Which of the following commend is used to displays a list of directly connected Cisco devices? O a. show ip interface brief O b. show ip route O c. show cdp neighbors O d. show rip neighbors
Q: installer executes 'ipconfig' to see what the IP addres is but it comes up with a 169.254.254.10…
A: Question 7: Answer is APIPA(automatic Private IP Addressing) Explanation: computer need a valid IP…
Q: Which of the following best describes DTP? O Negotiates a trunk between two Cisco devices O…
A: Dear Student, Dynamic Trunking Protocol is used to negotiate a trunk between two Cisco devices.
Q: Q4 Which of the following is NOT a network device? Gateway. Linux. А. В. С. Router. D. Firewall. Е.…
A: The most well known and widely employed open source operating system is Linux. Linux is refers to an…
Q: Which of the following network can run both IPV4 and IPV6 addresses and allows the host to…
A: Answer : - option B) Dual stack network.
Q: Which of the following is the function of a DNS in a network O A Defines the name of each node…
A: C) Translate IP addresses to URL and vice versa
Q: Which of the following are important things to do if instead of using Dynamic Host Configuration…
A: About important thing to do if instead of using Dynamic Host Configuration Protocol (DHCP),we…
Q: Which of the following command is used to manipulate network routing table? a. Route Print O b.…
A: a.) Route print command Route command is useful to view and to manipulate the IP network routing…
Q: Which of the following is a problem or restriction while configuring Etherchannel? O a. Cisco…
A: Which of the following is a problem or restriction while configuring Etherchannel? a. Cisco…
Q: * What does a VLAN do? O Acts as the fastest port to all servers. O Provides multiple collision…
A: Question 1: The answer is Option D. VLANs break up broadcast domains at layer 2.
Q: Which of the following port scans attempts to initiate a communication channel via every available…
A: TCP FIN scan is used to determine if ports are closed on the target machine. This type of scanning…
Q: Which of the following security technique should be used first to install and configure wireless…
A: Option A) Change the default username and password of the wireless router
Q: Which of the following is used in the options field of IPv4 ? a. Strict source routing b. Loose…
A: Internet Protocol version 4 (IPv4) is the fourth version of the Internet Protocol (IP). It is one of…
Q: Which of the following is not a network device? a. Router b. Gateway c. Ramp d. Hub
A: Router is a device used to route the data packets in the network Hub is network device used to…
Q: Which Cisco command will provide information about the status of all interfaces including the number…
A: Show Interfaces, this is the command used.
Q: Which of the following devices takes data sent from one network device and forwards it to the…
A: For transmitting data we have multiple devices based on requirement and security. Some of the…
Q: Which of the following features of a network connection between a switch and server is not improved…
A: LACP: Link Aggregation Control Protocol (LACP) is an IEEE 802AX standard used for dynamically…
Q: You are a network administrator and want to configure both IP v4 and IPV6 in the router interface.…
A: you are a network administrator and want to configure both ipv4 and ipv6 in the router interface.…
Q: Which of the following is a proprietary Cisco protocol and uses distance-vector routing? EIGRP RIPV2…
A: Distance vector routing protocols are: RIPv2: Simple distance vector routing protocol IGRP: First…
Q: Which of the following port scans attempts to establish a communication channel via TCP three-way…
A: TCP basically stands for Transmission control protocol.It controls all transmission of data in…
Q: How many broadcast domains are created when you segment a network with a 12-port switch? * O 2 O 12…
A: In this question, we are asked the number of broadcast domains created when you segment a network…
Q: Q9) Which type of traffic is designed for a native VLAN? * tagged untagged O management O…
A: GIVEN: Q9) Which type of traffic is designed for a native VLAN? * O tagged O untagged (O management…
Q: Cable a network using Cisco Packet tracer application similar to the one in the topology diagram.
A: Answer1) how to draw cable in cisco packet tracer step by step 1.Here we take 6 PC and 2 switch ,…
Q: Which of the following is NOT serves by wireless router? a. Switch b. Router O c. Access point d.…
A:
Q: Which one of the following statement is true about IEEE 802.1X a port-based access control and…
A: IEEE 802.1x is a standard for the port based Network Access Control. It provides an authentication…
Q: Which of the following is TRUE about the Ethernet Frame Check Sequence (FCS) field? Q9 It is used…
A: I have answered both the parts and have uploaded image for the solution.
Q: Which of the below options is considered to grant specific IP address for a specific host? IP…
A: IP reservation is permanent IP address assignment, and it permanently gives particular IP address to…
Q: There are a few ways to set DNS IP address in CentOS 8, which way is not recommended? O using nmtui…
A: There are 4 ways to set DNS IP address in CentOS 8. They are : 1) using nmtui 2) using nmcli 3)…
Q: Create a simple LAN using Switch in Cisco Packet Tracer. Note : Cisco Packet Tracer is a softwear
A: Part 1:- Throughout the Logical Topology Workspace, build a basic network. Step 1:- Packet Tracer…
Q: Which Cisco command will delete all VLANS from a Switch? O a. Access all vlans O b. delete vlan.dat…
A: Lets see the solution.
Q: Which of the below cmd command will let the network admin locate which router is not reachable? *…
A: The solution to the given problem is below. ***Note: According to Bartleby policy we are not…
Q: Which of these is associated with a private network adapter? O a. Two network adapters. O b. Server…
A: The Private Network to Network interface is the link-state routing protocol used in asynchronous…
Q: Which application can we use to identify the route leading to a host? Select one: O tracert O…
A: HI THERE I AM ADDING ANSWER BELOWPLEASE GO THROUGH ITTHANK YOU
Q: Which of the following statement(s) is/are True? O switch is more intelligent than hub as it can…
A: answer is
Q: Which of the following method is not used to tackle IPV4 address space limitations? Choose one a.…
A: I have answered both the parts and have provided necessary explanation with it.
Q: A PC cannot connect to any remote websites ping its default gateway, or ping a printer that is…
A: A ping (Packet Internet or Inter-Network Groper) is an essential Internet program that permits a…
Q: Which command will be used for the following queries? 1. Check connectivity between two PCs assuming…
A: Note: we are only allowed to solve three subparts in one question. to get answers to others,…
Q: Select three pieces of information about a route that a routing tabie contains. Default gateway…
A: Defined the select three pieces of information about a route that a routing table contains
Q: Cisco command will delete all VLANs from a Switch
A: Cisco command will delete all VLANs from a Switch? a. delete all vlans b. delete vlan.dat…
Q: Which command can be used on Cisco switch to configure SVI for the VLAN 20? O a. interface vlan 20 O…
A: SVIs are configured using the interface vlan vlan-id command interface vlan 20 is used to configure…
Q: Which of the below technologies is used to monitor traffic circulating through a specific port? O…
A: SPAN (Switched Port Analyzer) is a specialized switch port that sends a duplicated copy of network…
Q: Which of the following devices takes data sent from one network device and forwards it to the…
A: Task :- Choose the correct option for given question.
Q: Which of the following is a problem or restriction while configuring Etherchannel? a. Cisco Switches…
A: Hey there, I am writing the required solution based on the above given question. Please do find the…
Q: A cable customer has reported slow access times when retrieveing email information from the mail…
A: Question 1 : Tracert is the tool which provide access time information on each segment of the…
Q: which command displays your default gateway?
A: ifconfig displays the default gateway. The ifconfig command is used for displaying current network…
Q: Which of the following statement describes the feature that is associated with HSRP? a. HSRP used…
A: which of the following describes the features associated with HSRP
Q: what is the correct Connection String for connecting to mysql running on localhost $conn =…
A: According to the question mysqli are used for the new version according to the programming language…
11
Scaling Networks
Step by step
Solved in 3 steps
- Which of the following device is used to connect two systems, especially if the systems use different protocols? a. hub b. bridge c. gateway d. repeaterQ9) Which type of traffic is designed for a native VLAN? * O tagged O untagged (O management (O usergenerated3) Which of the following devices can be used to connect computers and other end devices in a LAN? a. Router b. Server c. Repeater d. Switch
- Which one of the following statement is true about IEEE 802.1X a port-based access control and authentication protocol? a. Allows unauthorized workstations from connecting to a LAN through publicly accessible switch ports. b. Restricts unauthorized workstations from connecting to a LAN through publicly accessible switch ports. c. Not allows authorized workstations from connecting to a LAN through publicly accessible switch ports. d. Restricts authorized workstations from connecting to a LAN through publicly accessible switch ports.answer with proper explanation Don't copy paste from online website. Multiple Choices 1. A customer's wireless device is displaying a very low signal strength value. What option can improve this situation? Answer Choice Group a.Update the client device. b,Add another access point (AP). c.Update the computer program (firmware) of the devices. d.Delete the Microsoft multipath environment. 2. A client wants to know under which frequencies a wireless network operates using the IEEE 802.11n standard. Which of the frequencies below apply to this particular standard? (Select two) Answer Choice Group a. 2.4MHz b. 2.5MHz c. 5MHz d. 2.4GHz 2.5GHz 5GHz 3. A network administrator needs to install a Wireless Access Point (WAP) in a location where there is no electrical wiring. Which of the following should the administrator use to complete the installation? Answer Choice Group a. Coaxial b. Wireless Bridge c. PoE d. Multimode Fiber 4. After a technician has…which of the following devices is used to connect different network segments and manage the traffic between them? a. Bridge b. Hub c. Gateway d. Repeater
- Which of the following devices takes data sent from one network device and forwards it to the destination node based on MAC address?Question 15 kk .Which of the following is not a feature of IMAP on a Windows Server 2016 system? Determine which DNS/DHCP servers are present in an environment Determine an organizations’s IP space utilization Configure DHCP and DNS Properties Manage IP addressing Automatically update DHCP IP scope ranges Full explain this question and text typing work only We should answer our question within 2 hours takes more time then we will reduce Rating Dont ignore this line20)This command is used to display ARP table in a Cisco router. a. tracert b. ping c. show ip arp d. arp -c
- Answer the following questions and provide the commands and screenshots where applicable in a report. A. What network applications are running on the server <enter any server url here> B. What are the nameservers of <enter any server url here> C. Save a packet trace from your machine to <enter any server url here> to a file name trace.txt D. Display the routing table of the machine. E. Use grep and netstat to list all ports on the machine which are in the LISTEN stateq30- A PC cannot connect to any remote websites ping its default gateway, or ping a printer that is functioning properly on the local network segment. Which action will verify that the TCP/IP stack is functioning correctly on this PC? Select one: A. Download a troubleshooting tool from the PC manufacturer's website B. Use the traceroute command at the command prompt to identify any failures on the path to the gateway C. Use the ping 127.0.0.1 command at the command prompt D. Use the ipconfig /all command at the hosts command prompt E. Use FTP to check for connectivity to remote sitesWhich of the following statements best describe middlebox devices?a. Middlebox device act as network hubs that forward data to multiple devices.b.Middlebox devices operate only in the network layer.c.Middlebox devices are routers that process, modify, and forward IP packetsd.A firewall is a type of middlebox device.