When looking at first arrival times in a seismic refraction survey, what relationship between the layer velocities allow us to determine the velocity of layer 3 and know that it is in fact the velocity for layer 3? a. V1 < V2 < V3 b. V2 < V1 < V3 c. as long as V2 > V3 d. V1>V2
Q: The theoretical slit width which should be used to separate the two sodium
A: Given: λ1=589.0nm λ2=589.6nm Linear dispersion is 1D=2.4nm/mm D=12.4 D=0.4167mm/nm
Q: When what you are experimenting has 'far' results with the expected results as stated by the standar...
A: Reliability:- Reliability describes the closeness in the values of different measurements of the sam...
Q: What happend when First law of Thermodynamics is applied to open system ?
A: The first law of thermodynamics is based on conservation of energy. The energy includes potential en...
Q: 3. A 1.0 kg block at rest on a horizontal frictionless sur- face is connected to an unstretched spri...
A:
Q: The pendulum apparatus in the video has a total mass of 578 grams. The pendulum rod has a small mass...
A: The pendulum with a bob of mass mb is colliding with a marble which is moving with velocity vm. Befo...
Q: 5) Sketch a y-t, v-t, and a-t graph for an object had been thrown upward, rises to the apex, then fa...
A: When an object is thrown upward, It will reach the maximum point then under the action of accelerati...
Q: I need help with the calculations on the bottom of the page Equation 2: (Cw)(mw)(Tf-Tiw) = -(Cm)(m...
A: Given: The data is as follows: Introduction: Heat capacity is the amount of heat required to change...
Q: An object with mass m is launched with initial kinetic energy E0 at an angle θ = 45° with respect to...
A:
Q: The number of atoms diffusing through a membrane with an area of 4 cm is 6.16×10³ atoms/sec (based o...
A: Fick's Law of Diffusion According to Fick's Law of diffusion, the flux of material diffusing through...
Q: The magnitude of the electric force between the two protons is 2.30 x10^-26 N. How far apart are the...
A: Magnitude of electric force between two protons is F=2.3×10-26 N Charge on proton is q=1.6×10-19 C U...
Q: Two closed vessels of equal volume contain air at 105 kPa, 300 K and are connected through a narrow ...
A: Given, Equal volume of two closed vessels at pressure 105 kPa and temperature 300 K and after connet...
Q: The answer wasn't c
A: Introduction: Particles whose wave functions are symmetric under particle interchange have integral ...
Q: Please provide a structure consistent with the following IR, 13 C NMR, and 1 H NMR spectra. Assign a...
A: Answer given below:
Q: A solenoid consists of 4200 turns of copper wire. The wire has a diameter of 0.200 mm. The solenoidh...
A: -
Q: What's the self-inductance of a solenoid with 697 loops wrapped around a cylinder. The cylinder has ...
A: We have to use some basic formula here
Q: A solenoid consists of 1,620 loops tightly wound around a cylinder with a radius of 2 cm and a lengt...
A: Magnetic field at the centre of solenoid is given by,
Q: I’m wondering if I can get some help with a previous asked question... the answer that was explained...
A:
Q: Static electricity demonstrations I need to draw diagrams for each questions a. piece of rabbits f...
A: When the two objects are rubbed, there is net transfer of charge from one body to other. As the fur ...
Q: In the first figure here, a sled is held on an inclined plane by a cord pulling directly up the plan...
A: In the second figure, the magnitude F required of the cord's force on the sled is plotted versus the...
Q: The figure below shows a 117-turn square coil rotating about a vertical axis at at o = 1,220 rev/min...
A:
Q: Question 10 ) Listen (Use equation 6.65) A satellite orbits the earth in a circle with a radius of 6...
A: Given, radius of orbit r = 6910km
Q: The counter scale of ionization chamber ranges from zero to 250 particles per second If you know tha...
A: As index is in middle , the number of particles will be half. From which number of particles per min...
Q: A length L of straight, horizontal wire is oriented perpendicular to a uniform horizontal magnetic f...
A: the main principle in this problem is equating the magnetic force to the gravitational force so that...
Q: Select the graph that best illustrates the following description: A train pulls into a station and l...
A: Graph (a): The graph (a) represents a train that is travelling at a constant speed and at the final ...
Q: 76. Interference Two identical tuning forks are struck, one a fraction of a second after the other. ...
A: Given: The modeled wavefunction of the two waves are given as
Q: Example III: A hydraulic jack has the dimensions shown. If one exerts a 5 cm diamete force F of 100 ...
A: Given data, Force, F = 100 N Diameter of the area A1 = 1.5 cm Diameter of area A2 = 5 cm
Q: Consider a spherical shell of charge of radius 7.5 m. The charge per area of the shell is constant ...
A: The electric potential at the center of the sphere is given by Where R = radius of the sphere, Q = ...
Q: A mixing beater consists of three thin rods, each 10.6 cm long. The rods diverge from a central hub,...
A: Given data: Length of rod r=10.6 cm. Cross-sectional area of ball A=4.20 cm2. Drag coefficient D=0....
Q: what is the answer of a,b and c
A:
Q: What is post treatment in 3D printing technology?
A: To answer: What is post-treatment in 3D printing technology?
Q: A coil of wire has 40 turns and a cross sectional area of 0.39 m2. When viewed from above, a steady ...
A: given, N=40 A=0.39 m2 I=1.5 A B=0.33x^ T ϕ=57° magnetic dipole μ=NIAn^where μ=magnetic dipole moment...
Q: A solenoid containing 8,733 loops per meter is producing a magnetic field of 0.06 mT at its center. ...
A: Magnetic field inside a solenoid is given by B=μ0nI where B is the magnetic field I is the current ...
Q: Where can be used three equations of motion:- (1)v=u+at (2)V²=u²+2as (3)s=ut+1/2at²
A: To answer: Where can the three equations of motion be used?
Q: A solenoid (length = 16.7 cm, radius = 1.3 cm) has a self inductance of 0.004 H. How many loops of w...
A: Given that length of the solenoid is l=16.7 cm⇒l=16.7×10-2 m Radius is r=1.3 cm⇒r=1.3×10-2 m Area...
Q: In spin systems, the existence of absolute order is equivalent to the absence of total changes in th...
A:
Q: You are working in a factory that produces long bars of copper with a square cross section. In one s...
A: In this problem , we have used , the formula for induced current to find the current in the rod then...
Q: A small object is placed 20 cm from the first of a train of three lenses with focal lengths , in ord...
A: Given that,An object is placed at a distance = (s1) = 20 cmFrom the first lens of focal length = (f1...
Q: Two inclines have the same height, but make different angles with the horizontal. The same steelball...
A: Here, Given that the height of inclines is same. Therefore, h is same. Now, angle of inclination ...
Q: 1- What is Laplace's equation where The electric field can be written as the gradient of a scalar el...
A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question ...
Q: Consider an infinite plane with a uniform charge density of +6.8 x 10-12 C/m2. Let point A = (0, 0,...
A: Given: Charge density σ=6.8*10-12C/m2 A(0,0,11.0) B(0,0,6.4)
Q: Respiration monitor belts are sometimes used in hospitals to monitor the breathing of patients. One ...
A: Magnetic Flux The magnetic flux gives the measure of the number of electric field lines passing thro...
Q: What are the three main elements in the traditional model of science?
A: Given: To explain the traditional model of science three main elements is shown as,
Q: The relative permittivity of a dielectric is 2.25. (a) What is its permittivity? (b) What will be th...
A: (a) We know the relative permittivity is given by ∈r=∈∈0 Therefore Permittivity will be ∈=∈0∈r=8.85×...
Q: A convex thin lens with refractive index of 1.50 has a focal length of 30 cm in air . When immersed ...
A:
Q: Kindly check the answer mentioned in picture containing the question before submitting the solution.
A: Given, side of the square,l=1mthickness,dx=1mm=10-3mForce,F=15Nviscosity,η=0.2Ns/m2 We know the ...
Q: 1- Define the velocity? 2- What is the viscosity? 3- What is the relationship between viscosity and ...
A: 1. Velocity is the rate of change of displacement i.e it's the measurer of what distance one travell...
Q: Respiration monitor belts are sometimes used in hospitals to monitor the breathing of patients. One ...
A:
Q: 6
A: The Convex spherical mirror produces, 1) Upright 2) virtual 3) real
Q: It is desired to project onto a screen an image that is four times the size of a brightly illuminat...
A: The refractive index of plano-convex lens is given as, n = 1.50 The radius of curvature of plano-con...
Q: 1.Two slits spaced 0.230 mm apart are 0.980 m from a screen and illuminated by coherent light of wav...
A: (a) Given: The distance between the slits is 0.230 mm. The distance between the slit and the screen ...
When looking at first arrival times in a seismic refraction survey, what relationship between the layer velocities allow us to determine the velocity of layer 3 and know that it is in fact the velocity for layer 3?
a. V1 < V2 < V3
b. V2 < V1 < V3
c. as long as V2 > V3
d. V1>V2<V3
Step by step
Solved in 3 steps with 1 images
