When the 10V are applied across a 20-ohm resistor, the current is

Q: i) the power delivered by isi; + ii) vz. Vsi " 200[V] Vx 5.1[kN] Vy * 2.5[k2] Nigi isi 20[mA/V]vx…

A:

Q: Answer number 8 only

A: Control systems are represented by transfer function. This  can be written in both time domain and…

Q: 2. Consider the three phase generator below: Phase A Phase B N Phase C N S a) If the stator rotates…

A:

Q: The following information is given in connection with a load circuit consisting of two parallel…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 13. A permanent magnet motor has the ability to generate to a variety of magnetic fields True False

A: A permanent magnet motor is a type of motor that uses magnetic in the field along with the windings.

Q: In the given signal flow-graph below, find A using Mason's gain rule. Gz{s) G(6) R(s) O G(s) Ge(s)…

A:

Q: For the digital system shown in below: 1) Write down the difference equation that represents the…

A:

Q: 18 17 20 100 6 30 150 40 200 DCV.A 50 250 DCV.A ACV ACV/ When selector switch is set to 10 DCV, what…

A: In this question,  We need to determine the reading of the voltmeter?  If DCV is selected the…

Q: In stepper motor, the number of digital pulses required to obtain half of one complete revolution…

A: Since, one complete revolution is of 360 degree, so the half revolution is of 180 degrees.

Q: Q.5) (a) Find the unknown currents I1, I2 I3 I4, I5 I6 from the Electric circuit in Figure 1. 20 2…

A: Note: As per the policy we can solve only 1 question at once, please re-upload the remaining part as…

Q: Find an expression for the closed-loop gain G = v0/vS. Then, assume that R1 = 1kΩ, R2 = 4kΩ, C = 1uF

A: In this question,  We need to determine the gain G If R1 = 1kΩ, R2 = 4kΩ, C = 1uF. We are solving…

Q: Consider the circuit below and answer the following questions: I'x R1 I'cc V1 V. 2 kN 2 k2 T'y ww R2…

A:

Q: 6. find the exact solin of the wrrent I for a given aruuit firel : a:) exact sol'n b) is it…

A:

Q: H. W. Find Vo 12^ 121 121 3 12A Vo 4A 121 Ans: (24V)

A: In this question we need to find a voltage Vo.

Q: Assuming that initial gain, K, of the system represented in the figure below is 1, the calculate the…

A: It is given that: %Mp=0.25

Q: 1. +24 V 22 kn 2.7 kn Si B = 75 4 kn 50 mv 6.8 kn 1.5 kn 2.0 kn In the given circuit above, work out…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: The network shown in Figure 2 contains two voltage sources, V, = 30Z0° and V2 = 2020°. Using mesh…

A: In this question,  Find the power in the resistor  We know Power P= I2 R Watt

Q: How do we convert a full adder to a subtractor cum adder

A:

Q: Determine the total resistance (R) and the current flow (I) for the circuit shown in the…

A:

Q: Determine the transfer function. 1 S 3 R(s) C(s) X,(s) X (s) -10 -24

A:

Q: s² – m? 1) f(t)=t cos(@t) Ans. F(s)= (s² + ø*}

A:

Q: Provide the nature of the response (undamped, overdamped, undamped, critically damped) of the output…

A:

Q: Question 3 For a circuit with one input A and one output Z implemented using T flip-flops with T =…

A:

Q: Given the signal flow graph, apply mason's rule to acquire the single transfer, function, G(s).…

A:

Q: consider the spiral shown below. If B = 0.5 az Wb/m², R = 20 ohms, l = 10 cm and the bar moves with…

A:

Q: 9:17 Asiacell l. docs.google.com a Calculate the natural frequency in (rad/sec) of the circuit…

A:

Q: Derive the flux density, D, by applying Gauss's Law: 1. Infinite Line Charge

A:

Q: Which sub-atomic part of an atom is used as a fundamental unit of electricity par'icularly when it…

A: 1.answer: C electron  Electron is the fundamental particle which causes current. While remaining…

Q: In an analog VOM, which scale calibration is not evenly divided into equal parts? A. AC ampere B. AC…

A: In an analog VOM, which scale calibration is not evenly divided into equal parts? A. AC ampere B. AC…

Q: D3 D2

A: FORWARD BIAS- Diode conducts in positive half cycle and does not conduct for negative half cycle.…

Q: Sketch the transfer curve for an n-channel depletion type MOSFET with IDSS=14 mA and Vp = -5 V

A:

Q: *6.66 For the circuit shown in Fig. P6.66, find the labeled node voltages for (a) ß= ∞ (b) B= 100

A: aTaking the value of β=∞Writing expression of ββ=IcIB∞=IcIBIB=Ic∞   =0 AFor a transistor the…

Q: . It is a machine which converts electric energy into mechanical energy or work and requires…

A:

Q: On a short/long bond paper, draw a schematic circuit diagram following your house wiring with…

A: electrical wires are designed to bear consistent electric current which should not lead to a fire in…

Q: Use Boolean Laws and Rules to simplify the following equations: 1. V = AC + ACD + CD 2. W = (B +…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: The following information is given in connection with a load circuit consisting of two parallel…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Choose the correct answer 1) If speed of a synchronous generator decresed from 1800 RPM to 900 RPM…

A: In this question we will write machine related question problems... Note :- due to bartleby policy ,…

Q: 1. Given the circuit in Fig. 3.8, find the average power supplied or absorbed by ell each element.…

A:

Q: A clothes dryer rated at 6kW is connected to a 120/240 V, single-phase, three-wir individual branch…

A: In this question,  We need to choose the correct options What is load current if  total load 6kW…

Q: 2)For the following circuit, assuming the Op-Amp is ideal, fill in the table for the missing values…

A:

Q: The differentiation of 7 u(t) is 0 7t2 07 6(t) 07 r(t) 07

A: Given, Function ft=7ut

Q: Which of the following s-plane represents the graph for the system having a transfer function G(s) =…

A: In this question,  We need to determine the representation in the s plane.  If transfer function is…

Q: Given that Vin 110Z30° V find Van and Ven assuming a negative sequence.

A:

Q: 2) Sketch the dc load line. Show detailed graph/sketch and computation of values plotted. 3) Is…

A:

Q: a broadcast radio transmitter radiates 9 kilowatts when the modulation percentage is 75. how much of…

A:

Q: Given first order LCCDE y(n)=ay(n-1)+x(n) 1) find the transfer function. • 2) find impulse response.…

A:

Q: Q1: Draw the block diagram for AM/DSB-SD system uses a carrier frequency 1MHZ and pilot carrier of…

A:

Q: A charged particle of mass m 7.6X10-8 kg, moving with constant velocity in the y-direction enters a…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Diecions:Using the schematic below and the test results listed, which load contains an open?…

A: Fig: Given circuit  it is given that when all load is connected in the…

Q: What is the overali efficiency of the solar collector with the following test results? Calculated…

A:

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.