Which formula can be used to estimate the Book Value?
Q: The beam shown below with a length L = 20 m and a rectangular cross section that has a width of b = ...
A: To Find :- Load P
Q: A square pile, 21 m long is driven into a homogeneous sand layer. The pile's width (diameter) is 0.4...
A: The given data : L=21 m Diameter, d=0.4 m The standard penetration resistance=12 To calculate= the u...
Q: What is the porosity of an undisturbed cylindrical soil sample of diameter 10 cm and length of 5 cm ...
A:
Q: Determine the member force LK(kN) in the figure shown. 2 m-2 m 2m 2 m 2m 2 m 2 m 2 m a 50 kN 50 kN 5...
A: We have to determine the value of member force LK in KN as shown in the figure as per the given data...
Q: What criteria will you used to decide the type of (flume, open ditch, surface pipe or underground pi...
A: Flumes are specially shaped, engineered structures used to measure the flow of water in open channel...
Q: A bullet of mass 0.05 kg moving with a speed of 400 m/s penetrates 15 cm into a fixed block of wood....
A: Use work energy Work by a force= change in kinetic energy
Q: BACKSIGHT FORESIGHT DE im) ELEVATION (m) STA RR (m) VD (m) RR (m) VD (m) (m) (m) BM- I01.245-4° 25' ...
A:
Q: 3. Calculate the total load on a 4'x4'x1' spread footing that is buried 3' below, and a hot tub is l...
A:
Q: 4" 16" 3 No. 8's 12" 7 ft
A:
Q: ructions: Using a W21x44 beam to support the loads, determine the maximum uniformly distributed load...
A: Given Simply supported steel beam Lrfd method Calculate allowable uniform load
Q: Calculate the cost per cubic yard to move earth for a project that plans to use a back-hoe and syste...
A: Calculate the number of bucket loads as follows: Calculate the bucket volume by using the formula: ...
Q: The moisture content of a soil at which the moisture is no longer available in sufficient quantity t...
A: (D) wilting point is the correct answer A wilting point the plants are no longer able to extract the...
Q: What is the porosity of an undisturbed cylindrical soil sample of diameter 10 cm and length of 5 cm ...
A: Given data in question Diameter Length Volume of water To find out Porosity
Q: 4" 16" 3 No. 8's 12" 7 ft
A:
Q: Cavitation and flashing are two different phenomena that should be avoided in the valve operation. ...
A: Introduction- Cavitation and flashing are very common in valve operations. These two are different p...
Q: 4. (Problem 5.76 from the text book) Knowing that the allowable normal stress for the steel used is ...
A:
Q: A T-intersection has a total of 2,400 collision incidents over the last 5 years. Given that the annu...
A: 1) A A three-way junction is a type of road intersection with three arms. A Y junction generally has...
Q: A column 450 mm x 450 mm square supports a dead load of 1000 kN and a live load of 780 kN. The allow...
A:
Q: (Problem 5.50 from the text book) Determine (a) the equations of the shear and bending- moment curve...
A:
Q: MAKE 1 PROBLEM (QUESTION AND SOLUTION) REGARDING TRAVERSE SURVEY IN THE FUNDAMENTALS OF SURVEYING. I...
A: Question: The following interior angles were measured in a closed traverse. The bearing of line AB w...
Q: A ball is shot from the cannon at A with the initial velocity VA directed at the angle tetha with th...
A: ASKED: To determine the radius of curvature of the cannonball at the highest point. Initial veloci...
Q: A watershed 600 ha in area experienced a rainfall of unifom intensity 2.0 cm/h for duration of 8 hou...
A:
Q: Watershed River Banks O Wetlands O Straw deep
A: It is a topographically delineated area of land where rainwater is collected through a river system ...
Q: Q1: Determine the allowable load capacity for the driven pile of 0.6 m diameter embedded in a layere...
A: We have to determine the value of allowable load capacity for the driven piles of 0.6 m diameter emb...
Q: Determine the total metacentric height MBo when its rolled on one side in meters B) determine the an...
A:
Q: A trapezoidal masonry dam with vertical upstreamn face is 7 m high, 2 m at the top and 4 m wide at t...
A: Given; B=3 m H= 6 m μ=0.8 Weight of concrete= 23.5 KN/m3
Q: 5. A steel cylindrical air receiver with 5 feet diameter and pressure load of 180 psi, design stress...
A: Given Design stress=9500psi Diameter of air receiver = 5 ft
Q: DETERMINE THE UNCONFINED COMPRESSIVE STRENGTH OF SOIL IN BOTH CONDITIONS. S.N. Discription In-situ s...
A:
Q: The following values were found from the corrected load versus penetration curve after completing a ...
A: CBR test It stands for California Bearing Ratio The California Bearing Ratio is a measurement of the...
Q: Draw the B.M.D for the following
A: The diagram given in the question is as follows:
Q: Two people are arguing on the flow regime of water in a certain trapezoidal canal with the following...
A: Q = 0.09m3 /s
Q: The total weight of soil when saturated 1526 g and weight of the soil after drying is 1053 g. If the...
A: The given question is related with geotechnical engineering . In this question we are provided with ...
Q: THREE-MOMENT EQUTION (3ME) AND SLOPE DEFLECTION METHOD (SDM) ASSUME w = 12 kN/m P = 46 kN El = const...
A:
Q: kN M = kN - m
A:
Q: 1. A masonry dam of trapezoidal cross section, with one face vertical and horizontal base. The dam i...
A:
Q: Use A36 steel and select a double-angle tension member to resist a service dead load of 20 kips and ...
A:
Q: 7. (a) Calculate angle y(in degrees) using Laws of cosines c? = a² + b? – 2ab cos y. 417 a=5, b = 7,...
A:
Q: The state of stresses in the xand y directions at a point in a given material is shown in the figure...
A: step 1-
Q: A simple circular curve is specified with a 12° degree (arc basis) horizontal curve and e=0.08. A st...
A: Radius R =500 ft Coefficient of side friction fx =0.13
Q: In your own words, describe what is meant by Prescriptive vs Performance based engineering and provi...
A: Prescriptive vs Performance based engineering Prescriptive fire Design:- Prescriptive fire design i...
Q: The maximum discharge of a river during floods is 200 cu.m./s. A weir is constructed across the rive...
A: A weir or low head dam is a barrier across the width of a river that alters the flow characteristics...
Q: accident rate
A: Accident rate per road sections measures the accident rate based on the total kilometers of travel.
Q: A 6-h stom had 6 cm of rainfall and the resulting runoff was 3.0 cm. If the o-index remains at the s...
A:
Q: Solve the fixed-end moment (FEM) at joint A in kN-m and joint B in kN-m. Use a= 10kN/m, b= 32kN/m, a...
A:
Q: For the beam loaded as shown in the figure below, determine the following unknown using any geometri...
A:
Q: Use Method of Consistent of Consistent Deformation to solve the horizontal reaction at D in kN of th...
A:
Q: Find the support reactions and stresses in the members of the frame as shown. |15 kN 15 kN/M 25 kN 1...
A: Hi there! the area of members is unknown so, the stress on the members can not be determined.
Q: The sample soil from a barangay in Baguio City was used in laboratory test to identify the requests ...
A: Find Liquid limit, LL Plot semi log graph with number of blows in x axis and water content in y axi...
Q: From the given figure, determine the following characteristics of the resultant: (a) magnitude of R,...
A: Given Data: The length AC is given as 6 ft. To Determine: (a) The magnitude of R. (b) orientation ...
Q: the
A:
Which formula can be used to estimate the Book Value?
Step by step
Solved in 2 steps with 2 images
