Which is not a term below is not a term for Reynolds Analogy? O A. f/2 B. h/c_p G O C. k_c/v_av O D. none of these

Q: (4) calculate the volume of a drilling mud prepared from water and bentonite only (bent %-8%), to wh...

A: Given, The density of mud, ρ = 10 ppg = 10 lbgal×119.826 ×kg/m31 lb/gal = 1198.26 kg/m3 The volume o...

Q: You are learning Russia {passiv}

A: The given statement is to be converted into passive voice.

Q: The crystal structure of titanium at ambient temperature and pressure is close-packed hexagonal, has...

A:

Q: (a) Discuss four (4) factors that affects the recycle structure of a process flow diagram. (b) Based...

A: In chemical process, to represent them we use process flow diagram.  Every equipment is denoted with...

Q: A simple Rankine cycle works betw een pressures 46 bar and 10 Kpa, the initial condition of steam be...

A: given p2=46 bar,p2=0.21 barfrom steam tablesat p=46 barh1=2797.0S1=6.010at p=0.1 barh2=29.4Kj/kghf2=...

Q: Q1/ A Petroleum cut has the following ASTM D86 distillation data:- Volume% distilled Temperature "C ...

A: given to calculate watson constant K K=(MeABP)13SGMeABP=VABP-∆VABP=T10+T30+T50+T70+T905

Q: There are two circulating flows in a fluidized catalytic cracking (FCC). Explain these two circulati...

A:  In a fluidized catalytic cracking (FCC) Explain-Two circulating flows in FCC

Q: The initial value of the equipment and its salvage values ​​are Rs.10 lakhs and Rs.2 lakhs respectiv...

A:

Q: What are the major differences between chemical pulping and mechanical pulping ?

A:

Q: The equilibrium constant, Kc, for the following reaction is 55.6 at 698 K. H2(g) + I2(g) 2 HI(g) Cal...

A: Equilibrium constant, KC= 55.6 Temperature, T= 698 K   Reaction is: H2 (g) + I2 (g) → 2HI (g)   H2 =...

Q: Saturated steam is condensed as a film on a vertical plate of height 50 cm. If the local beat transf...

A: This question is based on the Nusselt Equation  Data given : Height of the plate  = 50 cm Local heat...

Q: Q3/ Estimate the Watson characterization factor K, molecular weight, Aniline point, carbon to hydrog...

A: Give data: Mean average boiling point = 99 0C API gravity = 52

Q: 2. Explain about electrochemical potential. Show and explain about Interphase Equilibrium Condition ...

A:

Q: A simple Rankine cyele works befween pressures 3100 hpa anob looo kpa, the initial cordifion of Stea...

A: Find cycle efficiency Work ratio Specific steam consumption Where given  P1=3100 Kpa =31 bar P2=1000...

Q: (Barbir Chp6 Problem 1) Determine the required number of cells and cell active area for a fuel cell ...

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: Case Study: Two AES exchangers in series have difficulty heating a process stream from 50°C to 90°C ...

A: An adiabatic system which transfers heat from hot fluid to cold fluid is called heat exchanger. This...

Q: QUESTION 3 THERMODYNAMICS: A 1.09 g sample of acetic acid (HC2H302) was burned in excess oxygen in '...

A:

Q: Peat gas analyses 22% methane, 12% ethane, 15.8% carbon monoxide, 7% nitrogen and 43.2% oxygen. 100 ...

A: Given: Component % CH4 22 C2H6 12 CO 15.8 N2 7 O2 43.2 Total  100  

Q: Q6. The overall volume expansion ratio of a Carnot cycle is 15. The temperature limits of the cycle ...

A:

Q: A gas mixture containing 15 mole% A and 85 mole % inert is fed to an absorption tower where it is co...

A: The flow diagram of the given absorption tower is as follows:

Q: A mild steel tank of wall thickness 10 mm contains water at 90 °C. The thermal conductivity of mild ...

A: The system consists of three different resistances to the flow of heat. The first resistance is the ...

Q: EXPERIMENT: EFFECT OF REGULATING REFLUX RATIO ON TOP PRODUCT COMPOSITION IN DISTILLATION PROCESS OB...

A: Refractometer is used to measure the water content of liquids, by measuring the refractive index of ...

Q: 1. A gas bubble has a volume of 0.500 cm³ at the bottom of the lake where the pressure is 3.49 atm. ...

A: GivenVolume of bubble at bottom of lake=0.500 cm3Pressure of bubble at bottom of lake=3.49 atmPressu...

Q: What is the “glass transition temperature” of a polymer? (a) How can it be measured? (b) What molecu...

A:

Q: Q4: Write down the answer after converting the polar coordinates (-2, 4Tt/3) into the Cartesian coor...

A: Given:  r = -2  θ = 4π/3 To calculate the Cartesian Coordinates (x , y ) we know that,  cos(θ ) = x ...

Q: Using Newton’s iterative method find the molar volume of methane at 600 bar and 300K  (provided the ...

A: Given: P = 600 bar = 600×105 N/m2T = 300 Ka = 0.2285 N.m4b = 4.27×10-5 m3R = 8.314 J/mol.K Newton's ...

Q: a. Explain briefly the concept of colligative properties b. As you boil a relatively concentrated sa...

A: To  a. Briefly explain colligative properties b. As you boil a relatively concentrated saline (i.e. ...

Q: Consider a reaction A → R processed in 5 CSTR's placed in series. Overall time constant is 10 minute...

A: given: A→R t=10 minutes k=0.2 min-1 C0=1 mole/m3 CN=?  

Q: QUESTION 10 A dilute solution of acetic acid produced by fermentatioň and oxidation of natural carbo...

A: Given Mass of acetic acid =44.1 g Mass of water=68.8 g   Now molar mass of acetic acid=60 g Molar ma...

Q: 3-35 The hydraulic lift in a car repair shop has an output diarneter of 30 cm and is to lift cars up...

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: Bacterial cell mass is reported to have the following empirical formula: CsH;O2N. Determine the carb...

A: Given that: Empirical formula of bacterial cell mass = C5H7O2N Molecular mass of the cell= 113 g/mol...

Q: Explain the step by step calculations and assumptions for this problem: Two AES exchangers in series...

A:

Q: 15 kg each of nitrogen and hydrogen are mixed together at 300 kPa and 298 K. determine  the followin...

A: Molecular mass of Hydrogen = 2 Molecular mass of Nitrogen = 28 Moles of Hydrogen, nH = 152=7.5 kmole...

Q: THERMODYNAMICS: A 1.09 g sample of acetic acid (HC2H302) was burned in excess oxygen in a bomb calor...

A: Given data: Mass of acetic acid = 1.09 g Heat capacity of calorimeter = 2.67 kJ/0C Mass of water = 7...

Q: n fixed-bed leaching there is medium used please mention one or two only.

A:

Q: calculate the API values for oil types with these SG values : ( 1.03 ), ( 0.965),( 0.829 ) and class...

A: Specific gravity is the ratio of the density of the substance to the density of the reference materi...

Q: 3-IC What is the difference berween gage pressure and absolute peessure?

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: Two AES exchangers in series have trouble heating up a process stream from 50ᵒC to 90ᵒC, and cooling...

A: Heat exchanger equipment works on heat transfer. The heat is transferred from hot fluid to cold flui...

Q: Q4. Fluid enters a condenser at the rate of 40 kg/min with a specific enthalpy of 2000 kJ/kg, leaves...

A: In a condenser, the heat energy is removed in order to change the vapor into liquid. It is the rever...

Q: Tools: Material: Environment: Observation: Type of corrosion : Prevention:

A:

Q: A simple Rankine cycle works betw een pressures 43 bar and 10 Kpa, the initial condition of steam be...

A:

Q: Orthonitroanaline (an important intermediate in dyes-called fast orange) is formed from the reaction...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: Q3: How many 100 lb sacks of Barite are used to increase the mud weight of 100 bbl of 10 ppg mud to ...

A: Weighting up is an important part of the drilling process. There are various weighting agents such a...

Q: Body A has a positive charge of 0.2 µC and body B has a positive charge of 0.37 µC. If 87 x10^12 ele...

A: Charge of Body A ,Q1  =0.2 μCCharge of Body B ,Q2  =0.37 μCelectron transferred from B to A = 87 x 1...

Q: 3. H.W Date Dec. 2021 A petroleum cut has the specific gravity (SG = 0.825 at 60 °F) and the mean av...

A: Specific gravity is the ratio of the gravity of the substance to the gravity of the reference materi...

Q: Q6/ Do you think that distillation is a good method for classifying and studying petroleum propeties...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: 5 b) Draw the bode plot for the process: (s+2)(3s+7)

A: Bode plot for the process 5/(s+2)(3s+7)

Q: Q2. 0.3 kg of air at 350 kN/m2 and 35 °C receives heat at constant volume until its pressure become7...

A:

Q: Some hypothetical metal has simple cubic crystal structure. If its atomic weight is 62.28 g/mol and ...

A:

Q: Problem# 14: A stream containing 30 wt% ethanol (E) and 70% water (W) is blended with a stream conta...

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...