Answered: When the temperature increases, the…

When the temperature increases, the tension of the transmission line will and the sag will А. decreases, decreases В. decreases, increases C. increases, decreases D. increases, increases

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.22MCQ

See similar textbooks

Related questions

Q: P7.12 a. Find the ABCD parameters of the lumped inductor L, of impedance Z, shown in the figure. b.…

A: a) The ABCD parameter of the lumped L1 of impedance Z1 shown in fig: V1I1=ABCDV2-I2ABCD…

Q: 13.) In practice, what would happen to the transmission line voltage when it is heavily loaded and…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: Vo coswt Z, = 50 10

A: V(L) = V+ejBL [1+τej(ϕL-2βL)] I(L) = V+ejBLZo [1-τej(ϕL-2βL)]

Q: 2. a) Draw nominal t model of Transmission Line.

Q: A 29 Km line is terminated by its characteristic impedance. At a certain frequency the voltage at 1…

A: As the line is terminated at characteristic impedance .Hence, it is considered to be equal to…

Q: 1. A transmission line at river crossing is supported by two towers. Height of the lower tower is 72…

Q: Find the input impedance of 75-ohm lossless transmission line of length 0.1λ when the load is…

A: Given: Z0=75 ΩL=0.1λ And the load is short.

Q: Q4: Lossless transmission line of 0.25 having Zo = 100 2 terminated by load impedan = 40 +j 30 2.…

Q: A transmission line is supported from two towers at heights of 40 m and 58 m above ground level, the…

Q: Consider the lossless transmission line shown below. Z, = 60 2 Z 125 2 VE

A: Reflection coefficients determine how much wave is is reflected at discontinuity of medium. It is…

Q: Viva Questions: 1. What is the difference between Primary and Secondary constants? 2.Define…

A: 1. The fundamental difference between the primary and secondary constants is that the primary line…

Q: A 100MHZ generator with V=1020° (V) and internal resistance 502 is connected to g lossless 502 air…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: The A and C constants of a medium length transmission line is 0.936 + j0.016 ohms and (-5.18 + j914)…

A: Basic problem on transmission line in power system.

Q: Q4: Lossless transmission line of 0.25 2 having Z, ZL = 40 + j 30 Q. Find the following numerically…

Q: Q: A transmission line is supported from two towers at heights of 40 m and 58 m above ground level,…

Q: Problem 3: A voltage generator with v, (t) = 5 cos(2n × 10°t) V and internal impedance Zą =50 N…

A: (a):Γ=ZL-Z0ZL+Z0Γ=100-j100-50100-j100+50Γ=50-j100150-j100Γ=0.62e-j29.7'

Q: Consider the lossless transmission line shown below. -/6- Z, = 60 2 Z 125 2 VE

A: Reflection coefficients determine how much wave is is reflected at discontinuity of medium. It is…

Q: 2. a) Draw nominal π model of Transmission Line.

Q: Q1: The parameters of long three-phase transmission line 200 km with 50 Hz are l = 1.3 mH/km, c = 9…

A: Given length of the line, l=200km. The impedance per unit is calculated as

Q: Find standing wave ratio s

A: Reflection coefficients determine how much wave is is reflected at discontinuity of medium. It is…

Q: A 500-kV 60-Hz three phase transmission line is 463 km long. The series impedance is z=0.06+j0.4 Q…

Q: 2.5 For the parallel plate line shown in the accompanying figure, derive the R, L, G, and C…

A: Given Let R Resistance parameter Let be the inductance parameter Let Cbe the inductance…

Q: Draw the equivalent circuit of long transmission line and derive the equations of sending end…

A: Types of Transmission line Long Transmission line Medium Transmission line Short Transmission…

Q: has V, = 15/0° Vm Z, = A 40-m-long transmission line shown in Figure 30 + j60 N, and V, 5/-48° Vms…

Q: What are the factors which governs the performance of transmission line?

A: There are totally 4 parameters which includes Resistance, Inductance, Capacitance and Shunt…

Q: (b) A three-phase 765 kV, 60 Hz, 300 km transmission line is characterised by the following positive…

Q: d, a) Pi-Model of this transmission line. b) Efficiency of the line (n%).

Q: Q4. In a long transmission lines the line constants are considered as Lumped parameters Distributed…

A: The line constant of transmission line are Resistance, Inductance, Capacitance and Conductance.

Q: Current through the line Sending end voltage Sending end power factor Regulation of transmission…

Q: The transmission line has the following data weight of the conductor = 8.2 kg/m, Tension in the…

A: Given, Weight of the conductor(w)=8.2 kg/m Tension in the conductor(T)=1765 kg Conductor sag(S)=4.2m…

Q: The char. impedance of the trans. line is 50-Ohm and the resistance of it is 0.1Ohm/meter. What will…

A: For the distortion less transmission line the attenuation constant is independent of the frequency.…

Q: A 60-ohm distortionless transmission line has a capacitance of 0.15nF/m. The attenuation of the line…

A: Given data Z0=60 ΩC=0.15 nF/mα=1.15×10-3 Np/m i) Expression of characteristic impedance Z0=LC…

Q: 3. b) For a certain transmission lines, if l=50m and ta2=400nsec, then Vp will equal to: 1. 125*10°…

Q: Consider the standard lumped element model of coaxial cable transmission line: R G. with "per unit…

A: Given the transmission line as shown below: Given R=3.4 Ω/m, L=0.4 μH/m, G=14.5 mΩ-1/m and C=150…

Q: has V, = 15/0° Vm Z, = A 40-m-long transmission line shown in Figure 30 + j60 N, and V. = 5/-48° Vm…

Q: What is the percentage voltage regulation of short transmission line if its sending end and reciving…

Q: Transmission lines can be categorized on the basis of their length. Explain short transmission line…

A: Trans mission lines can be cateogerized into 3 types on the basis of their lengths 1. Short lines…

Q: (а) Transmission lines can be categorized on the basis of their length. Explain short transmission…

Q: 3-2. A lossless transmission line has a characteristic impedance of 50 N and is terminated in a load…

Q: Show that a lossless transmission line of "18 alway hers 1 Zinl = Zo leyth independent of the load…

Q: Q3 The characteristic resistance of a loss-less transmission line is given by (a) 1/√LC (B)…

A: Q3 The characteristic resistance of a loss-less transmission line is given by (a) 1/√LC (B) √LC…

Q: Refer to the lossless transmission line shown in Figure 11.49. (a) Find I and s (b) Determine Z, at…

A: We have given Refer to the lossless transmission line shown in given figure (a)Find τ and S (b)…

Q: 1- A lossless transmission line of characteristic impedance 50 ohm is to be matched to a load…

Q: Question # 03: What is the difference between balanced and unbalanced line transmission lines, show…

A: Given: The difference between the transmission lines which are balanced and unbalanced is asked.

Q: A quarter-wave lossless line has a characteristic impedance of 50 N and is terminated in a load of…

A: It is given that: Zo=50 ΩZL=100 ΩVg=20 V (rms)Zg=50 Ω

Q: Write ‘T’ for True and ‘F’ for False: Constant A, B, C, D represents the voltage of a transmission

A: The explanation is as follows.

Q: ) Write ABCD Parameters of the nominal π model of the medium transmission line.

Q: A 0.875 A section of 50 N lossless line is dr by a source with vg(t) = 10cos(8T * 10°t + 60°) and Z,…

A: As asked in the question we have to calculate the frequency of operation for the given system.

Q: Consider the lossless transmission line shown below. Z= 60 2 125 2 Find Zin at generator

A: Reflection coefficients determine how much wave is is reflected at discontinuity of medium.It is…

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

Please answer clearly

When the temperature increases, the
tension of the transmission line will
and the sag will
А.
decreases, decreases
В.
decreases, increases
С.
increases, decreases
D.
increases, increases

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Viva Questions:1. What is the difference between Primary and Secondary constants? 2.Define Transmission line Input Impedance?
1/ Calculate the voltage reflection coefficients at the terminating end of a transmission line with a characteristic impedance of 75 Ω when it is terminated by (a) a 75 Ω termination, (b) an open-circuit termination, (c) a short-circuit termination and (d) a 50 Ω termination.
A single circuit 60 Hz transmission line. the conductors are Linnet type with flat horizontal spacing of 17.46 feet between conductors. Determine: (a) Assume that the line is short with a length of 50 miles, calculate the parameters of the line and draw the equivalent circuit. (b) Assume that the line is average with length of 150 miles (Pi-nominal model). draw the pi-nominal circuit for the transmission line and calculate its parameters (Z and Y/2 values, where Z is the series impedance of the transmission line and Y is the shunt admittance).
Write ‘T’ for True and ‘F’ for False: Constant A, B, C, D represents the voltage of a transmission line.
The voltage on a 75 ohm transmission line decreases by 0.10% per meter. What length of this transmission line would result to 3 N attenuation?
a)find IBC load current? b)VAB give line voltage? C)Calculate the total complex power on the transmission line ?
A 75 Ω lossless line is terminated in error with a 93 Ω resistor. A generator sends 100 mW down the line.(a) How much power is dissipated at the load?(b) What happens to the rest of the power?
A 50-ohm lossless transmission line has series inductance of 250 nH/m and shunt capacitance of 100 pF/m. What is the time delay per unit length (in ns/m) of this transmission line? Enter only the numerical value. No need for the unit. Use four decimal places (if the answer is not an interger).
(Note: Write all the formulas related to problem step by step and neatly) What will be the power loss of a distribution line if the power at the sending and receiving end is 550kVA and 537kVA respectively? What will be its transmission efficiency?
A)Ibc =? find the load current=? B)Vca calculate the line voltage =? C)Calculate the total complex power in the transmission line=?
)A 60-ohm distortionless transmission line has a capacitance of 0.15nF/m. The attenuation of the line 1.15*10-3 Np/m. Calculate: (i) The line parameter resistance, inductance and conductance per meter of the line, (ii) Voltage at a distance of 1Km and 4Km with respect to sending voltage.
a) Find the IBC load current.b) Give the Vca line voltage.c) Calculate the total complex power on the transmission line.