Which of the following configurations can be used to apply Ampere's circuital law ? *

Q: The value of voltage (Vs) in Circuit-B after source transformation from Circuit-A is equal to

A: A voltge source in series with the resistance or reactance can be transferred into the current in…

Q: Calculate the direction and magnitude of the current through the 5-ohm resistor between points A and…

A: Calculate the direction and megnitude of current throughthe 5 Ω resistor b/w point A and B by using…

Q: . Why do we use voltage dividers in an electric circuit? (at least two reasons)

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: ith schematic diagram, explain the Wind Power Plant

A: Power station: A power station, often known as a power plant and also referred to as a generating…

Q: What is the number of basic nodes in the circuit given below?

A: In this question we need to find a number of basic nodes of the given circuit.

Q: In parallel circuit, if anyone of the resistor is short circuited, the remaining part of the circuit…

A: TRUE  ALL CURRENT GOES THROUGH SHORT CIRCUIT PATH  Current goes through minimum resistance path

Q: d.1. What are the two concepts that make up grounding in its simplest form? A. Impedance and…

A: Grounding :  connecting high voltage device intentionally to the group using conductor this called…

Q: Maintenance of existing plant and machines are the primary maintenance function. Select one: True…

A: TRUE

Q: 1. Superposition Method. Determine the voltages at the 5-ohm resistor due to the 24-Volt, 38-Volt…

A: Find the output voltage across 5ohm resistor using superposition theorem ?

Q: Use nodal analysis to find the voltage between terminals a,b, current in the 12 ohm resistor and the…

A:

Q: Assume that you have to buy a circuit breaker for your company which can operates up to 230 kV with…

A: The requirement for the company is that the rating of circuit breaker should be upto 230kV with an…

Q: Consider the following circuit, what is the maximum power that can be delivered to a load connected…

A: 3.125 Watt can be delivered. Detail solution in the image

Q: Write 3 points you have to consider for conduit installation

A: An electrical conduit is a tube used to protect and route electrical wiring in a building. It may be…

Q: Answer all subparts, aligned with honor code: a. Why does the bulb from the right suddenly lights…

A: Given:

Q: 9/ The Underground Cable operating at a Nominal Voltage of 36 KV is classified as Super Tension…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: What is the procedure for conducting the superposition method?

A: Super position method is used when there are two or more than two sources are there in the circuits.…

Q: 5. One of electrical wiring design procedure is that circuit all and to the appropriate panels and…

A: Electrical wiring is a proper installation of cables, switchboard, sockets etc in a circuit. Steps…

Q: illustrated in your reading material, the plug-in busway for motor Branch circuits has tap- off…

A: Correct option is c part.

Q: 1) The inverted value of the resistance is called 2) The sum of the voltage difference across all…

A: 1) The inverted value of resistance is called______________. To answer the above question first of…

Q: 15.For rangers of 8.75 kW or more in rating, the minimum branch circuit rating shall be:

A: Minimum  branch current rating should be 40 amperes (A) for the rangers which has 8.75 KW rating or…

Q: A lighting and appliance branch - circuit panelboard is generally one of which natural connections…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: What is the resistance of a copper bus-bar,as used in the power distribution panel of a high-rise…

A:

Q: At most cellular sites there is three legged tower. To maintain proper grounding, only one leg needs…

A: At most cellular sites there is three legged tower. To maintain proper grounding, only one leg needs…

Q: Question 4 Consider the following sequential circuit. Determine its state table and state diagram. A…

A: The solution is given below

Q: Draw a schematic diagram for closed circuit

A: In this question , we will draw a schematic diagram for closed circuit....

Q: Electric power supply based on the type of power transmission may be classified as under ground…

A: Electrical power system is normally comprising of power generation, transmission, distribution and…

Q: 2. Use nodal analysis to find the voltage between terminals a,b, current in the 12 ohm resistor and…

A:

Q: 35. Identify the criterion of grounding at 400kv substation. If the total safety is to be ensured…

A: identify the criterion of grounding at 400KV substation. if the total safety is to be ensured what…

Q: Draw the schematic diagram for the circuit shown below and identify the type of connection between…

A: The schematic circuit diagram for the given figure is as fallows

Q: 7. A 12-ohms resistor is connected in parallel with a series combination of 8 and 16-ohms. If the…

A: Given R1 =12 ΏR2 =8 ΏR3 =16 ΏReq =R1∥R2+R3 Voltage drop across 9 ohm resistance is 48 V

Q: Two fixed type resistors, 5 ohms and 7.5 ohms, are connected in series.   If a 12 volt battery is…

A:

Q: Service conductors supplying a building or other structure must not of another building or other…

A: From Article 230 of National Electric Code (NEC), the following information can be obtained:Service…

Q: On a short/long bond paper, draw a schematic circuit diagram following your house wiring with…

A: electrical wires are designed to bear consistent electric current which should not lead to a fire in…

Q: A building load consists of fifty 60 – watt, twenty 90 – watt and fifteen 55 – watt incandescent…

A:

Q: For the circuit shown below, what is the total current?

A: It is given that:

Q: a) Define 5 trees. b) Calculate Nullity and Rank.

A: A) the five trees are : e1, e2, e3, e5, e6

Q: 1. What is the difference between Miswire and short in the cabling?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: The following is an explanation of why plenummed cabling is required in the region above the ceiling…

A:

Q: Since the voltages across each branch circuit in a residence are the same, these circuits are A.…

A: To select proper answer

Q: what are the complex powers of the elements in the circuit

A: The given circuit is  Zeq=j2+21+j2+1-j Zeq=0.8+j 1.6 Ω

Q: Which of the following configurations can be used to apply Ampere's circuital law ?*

A: For ampere circutal law,  gaussian or dotted line should be symmetry or uniform about the current…

Q: 2- How to make the duty cycle approach to 50%? 3. Dacian

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: what is the practical utility of this circuit

A: Given circuit:

Q: what is the computed load for a cooktop unit with a nameplate rating of  6kW

A: Table 220.19 shown below applies to household cooking appliances (rated over 1,750W). Given name…

Q: Determine the power across 10 volts supply after solving the circuit by nodal analysis.

A:

Q: a. With the aid of a diagram, describe how socket outlets are wired in a ring main circuit. a radial…

A: RING CIRCUIT:                                               The Line, neutral, and earth wire…

Q: 6. What size of copper wire cable (THW insulation) is needed for the following mo- tor if located 30…

A: Cable Generally  Electrical cable is used for transmission and distribution of electrical energy,…

Q: 15 O Y 14 88888888 N>X-

A: The solution can be achieved as follows.