What's the difference between regulated and unregulated redundancy?

Q: A discrete-time signal a[n] has a period of N > 2. Which of the following is/are always true about…

A: The Fourier series coefficient is Ck=1N∑n=0N-1xn e-j2πNkn Statement I:  CN+k+1=1N∑n=0N-1xn…

Q: QUESTION 18: The circuit parameters in Figure 11.36 are V ¹ = 5V, V = −5V, and Io = 155 µA. The…

A: The given circuit diagram is shown below: It is given that: V+=5 VV+=5 VIQ=155 μAKn'=80 μA/V2Kp'=40…

Q: R GF 7 66- G₁ Gg 1654 G2 93 (G4 G8 2

A:

Q: Region I Mr₁=4 is the side of the plane y+z=1 containing the origin Region II 1 Mr₂ = 6 for given…

A:

Q: Schneider LON I 0.OFF MCCB MCB RCD Isolator

A:

Q: A single period of the magnitude and phase spectra of a discrete-time signal is given as follows: 1…

A:

Q: 25. A current wave is given by i = 4+2√2sin 30+ 4√2sin 50 The r.m.s. value of current wave is A. 10…

A: R.M.S. (Root Mean Square): The full form of R.M.S. is Root Mean Square. Direct current flow on a…

Q: VSI R4 R₂ {R6 VS₂ R5 R₁₂ с ww Q2. In the above circuit, Vs1 = 15 V, Vs2 = 16 V, R1 = 2 Ohm, R2 = 9…

A: In this question we have used Kirchoff's voltage law which states that the algebraic sum of all the…

Q: (a) A potential divider is formed from two elements with impedances, Z₁ and Z₂. Sketch the layout…

A: Voltage across parallel circuit and current in series circuit remain same Voltage in series circuit…

Q: Solve for I1 using Thevenins Theorem. Rthis 7.09 Ohms. Answer is 3.086 A

A: To apply Thevenin's Theorem we need to open the concerned branch as shown below,

Q: diode? Under what circumstances does the output voltage remain constant in a limiter circuit with…

A: The zener diode is the diode that works in the reverse bias.  The zener diode with the limiter…

Q: Give the electrical network below: Vin 5 + R1 10k sig Q2 Q1 RL 10 Vout

A: Here both the pmos and nmos transistors are off. See the analysis to get clarity.

Q: B. Maximum current circuit Circuit connection for minimum current delivered by a 30V DC source:…

A: This question belongs to circuit theory . It is based on the concept of ohm's law in the circuit .…

Q: Q1// Si transistor to be used in cct. Shown below has a current gain ß that varies from 50 to 200 if…

A:

Q: Given the information appearing in Fig. 120, determine: a. Ic. b. Vcc. c. B. d. RB. Vcc 12 V RB IB =…

A: In this question,   We need to calculate the collector current,  VCC  , current gain and base…

Q: Two single phase alternators operate in parallel

A: For KVL equations- Summation of voltage drops in a closed loop is  always zero. For KCL equations-…

Q: The Residual Current Device (RCD) checks the .6 :current balance between (answer can be found in the…

A: Residual current device (RCD) : It is a protection device use to automatically cut off the circuit…

Q: will give upvote when both questions are answered

A: Brief description : In the above given question they are discussing about MOSFETS. MOSFET is a 3…

Q: 2- Find the efficiency of a 150 kVA transformer at 25 % full load at 0.8 p.f. lag if the copper loss…

A:

Q: 4. The last step is to let one bit f determine the function of an adder/subtractor output z+y iff 0…

A: Given                               x + y    if  f=0       Output =…

Q: what's the main difference to sketch u[n-4] and scketching delta[n-4]?

A: The solution is given below

Q: 11.9 Find the equivalent Z of the network in Fig. P11.9. 20 -j10 -jin Z c b 192 102 www

A: Solve the problem

Q: D7.6. Evaluate both sides of Stokes' theorem for the field H = 6xya, 3y²a, A/m and the rectangular…

A:

Q: Finel TF. for the following systems

A:

Q: What is the percent resolution of a DAC that has 7 inputs?

A: Given  7 input DAC, we need to find the percentage resolution. Find the below attachment for clear…

Q: Find the overall transfer function of: 5s + 3 44s² + 10 G1- G2 = > 12s3 +2s +5 354 + 5s² + 3 1) G1,…

A:

Q: EVALUATE EACH SIDE OF STOKE'S THEOREM FOR A REGION: 0<=p<=4 0<=<=2+ Z=0 If H= 3 pa

A:

Q: ... H.W.JPG A.W Em In an FM systems the modulating frequeng the modulating voltage Um = 2 volt, and…

A: In this question we have given FM modulation....We have to find out deviation and modulation…

Q: the signal x(t) = cos (360 pi t + pi/4) is sampled at 100 hz and the sampled signal is reconstructed…

A: The signal x(t) = cos (360 pi t + pi/4) is sampled at 100 hz and the sampled signal is reconstructed…

Q: Assuming ideal op amps, find the voltage gain vo/vi 100 ΚΩ 20 ΚΩ το 20 ΚΩ (0)

A:

Q: Q3) For the circuit shown in fig.(2), IT I, sin(100t+10) + I, sin(300t+20) + I, sin(400t+35°) A, if…

A: Given data, Total current, iT=I1sin100t+100+I4sin300t+200+I4sin400t+350 A In=nIn+1 Power consumed…

Q: A solenoid containing 8 coils produces 10 V of power. How many coils will produce 5 V? A. 2 B. 4…

A: In this question,   We need to choose the correct options How many coils will produce 5 V?

Q: In the figure shown below, if R=212 and L=3 H, find the current in A flowing through the inductor…

A: We need to find out inductor current for given circuit.

Q: 1- Find the transfer function of the system whose Bode diagram is given in Fig.1 ▲ MaB 20 dB/dec. 40…

A: Solve the problem

Q: 3- At full-load, the Cu and iron losses in a 100-kVA transformer are each equal to 2.5 kW. Find the…

A: Steps: Find the loading  percentage according to given load and full load. Then calculate cu loss…

Q: An 11,000/230-V, 150-kVA, 50-Hz, 1-phase transformer has a core loss of 1.4 kW and full-load Cu loss…

A:

Q: Question. Express the real part of each of the following signals in the form Aeat cos(wt + b). where…

A:

Q: 1. An ion (q +2(e)) enters a magnetic field with flux density 1.2 Wb/m² = at velocity of 2.5 x 105…

A: In this question we will find force on ion due to given magnetic field .... Note :- as per our…

Q: For the circuit shown in Figure, determine the branch currents using Kirchhoff's laws 50.1 Ω 0.05 Ω…

A:

Q: 15. A light bulb draws 300 mA when the voltage across it is 240 V. The resistance of the light bulb…

A: Given  I = 300mA , V. = 240V Find R

Q: Part II. Kir a. Find the necessary KVL/KCL equations to solve the problem. b. Compute for 11, 12,…

A:

Q: . Bulb 1, 2,3 controlled by switch 1 in a parallel connection, bulb 4 controlled by switch 2 in…

A:

Q: 1- A 200-kVA transformer has an efficiency of 98 % at full-load. If the maximum efficiency occurs at…

A:

Q: - A OO MOVABLE ARM (WIPER) OB If the above potentiometer is rated for 10 kohm and the resistance…

A:

Q: = 3. Find the voltage for an R-2R DAC of 4 bits with given condition of R R = 2kn, VR = 16v and…

A:

Q: 3) Let's design a 1mA current source with this NMOSFET. For the circuit below, write an equation for…

A:

Q: Find Power supplied by all sources by using. (Loop analysis). Not the network Containg Duble super…

A: In this question,   We need to determine the power supplied by the source?  We know power P= VI

Q: Implement a Boolean function F (A, B, C, D) = A +B'C+A'C'D. Also implement with NAND gates.

A: The solution is given below .

Q: 5- A single-phase transformer, working at unity power factor has an efficiency of 90 % at both…

A:

Q: Q3): For the circuit shown in Figure 2, multiple choice:- v? 2K A. If (Vi₁ = 1 v and Vi₂ = 0 v), the…

A:

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.