
Step by step
Solved in 2 steps
