When caluating the average power delivered to a bad by an AC sigre, it is not as straightforward as DC. It depere on the difference in phase between the sincecidal voltage across and currentthrough the loadi, and it relates to the RMB values. The average power or enmetimas referred to as the active or real power, is related to the underpirning snusoidal voltage and current byP-Vene Cosy-00 WIn this question there is only a resistive load, A-6.00 and the amplitude is 98V.Decame the amplitude of the curent through the load I-Workout the P96Vresistor, 6.8050HzV1R16.80ResetRUN/StopElectric PotentialPowerChargeSimulation SpeedCharge FlowCurrent Circuit:

Answered: Image /qna-images/answer/a8292ef2-35c2-4585-99cb-c79eed4d92bf.jpg

When caluating the average power delivered to a bad by an AC sigre, it is not as straightforward as DC. It depere on the difference in phase between the sincecide voltage across and current through the loadi, and it related to their RMB values. The average power or enmetimas referred to as the active or real power, is related to the underpinning snusoidal vorage and current by P-Vee Cosy- We In this question there is only a resistive load, A-6.00 and the amplitude is 98V. Decamine the amplitude of the current through the load I- Workout the P- 96V resistor, 6.80 50Hz V1 R1 6.80 Reset RUN/Stop Electric Potential Power Charge Simulation Speed Charge Flow Current Circuit:

When caluating the average power delivered to a bad by an AC sigre, it is not as straightforward as DC. It depere on the difference in phase between the sincecide voltage across and current through the loadi, and it related to their RMB values. The average power or enmetimas referred to as the active or real power, is related to the underpinning snusoidal vorage and current by P-Vee Cosy- We In this question there is only a resistive load, A-6.00 and the amplitude is 98V. Decamine the amplitude of the current through the load I- Workout the P- 96V resistor, 6.80 50Hz V1 R1 6.80 Reset RUN/Stop Electric Potential Power Charge Simulation Speed Charge Flow Current Circuit:

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.26P: A small manufacturing plant is located 2 km down a transmission line, which has a series reactance...

See similar textbooks

Similar questions

In the circuit given on the side Ra=Rb=Rc=Basic frequency of 13 Ohm loadsit is powered by an AC voltage of f= 60 Hz. Power derived from the sourceits value was measured as Pk=9372.12 Watts. Each switchingthe element is triggered in such a way that it will be at 180 degrees.The DC bus voltage (E=?) and the effective value of the ic phase current(ic rms=?) calculate.
Derive the power angle equation for a power system network and draw the corresponding curve.
Derive the expression for the average and rms load voltage for a three phase HWCR operating with an RL type load. ? What will be the average power in the load for the circuit shown, when alpha = π/4 Assume SCR to be ideal. Supply voltage is 330 sin 314t. Also calculate the RMS power .?
A small manufacturing plant is located 2 km down a transmission line, which has a series reactance of 0.5/km. The line resistance is negligible. The line voltage at the plant is 4800V(rms). and the plant consumes 120kW at 0.85 power factor lagging. Determine the voltage and power factor at the sending end of the transmission line by using (a) a complex power approach and (b) a circuit analysis approach.
Find the line-to-line voltage derivation equation? And the Find the derivation equation for the voltages Vab and Vbc and Vca three phase ?
Is it possible to measure the phase-shift angle in an AC single-phase circuit by an indirect method using an ammeter and a voltmeter? - Yes, but an instrument must be added to measure the active resistance of the load. - Yes, but an instrument must be added to measure the active power dissipated by the load. - Yes, but an instrument must be added to measure the frequency.
(a) Give the condition for the loss of load in a power generation system in terms of outages in generation units. (b) Give the assumption taken for the calculation of LOLP?
The open circuit and short circuit impedance of a transmission line are 200 ohm and 50 ohm respectively. What will be the characteristic impedance of the transmission line?
An area of an interconnected power system has two fossil-fuel operating on economic dispatch. The variable operating costs of these units are given by in image Determine the power output of each units, the incremental operating cost, and the total operating cost that minimizes when total load demand is 250, 500, 750, 1000 and 1250 MW, transmission losses is neglecting?
For a series ac circuit having resistive and reactive components, What does volt-ampere (VA) mean?, What does volt-ampere-reactive (VAR) mean?, How is VAR calculated?
Give 5 problems and answers of ac circuits using super position theorem
Find the continuous(DC load line) and then find the value S of the circuit below?